GoYeel ZF003WH - User Manual

The ceiling

The ceiling

The ceiling

①

②

③

④

⑤

Tips: Before installation, the lamp should be tested for
electricity. The lampcan be installed to the ceiling
only in normal operation

All off

Pair code

Fan rotates

forward/reverse

Light on/off

Fan off

Color tem-

perature

Night light

Timing for

1/2 hour

Fan speeds

SETUP

Color tempe-

rature control

Light bright-

ness control

Turn on the power switch and press the ' SETUP ' button
within 2 seconds after hearing the 'drip'.The receiver beeps
out two clicks, successfully matching the code.

Step1 : Disassemble the hanging plate of the lamp,then the hole position of the

hanging plate is measured and located on the ceiling by borrowing the

hole position of the hanging plate.

Step2 : Punch holes in the positioning mark according to the size of the expansion

screw, then hammer the expansion screw into the hole with a hammer

(leaving one centimeter outside) and then counterclockwise unscrew the

nut and meson to lock the hanging plate.

(If your ceiling is not concrete but a wooden suspended ceiling,use

self-tapping screws directly to secure the cross-hanging panels).

Step3 : Install the hanging plate on the ceiling with the washers respectively. Ensure

that the mounting plate is connected with the ceiling firmly, and ensure that

the hanging plate and the expansion screw are sufficient to bear the weight

of the lamp body.

Step4 : The main line of the lamp body shuld be checked if the lamp works

normallyor not by connect 110-220V power supply. It is recommended that

professional electrician install the lamp.

Step5 : Install the lamp hub on the hanging plate according to the hole position.

please ensure that the lamp body and ceiling are securely connected.

1 : Please read the assembly drawing carefully before installing and maintaining the
lamps and lanterns, and keep it properly for future use after use.
2 : The power supply used should not exceed the specified range of voltage (rated
voltage AC110-220V) for a long time ,or may cause damage to the lamp
overheating.
3 : Please pay attention to check whether the cable and switch are in good
condition before use, and ensure that the local voltage is consistent with the
lamp voltage.
4 : Please turn off the power before installing the lamp.
5 : Do not install the lamp above the high temperature object, such as stove, gas,

exhaust,cylinder, etc., which may damage the lamp.
6 : Please do not refit the lamps ,which may case of malfunction.
7 : Please clean and check regularly. Turn off the power before cleaning. Wipe

the surface with a dry rubbing cloth. Do not wipe with acidic or alkaline

chemical solvents, which will cause serious damage to the surface.