GMC ATBR1650-3PK - Manual

7 Risk of loss of hearing What could happen How to prevent it • Long term exposure to noise produced from the operation of air tools can lead to permanent hearing loss. • Always wear hearing protection. Risk to injury What could happen How to prevent it • Tools left unattended with the air hose atta...

9 Risk to injury (cont.) • Fasteners could ricochet or be propelled causing serious injury or property damage. • Never point discharge of tool at self or others. • Do not pull trigger unless tool contact safety device is against work surface. • Never attempt to drive fasteners into hard surfaces suc...

10 Risk of entanglement What could happen How to prevent it • Tools which contain moving elements, or drive other moving tools, can become entangled in hair, clothing, jewellery and other loose objects, resulting in severe injury. • Never wear loose fitting clothes, or apparel which contains loose s...

11 Know your product 1. Exhaust deflector2. Trigger3. Air inlet4. Latch5. Nail magazine6. Safety strike element (Non marking tip) 7. Fastener discharge area8. Drive safety cover9. Quick release latch10. Depth adjustment thumb wheel 1 2 5 3 7 8 10 9 6 4

12 Preparing the tool Tool lubrication This finish nailer requires lubrication BEFORE initial use and BEFORE and AFTER each additional use throughout its life.1. Disconnect the air hose, turn the finish nailer so the air inlet (3) is facing up. Place 3-4 drops of non detergent oil into the air inlet...

13 Operation Operating the tool:Firing mechanism: This tool operates on a single sequential firing system. Where to use finishing nailer. Finishing nailer/staplers are used mainly in medium to light duty applications. The use of T-Brad finishing nails enable the nail heads to be countersunk under th...

14 Adjusting the exhaust direction: 1. The finish nailer is equipped with an adjustable direction exhaust deflector (1). Simply adjust the directional exhaust deflector so that the exhaust air blast will be directed away from the operator. Grasp the deflector and rotate it to the desired position fo...

15 Troubleshooting Trouble Possible cause Suggested remedy Fires two nails at time. The head of the nail is too small(Head size should be 2.8mm - 3.3mm). Check nail size. 18 gauge nails have been fitted. Purchase correct size nails from your local Air Tool supplier. Nailer skips when driving brad na...

1 MAGNESIUM BRAD NAILER/STAPLER GUN ATBS120-3PKINSTRUCTION MANUAL Black Cyan Magenta Yellow Code: ATBS120-3PK Date: 070420 Edition: 03 Op: DCR

13 Operation Operating the tool:Firing mechanism: This tool operates on a single sequential firing system. Where to use brad nailer/stapler Brad nailer/staplers are used mainly in medium to light duty applications. The use of brad nails and staples enables the nail heads to be countersunk under the ...

4 General safety instructions To use these tools properly, you must observe the safety regulations, the assembly instructions and the operating instructions to be found in this Manual. All persons who use and service the machine have to be acquainted with this Manual and must be informed about its p...

13 Preparing the tool Selecting compressor Select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing frequency, applicable pressure and compressor air output.Thus, for example, if nailing takes place at a rate of appro...

14 Operating the tool Firing mechanism This tool operates on a single (full sequential actuation) firing system. Single (full sequential actuation) firing To fire, grip tool firmly to maintain control, position the contact safety nose (1) of tool onto work surface, and squeeze trigger (4) to fire a ...

15 2. Connect the Framing Gun to an air supply and fire a nail into a sample piece of wood to determine the driving depth has been achieved. 3. If the nail depth is not acceptable, disconnect the tool from the air supply and re-adjust. Connecting the air hose 1. Slip the air coupling of the air hose...