Generac 5254 - Manual

Table of Contents:

• Page 2 – INTRODUCTION; is intended exclusively for outdoor; READ THIS MANUAL THOROUGHLY; DANGER; After this heading, read explanatory statements; CONTENTS; Engine; OPERATION AND MAINTENANCE; AUTHORIZED
• Page 3 – Table of Contents; Air-cooled Generators; Section 2 – Post Installation Start-up
• Page 4 – Owner’s Manual; Despite the safe design of this generator,; GENERAL HAZARDS
• Page 5 – Installation must always; EXPLOSION HAZARDS; STANDARDS INDEX; IMPORTANT SAFETY INSTRUCTIONS
• Page 6 – outdoor installation only.; SYSTEMS; Section 1 — General Information
• Page 9 – CONSUMPTION; Gaseous fuels such as natural gas and liquid
• Page 10 – Figure 1.4 – Demand Regulator
• Page 12 – Figure 1.9 – Generator Clearances; The engine exhaust fumes contain carbon mon-; sure is intended for indoor use only; If the AUTO/OFF/MANUAL switch is not set to its; BATTERY REQUIREMENTS
• Page 13 – Figure 1.10 – Battery Cable Connections
• Page 14 – INITIAL; Never operate the engine with the oil level; Do not attempt manual transfer switch opera-; CHECKS; The transfer switch is now electrically “hot.”; Proceed with caution! Generator power voltage
• Page 15 – Section 2 — Post Installation Start-up and Adjustments; TESTS UNDER LOAD
• Page 16 – Figure 2.1 — 7kW Fuel Regulator; Do not make any unnecessary adjustments.; A service fee may be charged for this adjustment.; ENGINE GOVERNOR ADJUSTMENT; The engine must be OFF to perform steps 1 and; Figure 2.2 — Engine Governor Adjustment; Unit
• Page 17 – UNITS; Figure 2.3 – Voltage Adjustment Potentiometer; Figure 3.1 – Generator Control Panel; POSITION; With the switch set to AUTO, the engine may
• Page 18 – OPERATION; TRANSFER; Do not attempt to activate the transfer switch
• Page 19 – Section 3 — Operation; Figure 3.2 – Manual Transfer Switch Operation; SETTING THE EXERCISE TIMER
• Page 20 – Figure 3.3 – Low Oil Pressure and; Oil Filter
• Page 21 – BATTERY; Figure 4.1 – Generator Control Panel; Remove the dipstick and wipe it dry with a clean; the; Oil Dipstick and Fill; Section 4 — Maintenance
• Page 22 – CHANGING THE ENGINE OIL; Any attempt to crank or start the engine before; Figure 4.5 – Oil Drain Hose and Filter
• Page 23 – box and around edges.; Figure 4.6 — 7 kW, Engine Air Cleaner Location; GENERATORS; Figure 4.7 — 10kW Engine Air Cleaner; Air Filter; Air Cleaner; Clean the area around the base of the spark
• Page 24 – Figure 4.9 – Setting the Spark Plug Gap; MAINTENANCE; To check valve clearance:
• Page 25 – SYSTEM; Figure 4.11 – Cooling Vent Locations; The exhaust from this product gets extremely; ATTENTION AFTER SUBMERSION; must
• Page 27 – SERVICE SCHEDULE; ATTENTION: It is recommended that all service work
• Page 28 – TROUBLESHOOTING GUIDE; Problem Cause; *Contact the nearest Authorized Dealer for assistance.; Section 5 — Troubleshooting
• Page 29 – Section 6 — Notes
• Page 32 – Section 7 — Mounting Dimensions
• Page 33 – Section 8 — Electrical Data
• Page 44 – Material
• Page 45 – Section 9 — Exploded Views and Parts Lists
• Page 63 – ITEM PART
• Page 70 – CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT; YOUR WARRANTY RIGHTS AND OBLIGATIONS; ATTENTION WARRANTY DEPARTMENT
• Page 71 – EMISSION CONTROL SYSTEM WARRANTY; EMISSION RELATED PARTS INCLUDE THE FOLLOWING:; Section 10 – Warranty
• Page 72 – GENERAC POWER SYSTEMS STANDARD LIMITED WARRANTY FOR; WARRANTY SCHEDULE; THIS WARRANTY SHALL NOT APPLY TO THE FOLLOWING: