Generac 004945-1 - Manual

Generac 004945-1

Generac 004945-1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
Page: / 20

Table of Contents:

  • Page 2 – DANGER; After this heading, read explanatory statements; GENERAL HAZARDS; • Any AC generator that is used for backup power if; IMPORTANT SAFETY INSTRUCTIONS
  • Page 3 – Table of Contents; Introduction to Installation; For authorized service,
  • Page 4 – Section 1 — General Information; ATS “HS” Type Transfer Switch; EQUIPMENT DESCRIPTION; AWG; Figure 1.1 — Typical ATS Transfer Mechanism; BREAKER; rated; TRANSFER SWITCH DATA DECAL
  • Page 5 – TRANSFER SWITCHES; INTRODUCTION TO INSTALLATION; Handle transfer switches carefully when install-; CONNECTING POWER SOURCE; Make sure to turn OFF both the UTILITY; GTS “HS” Type Transfer Switch
  • Page 6 – Section 3 — Operation; Use a torque wrench to tighten the conduc-; cables to transfer switch terminals E1, E2.; MAXIMUM WIRE LENGTH; Perform functional tests in the exact order pre-; MANUAL OPERATION; Do NOT manually transfer under load.; Turn the GENERATOR DISCONNECT SWITCH
  • Page 7 – Move handle UP for the; Return handle to; Figure 3.1 — Actuating Transfer Switch
  • Page 8 – CHECKS; PROCEED WITH CAUTION. THE TRANSFER; PROCEED WITH CAUTION. GENERATOR; Hertz; GENERATOR TESTS UNDER LOAD
  • Page 9 – Section 4 — Installation Diagram
  • Page 10 – Section 5 — Electrical Data
  • Page 14 – Section 6 — Exploded Views and Parts List
  • Page 16 – TL; TL
  • Page 17 – ITEM PART
  • Page 18 – Section 7 — Notes
  • Page 20 – Section 8 — Warranty; THIS WARRANTY IS IN PLACE OF ALL OTHER WARRANTIES, EXPRESSED OR
Loading the manual

Automatic Transfer Switch

Owner’s Manual

ATS Service Entrance

HS Type Transfer Switch

Models: 005036-0, 100 Amp, 250 Volts

and 004945-1, 200 Amp, 250 Volts

This manual should remain with the unit.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - DANGER; After this heading, read explanatory statements; GENERAL HAZARDS; • Any AC generator that is used for backup power if; IMPORTANT SAFETY INSTRUCTIONS

Generac Power Systems, Inc., hereafter referred to as the “manufacturer”, cannot anticipate every possible circumstance that might involve a hazard. The warn-ings in this manual, and on tags and decals affixed to the unit are, therefore, not all-inclusive. If using a procedure, work method or operat...

Page 3 - Table of Contents; Introduction to Installation; For authorized service,

Table of Contents 1 Safety Rules .........................................Inside Front CoverSection 1 — General Information ...................................2 1.1 Introduction............................................................. 21.2 Equipment Description .....................................

Page 4 - Section 1 — General Information; ATS “HS” Type Transfer Switch; EQUIPMENT DESCRIPTION; AWG; Figure 1.1 — Typical ATS Transfer Mechanism; BREAKER; rated; TRANSFER SWITCH DATA DECAL

2 Section 1 — General Information ATS “HS” Type Transfer Switch 1.1 INTRODUCTION This manual has been prepared especially for the purpose of familiarizing personnel with the design, application, installation, operation and servicing of the applicable equipment. Read the manual carefully and comply w...

Other Generac Models

All Generac Other