GE SBSD227 - Manual

GE SBSD227

GE SBSD227 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 2 – Installation Instructions; PREPARE THE PEDESTAL
  • Page 3 – LEVEL THE WASHER OR DRYER
  • Page 4 – CONTENU DE LA TROUSSE; AVANT DE COMMENCER; Note au consommateur –; Délai d’exécution –; MISE EN GARDE; — à cause de; PRÉPARATION DE L’INSTALLATION
  • Page 5 – Instructions d’installation; PRÉPAREZ LE SOCLE; POUR LES SÉCHEUSES SEULEMENT :
  • Page 7 – RÉINSTALLEZ LE TIROIR; RETIREZ LES VIS D’EXPÉDITION
  • Page 8 – CONTENIDO DEL KIT; ANTES DE COMENZAR; Nota para el consumidor –; Tiempo de instalación –; PRECAUCIÓN; — debido al; HERRAMIENTAS NECESARIAS
  • Page 9 – Instrucciones para la instalación; PREPARE EL PEDESTAL
  • Page 11 – VUELVA A INSTALAR EL CAJÓN; FINALICE LA INSTALACIÓN; ESPECIFICACIONES SUJETAS A CAMBIO SIN PREVIO AVISO
Loading the manual

Installation
Instructions

KIT CONTENTS

4 Support Pads

4 Mounting Screws

Drawer Divider

1

SBSD137, SBSD227

TOOLS YOU WILL NEED

Phillips Head
Screwdriver

9/16

Open End Wrench

or Adjustable Wrench

8 mm Socket Wrench

REMOVE THE LEVELING LEGS

Carefully lay the washer or dryer on its
side to access the leveling legs on the
bottom of the appliance.

IMPORTANT: Do not lay the washer or dryer
on its back! Do not remove the shipping
bolts on the back side of the washer. The
bolts must remain in place until the washer
is returned to an upright position.

Use an open-end wrench to remove the
washer or dryer leveling legs.

B

A

1

INSTALLATION PREPARATION

Remove the packaging.
The Drawer divider is taped at the top of the
shipping carton. Remove the divider and set
aside for final installation.
Flatten the product carton to use as a pad
to lay the washer or dryer down on its side.
Continue using the carton to protect the finished
floor in front of the installation location.

Back out and remove
all 4 leveling legs

Instructions en français : . . . . . . . . . . . .4
Instrucciones en español: . . . . . . . . . . .8

For Washer Models: GBVH5140, GBVH6260, GCVH6260, GCVH6600, GHDVH626,
GHDVH670, WBVH5100, WBVH6240, WCVH6260, WCVH6600, WHDVH626
and WHDVH660
For Dryer Models: DBVH510, DBVH512, DCVH515, DCVH660, DHDVH52,
DHDVH66, PBVH415, PCVH565, PDVH515, PHDVH52 and PHDVH57

BEFORE YOU BEGIN

Read these instructions completely
and carefully.

IMPORTANT

Save these

instructions for local inspector’s use.

IMPORTANT

Observe all

governing codes and ordinances.

Note to Consumer –

Keep these

instructions with your Owner’s Manual
for future reference.

Completion time –

1 to 2 hours

Proper installation is the responsibility
of the installer.

Product failure due to improper installation
is not covered under the Warranty.

CAUTION

— Due to the size and

weight of these products, and to reduce the
risk of personal injury or damage to the
product, TWO PEOPLE ARE REQUIRED FOR
PROPER INSTALLATION.

See washer and dryer installation
instructions for additional installation
requirements and guidelines.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand
GE
Model
SBSD227
Document type
Manual
Language(s)
English, Spanish, French
Pages
12
Format
PDF

Summary

Page 2 - Installation Instructions; PREPARE THE PEDESTAL

2 Installation Instructions INSTALL THE PEDESTALTO THE WASHER OR DRYER Place the pedestal against the bottom of the unit. Check to be sure the drawerfront is at the front of the unit. Align the holes in the pedestal with the holes in the bottom of the unit. Use a Phillips screwdriver to install the ...

Page 3 - LEVEL THE WASHER OR DRYER

3 Installation Instructions LEVEL THE WASHER OR DRYER Locate the 4 legs from the parts packageand install. Stand the washer or dryer upright. Moveit close to its final location. Make sure that the washer or dryer is level by placing a spirit level on top.Check side to side and front to back. Use an ...

Page 4 - CONTENU DE LA TROUSSE; AVANT DE COMMENCER; Note au consommateur –; Délai d’exécution –; MISE EN GARDE; — à cause de; PRÉPARATION DE L’INSTALLATION

Instructionsd’installation CONTENU DE LA TROUSSE 4 coussinets de support 4 vis de montage Séparateur de tiroir 4 AVANT DE COMMENCER Lisez attentivement et en entier toutes cesinstructions. • IMPORTANT — Conservez ces instructions à utiliser par l’inspecteur local. • IMPORTANT — Observez tous les cod...

Ask a question

Up to 3 photos. Max 5 MB each. Formats: JPG, JPEG, PNG, WebP.