GE PDW7000 - Manual

GE PDW7000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – Installation Preparation; For New Installations Only:; Elbow; Carpenters Square; Crescent Wrench; Flashlight; Nutdriver; Screw Driver II; Tubing Cutter; Waste Tee; Screw Kit; Drain Hose
Page 3 – PREPARE DISHWASHER ENCLOSURE; WARNING; DRAIN REQUIREMENTS; CABINET PREPARATION
Page 4 – PREPARE ELECTRICAL WIRING
Page 5 – Correct
Page 6 – Installation Instructions; STEP 4–REMOVE TOEKICK; STEP 7– INSTALL DRAIN HOSE TO; STEP 6– INSTALL
Page 8 – STEP 13– PUSH DISHWASHER INTO; IMPORTANT
Page 9 – STEP 15–POSITION DISHWASHER, SECURE TO COUNTERTOP OR CABINET; STEP 16–CONNECT WATER SUPPLY
Page 10 – STEP 17–CONNECT DRAIN LINE; DRAIN LINE INSTALLATION; Cutting Line; IMPORTANT: Do not cut corrugated portion of hose
Page 11 – STEP 18–CONNECT POWER SUPPLY; STEP 19–PRETEST CHECK LIST
Page 12 – STEP 20–DISHWASHER WET TEST; STEP 21–REPLACE TOEKICK

Loading the manual

GE Consumer & Industrial

Appliances

Installation Instructions

Built-In Dishwasher

If you have questions, call 800.GE.CARES (800.432.2737) or visit our website at: www.ge.com

IMPORTANT

– The dishwasher MUST be installed

to allow for future removal from the enclosure if service is
required.

If you received a damaged dishwasher, you should
immediately contact your dealer or builder.

Optional Accessories – See the Owner’s Manual for available
custom panel kits.

FOR YOUR SAFETY

Read and observe all CAUTIONS and WARNINGS shown

throughout these instructions. While performing

installations described in this booklet , gloves, safety glasses

or goggles should be worn.

READ CAREFULLY.

KEEP THESE INSTRUCTIONS.

IMPORTANT

– Observe all governing codes and

ordinances.
•

Note to Installer

– Be sure to leave these instructions for the

consumer’s and local inspector’s use.

•

Note to Consumer

– Keep these instructions with your

Owner’s Manual for future reference.

•

Skill Level

– Installation of this dishwasher requires

basic mechanical, electrical and plumbing skills.

Proper

installation is the responsibility of the installer. Product

failure due to improper installation is not covered under

the GE Appliance Warranty. See warranty information.

•

Completion Time – 1 to 3 Hours

. New installations require

more time than replacement installations.

BEFORE YOU BEGIN

Read these instructions completely and
carefully.

��

STOP

GSD6000 Series

PDW7000 Series

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand: GE
Model: PDW7000
Document type: Manual
Language(s): English
Pages: 12
Format: PDF

Summary

Page 2 - Installation Preparation; For New Installations Only:; Elbow; Carpenters Square; Crescent Wrench; Flashlight; Nutdriver; Screw Driver II; Tubing Cutter; Waste Tee; Screw Kit; Drain Hose

PARTS SUPPLIED IN INSTALLATION PACKAGE: ■ Two #8-18 x 5/8" Phillips special head screws, to Two #8-18 x 5/8" Phillips special head screws, to secure dishwasher to underside of countertop or sides of cabinets. ■ Junction box cover and #10 hex head screw Junction box cover and #10 hex head scr...

Page 3 - PREPARE DISHWASHER ENCLOSURE; WARNING; DRAIN REQUIREMENTS; CABINET PREPARATION

Installation Preparation PREPARE DISHWASHER ENCLOSURE • The rough cabinet opening must be at least 24" deep, 24" wide and approximately 34-1/2" high from ﬂ oor to underside of the countertop. • The dishwasher must be installed so that drain hose is no more than 10’ in length for proper d...

Page 4 - PREPARE ELECTRICAL WIRING

Installation Preparation PREPARE ELECTRICAL WIRING #282 French FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter plug with this appliance. #282 French The improper connection of the equipment grounding conductor can ...