GE JB860SJ6SS - Installation Manual
GE JB860SJ6SS – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ELECTRICAL REQUIREMENTS; WARNING; POWER CORD AND CONDUIT INSTALLATION
- Page 3 – -WIRE INSTALLATION
- Page 4 – ANTI-TIP DEVICE INSTALLATION; LEVEL THE RANGE; MODELS WITH STORAGE DRAWER; FINAL INSTALLATION CHECKLIST; MODELS WITH WARMING DRAWERS OR DOUBLE OVEN
- Page 5 – ANTES DE COMENZAR; Instrucciones de instalación; QUITE LOS MATERIALES DE ENVÍO:; ADVERTENCIA
- Page 6 – REQUERIMIENTOS ELÉCTRICOS; INSTALACIÓN DE CABLE DE ENERGÍA Y DE PASACABLES
- Page 7 – INSTALACIÓN DE 4 HILOS
- Page 8 – INSTALACIÓN DE DISPOSITIVO ANTI-VOLCADURAS; NIVELE LA COCINA; MODELOS CON CAJONES DE ALMACENAMIENTO; LISTA DE CONTROL FINAL DE LA INSTALACIÓN; MODELOS CON CAJONES O CALENTADORES HORNO DOBLE
2
PREPARE THE OPENING (FOR INDOOR USE ONLY)
See illustrations for all rough-in and spacing dimensions. The range may be placed with 0”
clearance (flush) at the back wall and side walls of the cabinet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
—
Save these
instructions for local inspector’s use.
•
IMPORTANT
—
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
•
Skill level –
Installation of this appliance
requires basic mechanical skills and
advanced electrical skills.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation
is not covered under Warranty.
Installation Instructions
Free-Standing Electric Ranges
MATERIALS YOU MAY NEED
TOOLS YOU WILL NEED
(UL Listed 40 AMP)
4-Wire Cord 4’ long OR
3-Wire Cord 4’ long
Squeeze Connector
(For Conduit
Installations Only)
Drill with 1/8” Bit
Safety Glasses
Adjustable Wrench
Level
Tin Snips
Tape Measure
Pliers
1/4” Nut Driver
1
REMOVE PACKAGING MATERIALS:
Failure to remove packaging
materials could result in damage to the appliance. Remove all packing parts from oven,
racks, heating elements and drawer. Also, remove protective film and labels on the outer
door, cooktop and control panel.
FOR YOUR SAFETY:
WARNING
Before beginning
the installation, switch power off at
service panel and lock the service
disconnecting means to prevent power
from being switched on accidentally.
When the service disconnecting
means cannot be locked, securely
fasten a prominent warning device,
such as a tag, to the service panel.
If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at no
cost. (In Canada, call 1.800.561.3344.) For installation
instructions of the bracket,
visit: www.GEAppliances.com.
(In Canada, www.GEAppliances.ca.)
Anti-Tip Bracket
Kit Included
NOTE:
Use a 4’ power cord to prevent interference with
the storage drawer. Power cords 4
1
»
2
’ to 6’ long may
have to be dressed to allow for proper drawer closing.
MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:
A. Make sure the wall covering, countertop, flooring and
cabinets around the range can withstand the heat (up
to 200°F) generated by the range.
B. Allow 30” minimum clearance between surface units
and bottom of unprotected wood or metal cabinet, or
allow a 24” minimum when bottom of wood or metal
cabinet is protected by no less than 1/4” thick flame
retardant millboard covered with not less than No 28
MSG sheet metal, (.015”), .015” thick stainless steel,
.024” aluminum or .020” copper.
C. This appliance has been approved for 0” spacing to
adjacent surfaces above the cooktop. However, a 6”
minimum spacing to surfaces less than 15” above the cooktop and adjacent
cabinet is recommended to reduce exposure to steam, grease splatter and heat.
To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage space
above the cooktop should be avoided. If cabinet storage space is to be provided above
the cooktop, the risk can be reduced by installing a range hood that projects at least 5” beyond
the front of the cabinets. Cabinets installed above the cooktop must be no deeper than 16”.
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
Tip-Over Hazard
WARNING
2
1
»
2
”
2
1
»
2
”
7
1
»
2
”
25”
47”
25
3
»
8
”
7”
14
1
»
2
”
On models with baking
or warming drawers,
electrical outlet must
not be in this area.
3
1
»
4
”
3
1
»
4
”
7
3
»
4
”
23
1
»
2
”
47”
29
7
»
8
”
25
3
»
8
”
45”
36”
SINGLE OVEN
DOUBLE OVEN
Acceptable electrical outlet area.
Orient electrical receptacle so the
length is parallel to floor.
30”
47
5
»
8
”
30”
29
7
»
8
”
*
*
3”
4”
A
NOTE C
B
A
C
Both
Sides
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for GE JB860SJ6SS
Summary
Rating plate SINGLE OVEN Rating plate DOUBLE OVEN ELECTRICAL REQUIREMENTS WARNING This appliance must be properly grounded. WARNING All new constructions, mobile homes, recreational vehicles and installations where local codes do not allow grounding through neutral, require a 4-conductor UL-listed r...
6 4-WIRE INSTALLATION WARNING The neutral wire of the supply circuit must be connected to the neutral terminal located in the lower center of the terminal block. The power leads must be connected to the lower left and the lower right terminals of the terminal block. The grounding lead must be connec...
7 ANTI-TIP DEVICE INSTALLATION To reduce the risk of tipping the range, the range must be secured by a properly installed anti-tip bracket. See installation instructions shipped with the bracket for complete details before attempting to install. To check if the bracket is installed and engaged prope...
