GE GTDX400EDWS- User Manual

Listed by

Underwriters

Laboratories

For answers to your Monogram,

®

GE Profile

™

or

GE

®

appliance questions, visit our website at

geappliances.com or call GE Answer Center

®

service, 800.626.2000.

370239

GTDX400ED

GE

®

6.0 cu. ft. capacity DuraDrum

™

electric dryer

36

25-1/2

42

54-1/2

Side View

27

Rear View

36

42

27

2

5-1/2

2-1/2

25-1/2*

Side View

Rear View

4-3/4

25-3/4

23-1/2

11-3/4

RCA Washer/Dryers LC4 QSart

*24-1/2" from the edge of the side panel to the front.�
25-1/2" from the front edge of endcaps.

5.7 cu. ft. Dryers

2

Back View

Power

Cord Hole

30-1/2

5.8, 6.0 and 7.0 cu. ft. Dryers

5

Back View

Power

Cord Hole

4-1/2

Power Cord Locations

Electric Dryer Rating:

240V

5600W

24A

60Hz

208V

4400W

22A

60Hz

Exhaust Option: 4-way rear, right, left and bottom
Circuit Requirements: An individual, properly-grounded branch circuit, protected by

a 30-amp circuit breaker or a time-delay fuse, is required.
Note: Dryer wall outlet must be located within 36" of service cord entry and

acessible when dryer is mounted in position.
Installation Information: For complete information, see installation instructions

packed with your dryer.

Dimensions and Installation Information (in inches)

Specification Revised 3/14

Special Installation Requirements
Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label

on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:

0" either side; 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.

• Closet doors must be louvered or otherwise ventilated and must contain a minimum

of 60 sq. in. of open area equally distributed. If this closet contains both a washer and

a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of local codes,

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

Minimum Clearances other than Alcove or Closet Installation:

• Minimum clearances to combustible surfaces are: 0" both sides; 3" rear
Dryer Exhausting Information : Use metal duct only, vertical and horizontal ducting.