Friedrich CP24N30 - Manual - manualsarea.com

Page 2 - Table of Contents

2 Table of Contents Performance Data ........................................................................................................................................................................ 3 Outer Component Identifi cation ...............................................................

Page 3 - Specifi cations and Technical Parameters

3 Model CP14N10 CP18N30 CP24N30 Function COOLING COOLING COOLING Rated Voltage 115V ~ 230/208V~ 230/208V~ Rated Frequency 60Hz 60Hz 60Hz Total Capacity (Btu/h) 14000 18000/17600 23500/23100 Power Input (W) 1430 1850/1810 2740/2710 Rated Input (W) 1540 2478 3538 Rated Current (A) 15 12.57 18.09 Air F...

Page 4 - Outer Component Identifi cation

4 Outer Component Identifi cation Models: CP14N10, CP18N30, CP24N30 Cabinet Air inlet louver Front grille Power cord Control panel cover Front intake grille Air filter(behind front intake grille)

Page 5 - Installation Dimensions

5 Installation Dimensions Models: CP14N10, CP18N30, CP24N30 (Top View) Fence / obstruction Over 2' Over 1' Over 1' Wall Or window (Front View) (Side View) Ceiling Over 1' Over 1' 25.98" 16.85" Less than 8.66" Over 2'

Page 6 - Wiring Diagrams

Page 7 - Functional Component Defi nitions

7 Functional Component Defi nitions MECHANICAL COMPONENTS Vent door Allows introduction of fresh air into the room and/or exhausts stale room air outside (on select models.) Plenum assembly Diffuser with directional louvers used to direct the conditioned airfl ow. Blower wheel Attaches to the indoor...

Page 8 - Refrigeration System Sequence of Operation

8 In the case of the capillary tube this is accomplished (by design) through size (and length) of device, and the pressure difference present across the device. Since the evaporator coil is under a lower pressure (due to the suction created by the compressor) than the liquid line, the liquid refrige...

Page 9 - Sealed Refrigeration System Repairs

9 EQUIPMENT REQUIRED 1. Voltmeter 2. Ammeter 3. Ohmmeter 4. E.P.A. Approved Refrigerant Recovery System. 5. Vacuum Pump (capable of 200 microns or less vacuum.) 6. Acetylene Welder 7. Electronic Halogen Leak Detector (G.E. Type H- 6 or equivalent.) 8. Accurate refrigerant charge measuring device suc...

Page 10 - Refrigerant Charging

10 NOTE: In order to access the sealed system it will be necessary to install Schrader type fi ttings to the process tubes on the discharge and suction of the compressor. Proper refrigerant recovery procedures need to be adhered to as outlined in EPA Regulations. THIS SHOULD ONLY BE ATTEMPTED BY QUA...

Page 13 - Cooling Only Room Air Conditioners: Troubleshooting Tips

13 Problem Possible Cause Action Compressor does not run Low voltage Check voltage at compressor. 115V & 230V units will operate at 10% voltage variance T-stat not set cold enough or inoperative Set t-stat to coldest position. Test t-stat & replace if inoperative Compressor hums but cuts off...

Page 17 - Heat / Cool Room Air Conditioners: Troubleshooting Tips

17 Problem Possible Cause Action Room temperature uneven (Heating cycle) Heat anticipator (resistor) shorted (on applicable models) Disconnect power to unit. Remove resistor from t-stat bulb block. Plus in unit & allow to operate. Feel resistor for heat. If not heat, replace resistor Wide differ...

Page 19 - Components

Friedrich CP24N30 - Manual

Table of Contents:

Summary

Other Friedrich Models