Franklin S - J Series - Manual
Franklin S - J Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FOR SOLVENT WELD CONNECTIONS; CAUTION; FOR THREADED CONNECTIONS
- Page 3 – TROUBLESHOOTING; ttings open too wide.
- Page 4 – Description
- Page 5 – MAY VARY FROM STATE TO STATE.
OWNER'S MANUAL
S - J Series Pump
Before Installation be sure to read all the
instructions and warnings carefully
. Refer to the
product data plates for additional operating instruction
and speci
fi
cations.
INSPECTION
Examine the equipment when received. Notify your
dealer or carrier of any damage or missing parts. Verify
that the equipment is of size and model speci
fi
ed.
Meet National Electrical Code, Canadian Electrical
Code, and local codes for all wiring.
Follow wiring instructions in this manual when
connecting motor to power lines.
INSTALLATION LOCATION
All S & J Series pumps are designed for
fl
ooded suction
(all suction
fi
ttings and suction piping are below water
level) and will not self-prime.
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see
this symbol on your pump or in this manual, look
for one of the following signal words and be alert to the
potential for personal injury:
D A N G E R
warns about hazards that
will
cause
serious personal injury, death or major property damage
if ignored.
W A R N I N G
warns about hazards that
can
cause
serious personal injury, death or major property damage
if ignored.
C A U T I O N
warns about hazards that
will
or
can
cause minor personal injury or major property damage if
ignored.
The label
NOTICE
indicates special instructions, which
are important but not related to hazards.
Carefully read and follow all
safety instructions in this
manual and on pump.
Keep safety labels in good
condition.
Replace missing or damaged
safety labels.
Wire motor for correct
voltage. See “Electrical”
section of this manual and
motor nameplate.
Ground motor before
connecting to power supply.
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
W A R N I N G
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 GENERAL PLUMBING FOR SOLVENT WELD CONNECTIONS Rigid or fl exible PVC pipe can be used. Pipe ends should be clean and free of any fl ash caused by the cutting operation. Be sure that the proper adhesive is used on the type of pipe speci fi ed. Recommended Adhesives- These are examples only and are ...
2 TROUBLESHOOTING MOTOR DOES NOT START 1. Disconnect switch or circuit breaker in OFF position.2. Fuses blown or thermal overload open.3. Locked motor shaft.4. Motor windings burned out.5. Defective starting switch inside single-phase motor.6. Disconnected or defective wiring.7. Low voltage. MOTOR D...
3 PARTS FOR MODEL J, JCM, S, and SKM 8 7a 7 3 6 5 4 2 1 Figure No. Part No. Description 1 9010-1197-R Motor 3/4HP 115/1/60 48Y Frame 9010-1247-R Motor 1HP 115/1/60 48Y Frame 9010-0710-R Motor 1-1/2HP 115/1/60 48Y Frame 2 02-1308-05-RKIT J Bracket Kit (incl. #7 3-10 butt & #8 1/4-14 x 1-1/8 faste...
