Fisher & Paykel DW820 - Manual

4 Door open (D) 595mm Width (B) 600mm Depth (C) 560mm Height (A) 825-875mm Electrical A 3 Pin 10 Amp switched outlet is required. The switch must be located in a readily accessible position with the product installed. Joinery dimensions (DW820 & DW920) Height A - 830mm MIN Width B - 600mm Depth ...

5 Diagram 1: Dishwasher Plumbing and drainage options Diagram 2: Dishwasher & waste disposal unit Diagram 3: Dishwasher using sink trap with dishwasher drain hose spigot Waste Water 200mm MIN Waste Standpipe Ø38mm750mm MIN above floor * * Hose supplied Switched power socket Waste Water Waste 200...

6 Introduction Fisher & Paykel strongly recommend that you read the information contained in this User Guide before using the dishwasher. After your Dishwasher has been installed, please check that: 1 The Dishwasher has been installed in accordance with installation instructions. 2 There are no ...

7 Quick operating instructions Load the dishes into the dishwasher Remove any large scraps of food from dishes. Ensure the dishwasher is not overcrowded when loading as this may lead to poor wash performance. Check spray arms can rotate Ensure there are no items blocking the spray arm path. Fill the...

8 Control panel Power Button This turns the Dishwasher on and off. On After pressing the POWER button:-920 Model Only - The Time Remaining Display will indicate the time remaining in minutes for the wash programme selected. 820 Model Only - The wash programme light will be lit up.The next time the D...

9 Wash button To select a wash programme, press the WASH button. The wash button will scroll between the normal - light - fast and rinse wash programmes. The light below the wash programme will indicate your selection. Eco button The Eco feature reduces the temperatures during the wash. It saves on ...

1 0 Time remaining display (920 Model Only) This indicates the approximate time remaining in the wash programme. The Time Remaining Display is based on 20°C or 60°C incoming supply, depending on whether the water connection is cold or hot. If your incoming water deviates from the above temperatures,...

1 1 Loading the dishwasher Scrape off large food scraps and remove bones, crusts, toothpicks and any similar items. Load the dishes, taking care not to overload the dishwasher. Check there are no items blocking the path of the spray arm. Check by giving the top and bottom spray arm a turn before you...

1 2 Cutlery basket A removable cutlery basket sits in the centre of the lower basket. Load cutlery handles down for the best wash performance. Take care when loading and unloading sharp knives or prongs. Mix spoons, knives and forks within each section of the basket. This prevents the spoons and for...

1 3 Detergent Detergent usage The detergent dispenser is located on the inside of the Dishwasher door. Check the Wash Programme Chart for the correct amount of detergent or consult the detergent manufacturer’s instructions. Filling the detergent dispenser To fill the detergent compartment: 1 Press t...

1 4 Rinse aid Rinse Aid helps give a streak-free, sparkling clean look to glass and chinaware. It speeds up drying and helps prevent metal from tarnishing. The Rinse Aid Dispenser is on the inside of the Dishwasher door. The dispenser holds 140ml, enough for about 70 regular washes. If the Rinse Aid...

1 5 Wash programmes Det e rgent quantities W a sh descriptions W a sh times (appr o x . minutes) Wa sh pr ogr a mme W h e n t o u se P re w a sh (g) Main wa sh ( g ) Pre wa sh 1 Pre wa sh 2 Main wa sh Po st rinse 1 Po st rinse 2 Dr ying C o ld co nnec t Hot co nnec t Standard progr ammes Nor m al He...

1 6 Changing the pre -set options End of programme beeps The beeps at the end of each wash programme can be removed by following the steps below. 1 Press the POWER button to turn the Dishwasher off. 2 Press the ECO button and while holding down, press the START/PAUSE button and hold together for app...

1 7 Australian/New Zealand standards AS2007.1 Loading patterns Fisher & Paykel Dishwashers are tested to Australian/New Zealand Dishwasher Standards for both wash and dry performance. The loading pattern for AS 2007.1 is shown below. Detergent quantities For testing to AS2007.1 we recommend the ...

1 8 Care guide The combination of high temperatures and Dishwasher detergent may cause damage to some items if they are washed in the Dishwasher. Remember, if you are in doubt about any aspect concerning items washed in the Dishwasher, follow the instructions from the manufacturer of the items, or w...

1 9 Care and cleaning Cleaning the strainer The filter plate is designed to be self cleaning but occasionally food scraps may collect. Sweep these into the strainer before emptying. The strainer should be regularly checked and removed for cleaning, if necessary. 1 Unclip the strainer from the filter...

2 0 Problem solving If the Dishwasher does not appear to be operating properly, check this chart before you call for service. Problem Possible cause What to do The dishwasher will not start. Door not closed properly. Close the door by pushing the handle forward until it ‘clicks’, Power supply notcon...

2 2 Fault codes You are reminded that if you call a Fisher & Paykel Authorised Service Centre because of a User Fault, it is not covered by the Warranty. Should you encounter any problems we recommend that you call our Customer Care Centre. 920 model only In the 920 Dishwasher, the Time Remainin...

2 3 Manufacturer ’s warranty When you purchase any new Fisher & Paykel whiteware Product you automatically receive a two year Manufacturer’s Warranty covering parts and labour for servicing. Fisher & Paykel undertakes to Repair or, at its option, replace without cost to the owner either for ...

2 4 Customer care Check the things you can do yourself. Refer to your User Guide and check: 1 your appliance is correctly installed 2 you are familiar with its normal operation If after checking these points you still need assistance please refer to the following: In New Zealand If you need assistan...

Copyright Reserved © Fisher & Paykel 2004. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your De...