Fisher & Paykel DD36STI - Manual
Fisher & Paykel DD36STI – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – width of the panel; height of the panel; Front Panel material; Adequately sealed to withstand moisture (122; PANEL PREPARATION; Use this diagr
- Page 3 – Badge zone
- Page 5 – SAFETY AND WARNINGS; Electrical shock hazard; Failure to use caution could result in injury or cuts.; Important safety instructions!; DishDrawer®; Front panel adjustment; US CA NZ AU GB IE; SAVE THESE INSTRUCTIONS
- Page 7 – Factory setting
- Page 8 – RECONNECT THE POWER SUPPLY
Important!
SAVE THESE INSTRUCTIONS
The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local
website listed at the end of this document or contact your local Fisher & Paykel dealer.
SAFETY AND WARNINGS
1
WARNING!
Electrical shock hazard
WARNING – To reduce the risk of electric shock, fire, or injury to persons, the
installer must ensure that the DishDrawer® is completely enclosed at the time of
installation.
Before fitting the front panel and connecting the integrated badge, make sure
that the DishDrawer® is completely enclosed by cabinetry, and disconnected from
the power supply.
The integrated badge must be electrically connected by a suitably qualified
installer.
Failure to follow these warnings may result in electrical shock, injury or fire.
WARNING!
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.
Important safety instructions!
Read these instructions completely and carefully.
Ensure the product is not plugged in.
Installation of DishDrawer® panels requires basic mechanical and electrical skills.
Installation must comply with your local building and electricity regulations.
Failure to install the Dishdrawer® panels correctly could invalidate any warranty or liability claims.
DishDrawer®
Front panel preparation
(Integrated models only)
DD36STI, DD90S(H)TI models
US CA NZ AU GB IE
(1,1) -1- 590018A DD36SDD90S DoorPanelPrep USCANZGB.indd 22/2/10 1:49:22 PM
(1,1) -1- 590018A DD36SDD90S DoorPanelPrep USCANZGB.indd 22/2/10 1:49:22 PM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The following calculations assume the top of the panel is aligned with the top of the adjacent cabinetry: width of the panel Measure A ( the width between adjacent door/drawer fronts) and write it in the fi rst box below, then complete the equation. height of the panel Measure B ( door/drawer height...
PARTS SUPPLIED ZONE REQUIRED FOR BADGE REMOVE PANEL BRACKET & DETACH BADGE 3 4 5 Panel mounting screws (14) Supplied separately Attached to product Integrated rectangular badge (1) (Satin chrome supplied) Panel bracket (1) Integrated door seal (1) 2 11⁄16 ” (69 mm) 18” (457 mm) 5” (127 mm) 10 1⁄...
If, after installation, the front panel of your DishDrawer is not correctly aligned with the front panels of surrounding cabinetry, it can be adjusted as follows. SAFETY AND WARNINGS 1 WARNING! Electrical shock hazard WARNING – To reduce the risk of electric shock, fire, or injury to persons, the in...
