Fisher & Paykel CDV3-365HN - User Manual

SAFETY AND WARNINGS ! WARNING! Fire Hazard Failure to follow this advice may result in overheating, burning, and injury. • Never leave the appliance unattended when in use. Boilover causes smoking and greasy spillovers that may ignite. ! WARNING! Cut Hazard Failure to use caution could result in inj...

SAFETY AND WARNINGS ! WARNING! Hot Surface Hazard Failure to follow this advice could result in burns and scalds. • To avoid burns and scalds, keep children away from the appliance. • Surfaces of the appliance may become hot enough to cause burns. • During and after use, do not touch or let clothing...

SAFETY AND WARNINGS READ AND SAVE THIS GUIDE WARNING! To reduce the risk of fire, electrical shock, injury to persons or damage when using the cooktop, follow the important safety instructions listed below. Read all the instructions before use. Installation z Ensure the appliance is properly install...

BEFORE YOU BEGIN z Read this guide, taking special note of the 'Safety and warnings' section. z Remove all packaging from the cooktop. Recycle responsibly. z Remove any adhesive residue using dishwashing liquid on a soft cloth. Do not use any harsh or abrasive cleaners. 2 1 Cooktop features 1 Contro...

CONTROL PANEL Dial halos* When a burner in use, a red halo will illuminate. If all dials are turned OFF , all halos will dim. Control panel CDV3-365 model illustrated Using the burner dials To use the burner and griddle dials, push in and turn counterclockwise to HI. Hold the dial at HI before turni...

BURNER USE WARNING! If the flame is extinguished during a power failure, turn the dial back to OFF as the burner will not automatically relight and gas may accumulate. Identify the desired burner and the corresponding dial. When the burner is lit, turn the dial to any setting between HI (high) and S...

BURNER USE Manual lighting If there has been a power outage, the burners can be manually lit. If you have attempted to light the burner with the ignition, allow 1 minute for any accumulated gas to dissipate before manually lighting. 1 Carefully hold a battery operated lighter near the desired burner...

CARE AND CLEANING ALWAYS NEVER • Read these instructions and the ‘Safety and warnings’ section before you start cleaning your cooktop. • Before cleaning or removing any part, make sure that everything on the range has been turned off. • Unless suggested otherwise in the chart following, allow any pa...

Ensure that all burner parts are correctly fitted. Incorrectly assembled burners may produce dangerous flames. Flames should be blue with no yellow tipping, and burn without fluttering around the burner cap. CARE AND CLEANING Replacing burner parts Burner cap Flame spreader Ignitor Correct alignment...

TROUBLESHOOTING PROBLEM POSSIBLE CAUSES WHAT TO DO The ignitor keeps clicking (continuous spark) even when a burner has lit. Dirty or wet ignitor(s) Clean the ignitor(s). See ‘Care and cleaning’ for guidance. None of the burners will light. No power supply The cooktop burners can still be used. To l...

WARRANTY AND SERVICE Before you call for service or assistance Refer to the installation guide and user guide and check that your product is correctly installed and you are familiar with its normal operation. If after checking these points you still need assistance or parts, please refer to the Serv...