Fisher & Paykel 80328 EC120DMV1 - Manual

104923 issue A

ECN 06 037

Designer Series Island Canopy

80327 EC120DXV1 (SS NZ/AUS)

80328 EC120DMV1 (IR NZ/AUS)

88388 EC120DXV1 (EU)

88833 EC120DXV2 (UK)

Please note product may vary slightly from the picture.

Please read the entire instructions before installing the canopy.

INSTALLATION INSTRUCTIONS

CONTENTS

Contents of packaging

Equipment required

Optional accessories

1 x canopy hood

Electric drill

Light bulb

104467

2 x chimney pieces

Drill bits

Chimney ext.(10’) SS

8 x angle brackets

Spirit level

Chimney ext.(10’) IR

1 x installation instructions

Screwdriver

Charcoal filter

103821

4 x filters (part number 104660)

Jig saw

Recirculation kit

1744

Installation kit (part number 104922)

Ladder

4 x 12 x 40mm screw

Tape measure

30 x 6 x ¼” self tapping screw

Duct tape

(2 spare)

Ducting

PRE-INSTALLATION

Thank you for purchasing a quality, stainless steel canopy hood.
We have a high standard of quality control and each canopy hood is tested and approved before it
leaves the factory.

IMPORTANT

•

Always switch the power off prior to installation, servicing or cleaning the canopy hood.

•

Never use the canopy hood without the filters.

•

Stainless steel is very easily damaged during installation if abraded or knocked by tools.
Protect the top of the canopy with cardboard or polystyrene during installation.

•

Please read the entire instructions before installing the canopy hood.

•

A power outlet should be within 750mm from the motor assembly and can be either on the
wall, behind the chimney or in the ceiling. An extension lead may be necessary on some
installations.

•

To comply to electrical safety regulations this canopy must be plugged into a socket near the
appliance. The socket must be accessible and enable the end user to isolate the canopy from
the power for the purpose of internal cleaning or maintenance.

Ducting accessories are not supplied. All ducting must comply with local requirements and
building codes.

All electrical work must be done in accordance with local and/or national electrical
codes as applicable. For safety this product must be earthed. If you are unfamiliar with
methods of installing electrical wiring, employ the services of a qualified electrician.
Turn off power at service entrance before installing wiring or servicing this product.

lbs

The canopy hood is heavy please ensure adequate care when installing the canopy hood
to prevent personal injury. The canopy hood must be installed onto a solid wall or solid
stud. Weight of product 43.2 kg.

HEIGHT OF CANOPY HOOD

•

The canopy is designed for 2440mm high ceilings.

•

The chimney is telescopic and is designed for hood installations
between 600 to 750mm above the cooking surface.

•

Ascertain the desired installation height of the canopy hood.

•

Any installation above 750mm will compromise the extraction
performance.

•

The air outlet from the motor requires 150mm round ducting
which requires 170mm diameter hole in the ceiling.

A=600 min (electric cook top)
A=650 min (gas cook top)

CONTROL PANEL

Delay switch: Canopy hood will remain on a
low, mid or high speed for five minutes to clear
away all residual cooking odours before
switching off automatically

.

FILTER SURFACE

HOB TOP

A

I

I I

I I I

Fan On/Off

Mid Speed

High Speed Delay Switch

Light On/Off