Fisher & Paykel 60 - Manual

5 Safety and warnings Important safety precautions Isolating switch: make sure this cooker is connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply. Household appliances are not intended to be played with by children. Children, or persons wi...

6 750 mm 500 mm 105 mm 450 mm Clearances Installation clearances and protection of combustible surfaces shall comply with the current local regulations eg. AG 601 (AS 5601) Gas Installations code. Installation shall comply with the dimension in Fig. 1 bearing in mind that: Overhead Clearances In no ...

7 Installation instructions Levelling the cooker To fit the adjustable feet: Place the cooker on its back as shown. Screw the four feet to the cooker. Stand the cooker and level it by screwing or unscrewing the feet with a spanner. Fig. 2a Fitting the adjustable feet (supplied with the cooker in a s...

8 Installation instructions Anti-tilt bracket Important! To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. To fit the anti-tilt bracket: After you have located where the cooker is to be positioned mark, on the wall, the place whe...

9 Installation instructions Gas supply The gas connection must be carried out by an authorised person according to the relevant standards. Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the gasket has been placed (see Fig.s follow...

10 Installation instructions After installing the freestanding cooker and connecting the gas supply: 1 Using a suitable leak detection fluid solution (e.g. Rocol) check each gas connection one at a time by brushing the solution over the connection. The presence of bubbles will indicate a leak. If th...

11 Installation instructions Converting to a different gas type This appliance is suitable for use with Natural gas or LPG gas (check the “gas type” sticker attached to the appliance). To convert from one gas type to another, you need to replace the injectors, and then adjust the minimum burning set...

12 Installation instructions Adjusting the minimum burner setting Check whether the flame spreads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, increase the minimum gas rate setting. Check whether the burner remains lit even when...

13 Cod. 1131682 Installation instructions Lubrication of the gas taps A qualified technician must lubricate the gas taps. Wiring diagram

14 Using your oven for the fi rst time Fig. 11 Control panel Before using your new oven, please: 1 Read this user guide, taking special note of the ‘Safety and warnings’ section. 2 Remove all accessories and packaging. 3 Condition the oven: Slide in the shelves and grill pan as shown. Fit them betwe...

15 Using your oven 1 Select the function using the function knob. The oven light will come on. 2 Select the temperature using the temperature control knob. The oven temperature indicator light, above the temperature knob on the control panel, will glow until the oven has reached the set temperature,...

16 Cooking functions OVEN LAMP Only the oven light comes on. It remains on in all the cooking functions. BAKE The upper and lower heating elements come on. BAKE is the traditional method of cooking. It is best to cook on only one shelf at a time in this function. FAN BAKE The upper and lower heating...

17 Using your gas cooktop Gas burners The knob controls the flow of gas through the safety tap. = closed valve = maximum aperture or flow = minimum aperture or flow You can choose to cook at any heat between and , but never between and 0 . 1 Auxiliary burner 2 Semi-rapid burner 3 Triple-ring wok bur...

18 Using your gas cooktop Before using your cooktop Before using your new cooktop, please: Read this user guide, taking special note of the ‘Safety and warnings’ section. Turn the cooker on. Make sure all controls are turned off. Lighting the cooktop 1 Choose the control knob for the burner you want...

20 Using your gas cooktop Burners Minimum Maximum Auxiliary 12 cm (6 cm with grate) 14 cm Semi-rapid 16 cm 24 cm Triple-ring wok 26 cm 28 cm Maximum diameter for woks 36 cm Choosing a burner Use flat-bottomed pans, and make sure that they match your burner, as shown in the following table. A small p...

21 Cooktop troubleshooting Problem Possible solutions My cooktop burners do not light. Check the cooker is switched on.Check the gas supply valve is turned on and the supply to the house is working. You should hear the gas when you turn a burner on.The ignitors may be dirty. Clean them with a toothb...

22 Care and cleaning Important! Before you start cleaning your cooker, please: Read these cleaning instructions and the ‘Safety and warnings’ section at the start of this user guide. Turn the cooker off at the wall. Make sure the cooker is a safe temperature to touch. Do not use a steam cleaner. Do ...

23 Care and cleaning Cap Ignitor Flame spreader Burner parts and pan supports You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly before they become burnt on. Do not wash these parts in a dishwasher. After cleaning, check that the burners and ...

24 Care and cleaning Replacing the wok burner To replace the wok burner, fit the burner ring to the housing as shown by the arrow in the Fig. following. Make sure the burner is not able to rotate. Gas taps If you have problems with the gas taps, call your Authorised Service Centre. Fig. 22 Triple-ri...

25 Care and cleaning Cleaning the enamel cavity Clean the enamel on the inside of the oven when it has cooled down, using household detergents or an ammonia-based cleaner. You may use ‘off the shelf ’ oven cleaners, if you carefully follow the manufacturers’ instructions. To make cleaning easier, yo...

26 Care and cleaning Removing the oven door The oven door can easily be removed as follows: Open the door completely. Hook the swivel retainers of the right-hand and left-hand hinges (Fig. 28a) onto the metal bar above them (Fig. 28b). Lift the oven door slightly. The notch on the bottom of the hing...

27 Care and cleaning Replacing the oven lamp Let the oven cavity and the heating elements cool down. Remove the protective cover “B”. Unscrew and replace the bulb “A” with a new one suitable for high temperatures (300°C) with the specifications: 230-240V 50 Hz, 15W, E14 Refit the protective cover “B...

28 Warranty and service Before you call for service or assistance ... Check the things you can do yourself. Refer to the installation instructions and your user guide and check that: 1 Your product is correctly installed. 2 You are familiar with its normal operation. If after checking these points y...