Page 2 - Contents; Cleaning Your Cooker
Contents 1. Before You Start... 1 2. Cooker Overview 3 3. Cooking Tips 13 4. Cooking Table 14 5. Troubleshooting 15 6. Cleaning Your Cooker 17 7. Installation 21 8. Conversion to Propane Gas 30 9. Servicing 32 10. Circuit Diagram 38 11. Technical Data 39
Page 3 - DO NOT modify this appliance.
1 Australia Thank you for buying this cooker. It should give you many years of trouble-free cooking if installed and operated correctly. It is important that you read this section before you start, particularly if you have not used a dual fuel cooker before. This appliance is designed for domestic...
Page 4 - Australia; NEVER operate the cooker with wet hands.; Take care that no water seeps into the appliance.; This appliance is heavy so take care when moving it.; Cleaning; Clean only the parts listed in this guide.
2 Australia DO NOT spray aerosols in the area of the cooker while it is on. Use dry oven gloves when applicable – using damp gloves might result in steam burns when you touch a hot surface. Do not use a towel or other bulky cloth in place of a glove – it might catch fire if brought into contact wit...
Page 6 - ‘Cleaning
4 Australia The igniter should spark and light the gas. Keep holding the knob pressed in to let the gas through to the burner for about ten seconds. If, when you let go of the control knob, the burner goes out, then the FSD has not been bypassed. Turn the control knob to the OFF position and wait fo...
Page 7 - (available from our cookware collection – Part Code RM095); The Griddle; a maximum of 5 minutes
5 Australia The Wok Cradle The wok cradle is designed to fit a Professional 35cm Wok (available from our cookware collection – Part Code RM095) . If you use a different Wok, make sure that it fits the cradle. Woks vary very widely in size and shape. It is important that the Wok sits down on the pan sup...
Page 8 - Function
6 Australia The Glide-out Grill Open the door and pull the grill pan carriage forward using the handle (Fig.2-15) . The grill has two elements that allow either the whole area of the pan to be heated or just the right-hand half. Adjust the heat to suit by turning the knob. To heat the whole grill, t...
Page 9 - Multi-function oven functions; poultry to be defrosted.
7 Australia The multi-function ovens have many varied uses. We suggest you keep a careful eye on your cooking until you are familiar with each function. Remember – not all functions will be suitable for all food types. Please remember that all cookers vary – temperatures in your new ovens may differ ...
Page 10 - Operating the Ovens; Operating the left-hand multi-function oven
8 Australia Operating the Ovens Operating the left-hand multi-function oven The multi-function oven has two controls: a function selector and a temperature setting knob (Fig.2-18) . Turn the function selector control to a cooking function. Fig.2-19 shows the control set for convectional oven cooking...
Page 11 - Setting the time of day; The cooker will not operate unless the clock; Minute Minder; ‘cook time’; and; ‘stop time’
9 Australia The Clock You can use the timer (Fig.2-22) to turn the ovens on and off. The clock must be set to the time of day before the ovens will work. Setting the time of day When the clock is first connected, the display flashes ( 0.00 ) and ( ) alternately. To set the time, turn and hold the Tim...
Page 12 - Key Lock; To activate the key lock
10 Australia A - Top view, B - Side view, C - Shelf guard, D - Front The shelf guard should be at the back pointing upwards Use the Adjusting knob to set the ‘cook time’ you need (Fig.2-28) . Turn the Timer knob to the ( ) position. The display will show the current time of day plus the ‘cook time...
Page 13 - Oven Shelves
11 Australia Accessories Oven Shelves In addition to the flat shelves (Fig.2-35) , some models are supplied with a drop shelf (Fig.2-36) . The drop shelf increases the possibilities for oven shelf spacing. The oven shelves can be easily removed and refitted. Pull the shelf forward until the back of th...
Page 14 - ‘Troubleshooting’; Storage
12 Australia Main Oven Light Press the appropriate button to turn the light on (Fig.2-43) . If the oven light fails, turn off the power supply before changing the bulb. See the ‘Troubleshooting’ section for details on how to change the bulb. Storage The bottom drawer is for storing oven trays and oth...
Page 15 - Tips on Cooking with the Timer; DO NOT place warm food in the oven to be timed.; General Oven Tips; ‘Cleaning Your Cooker’
13 Australia Tips on Cooking with the Timer If you want to cook more than one dish, choose dishes that require approximately the same cooking time. However, dishes can be ‘slowed down’ slightly by using small containers and covering them with aluminium foil, or ‘speeded up’ slightly by cooking small...
Page 17 - ‘Cleaning’
15 Australia Steam is coming from the oven When cooking foods with a high water content (e.g. oven fries) there may be some steam visible at the rear grille. Take care when opening the oven door, as there may be a momentary puff of steam when the oven door is opened. Stand well back and allow any ste...
Page 18 - Hotplate ignition or cooktop burners faulty
16 Australia Hotplate ignition or cooktop burners faulty Is the power on? Are the sparker (ignition electrode) or burner holes blocked by debris? Are the burner heads correctly located? See the section entitled ‘Cleaning’. Remember that each cooktop burner has a special safety device that stops the ...
Page 19 - but take care that no surplus water seeps into the; Daily Care; Do not allow surplus water to seep into the cooker.; Hotplate Burners; The Single Ring Burners; When reassembling a wok burner
17 Australia 6. Cleaning Your Cooker Isolate the electricity supply before carrying out any major cleaning. Allow the cooker to cool. Never use paint solvents, washing soda, caustic cleaners, biological powders, bleach, chlorine based bleach cleaners, coarse abrasives or salt. Do not mix different cl...
Page 20 - Lift the grill pan clear of the support frame.; DO NOT use any abrasive substances.
18 Australia ArtNo.331-0001Grill pan pulled forwards Fig.6-5 ArtNo.331-0003 Grill frame out, no pan ArtNo.331-0004 Removing the grill frame Fig.6-6 Fig.6-7 ArtNo.331-0005 Removing the grill rail Fig.6-8 ArtNo.331-0006 Grill pan plan Fig.6-9 Now fit the two burner caps, ensuring that they are seated p...
Page 21 - ‘Moving the Cooker’; Door Panel; If the door is triple glazed then the inner two panels are; oven door glass since they can
19 Australia Control Panel and Doors Avoid using any abrasive cleaners, including cream cleaners, on brushed stainless steel surfaces. For best results, use a liquid detergent or our Multi-purpose Cleaner. The same cleaner can also be used on the doors. Alternatively, use a soft cloth wrung out in c...
Page 22 - Hotplate
20 Australia Cleaning Table Cleaners listed are available from supermarkets or electrical retailers as stated. For enamelled surfaces use a cleaner that is approved for use on vitreous enamel. Regular cleaning is recommended. For easier cleaning, wipe up any spillages immediately. To help keep your ...
Page 23 - INSTALLATION; Service and Spares; * This information is on the appliance data badge; If you have a problem; If you are still having difficulty, contact you retailer; Please note; Appointments not kept by you may be subject to a charge.; Out of Warranty; Ceramic electric; Electric
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 21 7. Installation Service and Spares Firstly, please complete the appliance details below and keep them safe for future reference – this information will enable us to accurately identify the particular applia...
Page 24 - Dear Installer; The regulations and standards are as follows:; Provision of Ventilation; An appliance for use on Propane must not be installed; Conversion
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 22 Dear Installer Before you start your installation, please complete the details below, so that, if your customer has a problem relating to your installation, they will be able to contact you easily. You must...
Page 26 - Positioning the Cooker; Overhead – Measurement A; Moving the Cooker; The cooker is very heavy, so take great care.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 24 ArtNo.010-0001 Removing the packaging ������� ������� ArtNo.110-0005 110 door clearances ArtNo.110-0023 - 110 - cooker clearances (AUS) � � � � � Fig.7-1 Fig.7-2 Positioning the Cooker The diagram (Fig.7-1)...
Page 27 - First fit the levelling tool on the hexagonal adjusting nut; Completing the Move
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 25 ArtNo.010-0004 Moving the cooker ArtNo.010-0002 Rear roller nut ArtNo.010-0010 Lowering the rear rollers (90) x10 Fig.7-8 Fig.7-6 Fig.7-7 ArtNo.010-0009 Pushing the cooker Fig.7-9 ArtNo.342-0002 - Elan - dr...
Page 28 - Fitting the Splashback; The cooker must be set to the correct height; Fitting a Stability Bracket; (not supplied by with the; Fitting the Restraining Chain
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 26 ArtNo.070-0011 - Elan bracket holes ��������� ������������� Fig.7-13 Fitting the Splashback The splashback fits the back of the cooker. It is secured using 4 screws (2 at each end) in the rear edge of the flu...
Page 29 - Gas Connection; Must be in accordance with the relevant standards.; Pressure Testing; For Natural Gas cookers the pressure should be 1kPa.; Electrical Connection; WARNING: THIS APPLIANCE MUST BE EARTHED
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 27 Gas Connection Must be in accordance with the relevant standards. The gas supply needs to terminate with a down facing bayonet. Because the height of the cooker can be adjusted and each connection is differe...
Page 30 - Fixed Wiring; Checks; Hotplate Check
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 28 ArtNo.132-0002 - 3 phase 240/415Vac 50Hz ���������������� �� ����� Fig.7-17 ArtNo.132-0005 - Fixed wiring connection 2 (AUS) ������������� ������������������ ������������������ ������� ����������� Fig.7-18 ...
Page 31 - Fitting the Plinth; . Fasten the plinth using; Refit the Drawer; Please complete your details in this Guide, inform
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished. 29 Fitting the Plinth Remove the 3 screws for the plinth mounts along the front bottom edge of the range (Fig.7-19) . Fasten the plinth using these screws (alternative colour screws can be found in the loose p...
Page 32 - section at the back of these; Injectors; ‘Technical Data’; Tap Adjustment; Disconnect from the electricity supply.; To Convert to Propane Gas; ‘Technical Data’; Conversion to Propane Gas
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 30 ArtNo.215-0013 - 90 Elan DF - Removing the control panel �� 0 0 0 0 Check in the ‘Technical Data’ section at the back of these ...
Page 33 - WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON; Set the Governor; Ensure that the appliance is gas sound (refer to; ‘Pressure Testing’; in the; ‘Installation’; Check the operation of all the burners.
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 31 Set the Governor Unscrew the governor’s brass top. In the base of the brass top is a plastic snap-in converter device (Fig.8-4) ....
Page 34 - To Remove the Control Panel; To Remove the Hotplate Top; To Remove a Side Panel
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity before servicing. Check appliance is safe when you have finished. 32 � � 9. Servicing Disconnect the cooker from the electricity supply before servicing, particularly before removing any of the following:...
Page 35 - Centre Hotplate Burners
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity before servicing. Check appliance is safe when you have finished. 33 5. To Change a Hotplate Tap Disconnect from electricity supply. Remove the hotplate top (see 3). Unplug the FSD lead from the rear of the...
Page 38 - To Replace an Oven Fan; To Remove the Left-hand Oven Bottom and Top; Bottom Element; Top Element
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON Disconnect from electricity before servicing. Check appliance is safe when you have finished. 36 25. To Remove the Fan Oven Element Disconnect from electricity supply. Remove the oven inner back (see 25). Remove the two screws from th...
Page 40 - Key
38 Australia ������� � �� � �� � �� � �� � �� � �� � �� � �� a b e f c d 1 2 ������� � � �� �� � � � � � � � � � � � � � � � � � � � � � � � � � �� �� �� �� �� �� � � � � � � � � � � �� �� � � � � �� �� � � � �� � � � �� �� �� �� �� �� �� � � � � � � � � � � � �� � � � � �� � � � �� �� � � �� �� � �...
Page 41 - DATA BADGE LOCATION:; Test Pressures (quoted on the data badge)
39 Australia 11. Technical Data This cooker is designed for use on Natural Gas, although a conversion for LP (LPG X Propane (2.54kPa)) gas is available. INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Cooker back. The serial number is repeated on the badge below the le...
