Extron VM 700T - Manual
Extron VM 700T – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – VM 700T Mounting Kit Installation Guide, Continued; Save the two screws for use with the VM 700T mounting kit.; Adjust bracket and thread cables through.
- Page 3 – SECTION A–A; Cord
- Page 4 – Headquarters; Europe; Asia; Japan; Middle East
VM 700T Mounting Kit Installation Guide
Overview
The Extron
®
VM 700T is
an adapter that provides a
VESA‑mounting option for the
TLP 700TV TouchLink
™
panel.
Four holes, one in each corner
allow the adapter to fit any third‑party VESA Type D 75 mm mounting kit.
This guide provides basic instructions for an experienced installer to mount and
perform initial configuration on the TLP 700TV.
Using the VM 700T mounting kit
The TLP 700TV comes assembled with a stand that allows it to be placed on a desk‑top. The stand can also be
removed and replaced with the Extron VM 700T VESA mount adapter kit (part
# 70‑692‑01
). This kit fits into any
third‑party VESA Type D 75 mm wall mount system as follows:
1.
Determine the best location for wall‑mounting the TLP 700TV.
2.
Follow the manufacturer ’s instructions to attach the VESA mounting kit to the wall.
W
The third-party VESA mounting kit must be attached to a wall stud to support the weight of the mounting
arm and the TLP 700TV unit.
3.
Run the cables for power, LAN, and video (two BNC connectors) to the installation site.
4.
Remove the TLP 700TV from its packaging or, if the TLP 700TV has previously been used as a free‑standing,
desk‑top unit, remove all cables to the back of the base.
5.
At the bottom, the two plastic cover plates for the
stand are held together by a Phillips head screw
near the base. Remove the screw in the recessed slot
at the front of the stand, close to the base.
6.
At the top, the two plastic plates covering the stand
are held together by four locking tabs on the back
cover plate fitting into four slots on the front cover
plate. Squeeze the sides of the front plate at the top
so that the tabs are no longer seated in the slots.
68-1792-01
Rev. A
08 09
6
6
75mm
2.95”
75mm
2.95”
5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
VM 700T Mounting Kit Installation Guide, Continued 7. Remove the back cover to reveal the metal stand and the cables connecting the circuit board in the base to the touch panel screen. 8 . Cut the plastic tie holding the cables to the metal stand. 9. Disconnect the power, LAN, audio, LED, and two BN...
V 13. Remove and save the three Phillips head screws holding the plastic molding to the back of the screen. 14. Disconnect the audio, LED, and power cables from the back panel of the screen. The audio cables are the black and white pair, wound around a • ferrite core.The power cables are the red and...
Extron USA - West Headquarters +800.633.9876 Inside USA / Canada Only +1.714.491.1500 +1.714.491.1517 FA X Extron USA - East +800.633.9876 Inside USA / Canada Only +1.919.863.1794 +1.919.863.1797 FA X Extron Europe +800.3987.6673 Inside Europe Only +31.33.453.4040 +31.33.453.4050 FA X Extron Asia +8...
