Extron TP Receiver - Manual
Extron TP Receiver – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Setup Guide — TP Receivers
This card provides instructions for an experienced
installer to set up and operate the TP Receiver Series
products.
Refer to www.extron.com for the complete user ’s
manual.
Pre-installation — Jumper settings
The TP R BNC A and TP R BNC AV are factory configured to receive
RGB video. They can receive component, S-video or composite video
by changing jumper J3 located on the main board.
N
If using the TP R BNC AV with an older TPX 88X transmitter,
download the TP Receivers User’s Manual at
www.extron.com
and refer to the audio jumper settings.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources
and mount the receiver as required.
Step 2 — Connect input
Connect the RJ-45 cable (from a TP transmitter)
to the Input port on the TP R.
Terminate the ends of the cable to the same
standards.
Step 3 — Connect outputs
Attach the applicable output cables (video, audio),
depending on the TP R model.
a
. Composite video output connector — Connect to the single female BNC
connector (VIDEO) for composite video output (TP R BNC AV Only) or to
either the R, or G, or B connectors (TP R BNC A Only).
b
. S-video output connector — Connect to the R (C-chroma) and G (Y-luma)
connectors.
c
. Component video — Connect to the R (R-Y), G (Y) and B (B-Y) connectors.
d
. RGBHV Video — Connect to the R, G, B, H, V connectors.
e
. RGBS video — Connect to the R, G, B, H/V connectors.
f
. High resolution video output connector — Connect to the 15-pin HD
connector (TP R 15HD A only).
g
. Audio connector — Connect an audio device accepting line level analog
audio to the unbalanced stereo audio RCA connectors (TP R BNC A and
TP R BNC AV) or to the line level stereo 3.5 mm, 5-pole captive screw
connectors as shown.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
NOTE
If using Enhanced
Skew-Free™ A/V cable, use the
TIA/EIA T568A standard only.
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
T568A
T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Side
Blue
Blue
Insert
Twisted Pair
Wires
Pins:
1 2 3 4 5 6 7 8
RJ-45 Connector
C
For unbalanced audio, connect both sleeves to the center (ground)
contact. DO NOT connect the sleeves to the negative (-) contacts.
Unbalanced Output
Balanced Output
Do not tin the wires!
Tip
Ring
Tip
Ring
L
R
Sleeves
NO GROUND HERE
NO GROUND HERE
Tip
Tip
L
R
Sleeves
RGB
J3
1
2
3
Component,
S-video,
Composite
J3
1
2
3
Continued on other side
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
