Extron SW2 DP - Manual
Extron SW2 DP – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Product Category
1
SW2 DP • Setup Guide
The Extron SW2 DP is a two input, one output, DisplayPort switcher that switches DisplayPort video and embedded
multi-channel digital audio signals. The SW2 DP is HDCP-compliant and supports data rates up to 10.8 Gbps and computer
resolutions up to 2560x1600 @ 60 Hz. This guide provides basic instructions for an experienced installer to set up and
operate this switcher.
NOTE:
For full installation, configuration, and operation details, see the
SW2 DP User Guide
, available at
Rear Panel Features and Connections
12V
0.6A MAX
POWER
EDID
STORE
DEFAULT
2
1
STORED
RS-232 AUTO
Rx G
Tx
INPUTS
OUTPUT
EDID
REMOTE
SW2 DP
3
2
1
6
7
5
4
a
Power connector for 12 VDC, 1 A power supply
e
EDID Store button
b
DisplayPort input connectors
e
EDID DIP switch
c
DisplayPort output connector
g
RS-232 and auto-switching connector
d
EDID Store LED
Installation Steps
1.
Turn off all of the equipment
and disconnect it from the power source.
2.
(Optional)
Mount the switcher
on a rack shelf or furniture.
3.
Connect DisplayPort sources
to one or both of the SW2 DP input connectors (
b
on the rear panel diagram above).
4.
Connect a DisplayPort output device
to the output connector (
c
).
5.
Connect control devices:
Connect your computer to either of the following SW2 DP communication ports to
configure and control the switcher via SIS commands:
•
RS-232 port
— Connect the unterminated transmit,
receive, and ground wires of an RS-232 cable to the
first three pins on the provided 5-pole captive screw
plug, as shown in the illustration at right. Connect
the plug to the rear panel Remote shared connector
(
g
).
Connect the other end of the cable (terminated with
the female 9-pin HD connector) to your computer
serial port.
Protocol for the RS-232 port is 9600 baud, 8 data
bits, 1 stop bit, no parity.
•
Config port
— Connect a USB A-to-mini B cable
between a USB port on your computer and the front
panel USB connector (
e
on the front panel diagram
on the next page) for USB control.
RS-232 Auto
Computer or
Control System
RS-232 Port
SW2 DP Switcher
Rear Panel
Remote Port
NOTE:
If you use cable that has a drain
wire, tie the drain wire to ground
at both ends.
Tx Rx G
Ground (G)
Transmit (Tx)
Receive (Rx)
Transmit (Tx)
Receive (Rx)
9-pin HD
Connector
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
