Extron SW 4 AR MX HV - Manual
Extron SW 4 AR MX HV – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
1-2
SW 4 AR MX HV and SW 6 AR MX HV • Specifications
Specifications — SW 4/6 AR MX HV Switchers
Video
Gain ............................................... Unity
Bandwidth .................................... 600 MHz (-3dB)
Crosstalk ....................................... -70dB @ 10 MHz
Switching speed ........................... 5 mS (max.)
Video input
Number/signal type ................... 4 or 6 (depending on the model) analog VGA-UXGA RGBHV, RGBS, RGsB,
RsGsBs, component video,
S-video or NTSC/PAL/SECAM composite video
Connectors .................................... 4 or 6 x 5 BNC female (depending on the model)
Minimum/maximum levels ...... Analog ....... -5.0V to +5.0V p-p with no offset
Impedance .................................... 75 ohms
Horizontal frequency .................. 15 kHz to 145 kHz
Vertical frequency ....................... 30 Hz to 170 Hz
Return loss .................................... -30dB @ 10 MHz
Video output
Number/signal type ................... 1 analog VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs, component video, S-video or
NTSC/PAL/SECAM composite video (same as input)
Connectors .................................... 5 BNC female
Minimum/maximum levels ...... Analog ....... -5.0V to +5.0V p-p
Impedance .................................... 75 ohms
Return loss .................................... -30dB @ 5 MHz
DC offset ....................................... ±5mV maximum with input at 0 offset
Sync
Input type ..................................... 4 or 6 analog RGBHV, RGBS, RGsB, RsGsBs
Output type .................................. 1 analog RGBHV, RGBS, RGsB, RsGsBs (same as input)
Standards ...................................... NTSC, PAL, SECAM
Input level ..................................... 0.5V to 5V p-p
Output level .................................. Same as input
Input impedance .......................... 510 ohms
Output impedance ...................... 75 ohms
Max. propagation delay .............. 40 nS
Max. rise/fall time ....................... 4 nS
Polarity .......................................... Positive or negative
Control/remote — switcher
Serial control port ........................ RS-232, 9-pin D female connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity
Serial control pin configurations ... 2 = TX, 3 = RX, 5 = GND
Contact closure ............................ 25-pin female D connector
Extron remote key pad control .. Extron KP 10 keypad .............. connects to the 25-pin D female connector
IR controller module ................... Extron IR 10 1 ........................... connects to the RS-232 9-pin D female connector
Loop signal ................................... Momentary low, 1 mS min., 5 mS max.
Program control ........................... Extron’s control program for Windows®
Extron’s Simple Instruction Set
™
– SIS
™
General
Power ............................................. 100VAC to 240VAC, 50/60 Hz, 10 watts, internal, auto-switchable
Temperature/humidity .............. Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, non-condensing
Operating +32° to +122°F (0° to +50°C) / 10% to 90%, non-condensing
Rack mount ................................... Yes, with optional 3U front panel #60-141-02 or 2U universal rack shelf #60-032-01
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
