Extron SM 3 - Manual
Extron SM 3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mounting to a Wall Stud; Use the appropriate mounting screws (see the above ATTENTION).; When mounting to surfaces that do not allow
- Page 3 – Attaching the Speaker to the Mounting Plate; be made to mount a locked speaker (see “; Using the Security Key to Lock and Unlock; If a secondary attachment point is being used, see the “; Attaching a Secondary; Using the Security Key to Lock and Unlock the Speaker; Unlocked; Removing the Speaker from the Mounting Plate; Remove the security key.; Press to Release
- Page 4 – Attaching a Secondary Support Cable; Reference only
1
IMPOR
TANT
:
IMP
ORT
ANT
:
Go to www
.extr
on.com f
or the
complete user guide
, installation
instructions,
and specifications.
SM 3 • Setup Guide
This setup guide contains installation information about the Extron SM 3 speaker.
Installing the Speaker Mounting Plate
The SM 3 speaker comes with two types of speaker mounting plates:
0° mounting plate
— The 0° plate allows the speaker to be mounted fl at on a vertical wall with the speaker protruding less
than four inches (ADA compliant) from the wall surface.
10° mounting plate
— The 10° mounting plate allows the speaker to be installed at a 10 degree angle so that the speaker
can be pointed down from an elevated position.
The mounting plate can be installed vertically or horizontally as shown
on the right.
0° Mounting Plate
10° Mounting Plate
NOTE:
Observe all applicable building codes and local ordinances when installing the speaker.
Mounting to a Wall Box
1.
Route the speaker cable through the rear of the mounting plate and attach the wire ends to the quick connect contacts using
a small screwdriver (see the following fi gures on the next page). Be sure to observe the correct polarity.
NOTE:
The positive (+) connector and the negative (-) connector are marked on the mounting plate.
2.
Attach the mounting plate to the wall box, using two mounting screws (see fi gure below).
NOTE:
The mounting screw holes in the mounting
plate allow for some degree of play and lateral
movement so that the mounting screws may
be aligned properly with the screw holes of the
wall box. Observe U.S. and European screw
locations, as shown on the right.
ATTENTION:
Make sure that the wall box is
secured to the wall structure and can handle the
weight of the speaker. If there is doubt, secure
the mounting plate with additional mounting
screws. The wall stud mounting holes can be
used for this purpose.
Catch Tab
Vertical Mounting
Horizontal Mounting
Top Screw
European Box Screw Location
U.S. Box Screw Location
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 SM 3 • Setup Guide (Continued) ATTENTION: Use the appropriate mounting screws. The screw heads must not protrude more than .074” (1.9 mm) above the screw holes in the mounting plate (see the fi gure below left). If the screw head protrudes too far above the mounting plate surface, damage to the sp...
3 Attaching the Speaker to the Mounting Plate ATTENTION: By default, the SM 3 speaker is shipped unlocked. When mounting the speaker to the mounting plate, be sure that the speaker is unlocked. Failure to place the speaker in the unlocked position will result in damage to the speaker lock mechanism ...
4 68-1540-50 Rev. B 04 13 Extron Headquarters+800.633.9876 Inside USA/Canada Only Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000+1.714.491.1517 FAX +1.919.850.1001 FAX Extron Europe+800.3987.6673Inside Europe Only +31.33.453.4040+31.33.453.4050 FAX Extron Asia+800.7339.8766Insid...
