Extron PVS 204SA PLUS - Manual
Extron PVS 204SA PLUS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation; PRELIMINAR; Composite video and audio inputs; The PoleVault; A/V output connections; RGB video output; Control connection; You must connect a ground; NOTE; If you use cable that has a drain; PVS 204SA Plus Rear Panel
- Page 3 – Paging sensor input; Aux/Mix input connection; Captive Screw; MP 101 D front and rear panels; CAUTION; DO NOT; Line out audio port; connector to this port.; Amplified Out; a maximum output load of 4 ohms.; Configuring the PVS 204SA Plus Switcher; at; Firmware updates can be made only via the front panel Config port.; See page 4 for the SIS Command/response Table for the PVS 204SA Plus
- Page 4 – Europe; Asia; Japan; Middle East; SIS Command/Response Table; Command; PVS 204SA Plus specific symbol definitions; SIS
Installing the PVS 204SA Plus
Mount the PVS 204SA Plus in the Extron PMK 450 (Projector Mount Kit), which is installed above the projector, as follows:
1.
Follow steps 1 through 3 of “Installation — Stage Four”, in the
PoleVault System Installation Manual,
supplied with the complete
PoleVault System.
2.
Lift the PMK’s bottom plate (with the PVS 204SA Plus and power supply installed) up to the base of the pole, and connect the cables
to the switcher as shown below.
Power connection
a
DC power connector —
Attach the supplied orange, 2-pole, male captive screw connector to the cord of the supplied power
source as shown in the figure above. When all other cables have been connected, plug the captive screw connector into the
2-pole female connector to connect the switcher to the 12 VDC power source. The front panel power LED ( ) lights while the
PVS is receiving power.
N
Use only the supplied 12 V power supply for this switcher.
A/V input connections
b
RGB video and audio inputs (“RGB”) —
Each RGB input requires the use of two twisted pair (TP) cables, A and B. Using TP
cables, connect up to four high resolution computer video and audio sources via the PVT RGB D input wallplates to these eight
RJ-45 female connectors.
N
Inputs 3 and 4 can be configured for either RGB or composite video signals via RS-232. Default is composite video.
PVS 204SA Plus
PoleVault
™
Switcher
The Extron PVS 204SA is a four input, two output, twisted pair,
audio and video switcher with a built in audio amplifier. The PVS 204SA accepts high resolution (RGB) video and audio, and
composite video and audio signal inputs, along with a line level mono audio auxiliary/mix input. The PVS 204SA is part of
the PoleVault System, and is used in conjunction with the Extron PVT series of transmitters and with Extron speakers.
Installation Notes – Addendum
L
R
L
R
AUX/MIX IN
LINE OUT
AUDIO
PAGING
SENSOR
DO NOT GROUND
OR SHORT
SPEAKER OUTPUTS
I
N
P
U
T
S
RS-232 MLC/IR
DC VOL
4/8
Ohms
AMPLIFIED OUTPUT
VOL/MUTE
Tx
A B C D E
Rx IR
12V
10V
POWER
UL 2043 PLENUM RATED
12V
3A MAX
US
LISTED 17TT
AUDIO/VIDEO
APPARATUS
®
RGB
VIDEO
OUTPUTS
CONTROL
N15779
2A RGB
1A RGB
1B RGB
2B RGB
4A RGB
RGB
3B
VIDEO
RGB
4B
VIDEO
3A RGB
PVT RGB D Input
(2 cables, A and B)
RGB output
to projector
RGB #1A
PVT CV D
Input
(1 cable)
VIDEO #4
Ground
+12 VDC input
External
Power Supply
(12 VDC, 3 A max.)
Power source
Tie Wrap
Video output
to projector
RGB #1B
MLC104 IP Plus
RS-232 input
4-pole Captive
Screw Connector
Audio output
to speakers
VGA
RCA
5-pole Captive
Screw Connector
2-pole Captive
Screw Connector
CAT 5 cable
with RJ-45
connector
CAT 5 cables
with RJ-45
connectors
d
e
b
a
h
c
B
A
+12 VDC
Ground ( )
Transmit (Tx)
Receive (Rx)
Ground ( )
i
g
j
k
10V
Wire colors (Left and Right)
Red - Positive terminals
Black - Negative terminals
Paging Sensor
Aux/Mix
Line Out Audio
N
This power supply is sufficient
to power the switcher, up to 4
A/V wallplates and the
MLC 104 IP Plus controller
AUDIO IN
L
R
VIDEO IN
COMPUTER IN
AUDIO IN
MLC Wire colors PVS 204SA
A (Rx) White A (Tx)
B (Tx) Violet
B (Rx)
Ground Drain Wire
D (Ground)
Ground Black D (Ground)
12V In Red E +12 V
DC Volume Control (Vol/Mute)
f
2-pole Captive Screw Connector
3-pole Captive Screw Connector
5-pole Captive Screw Connector
3-pole Captive Screw Connector
Power Supply
h
i
g
j
PVS 204SA PLUS
POLEVAULT SWITCHER
INPUTS
1
2
RGB
MIN/MAX
CLIP
CONFIG
AUTO
SWITCH
AUX/MIX LEVEL
3
4
VIDEO
AUDIO
PAGING
SENSITIVITY
STEREO
ON
DUAL
MONO
HIGH
PASS
FILTER
OFF
ON
1 2
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation PRELIMINAR Y PRELIMINAR Y c Composite video and audio inputs (”Video”) — Each composite video input (3B and 4B) needs one TP cable. Using TP cable, connect up to two composite video and audio sources via the PVT CV D input wallplates to 3B and 4B RJ-45 female connectors. C The PoleVault...
g Paging sensor input — Connect the optional Priority Page Sensor to this port, to enable audio interrupts during paging system use. N Enable the switcher’s paging sensor port, using Global Configurator or the MediaLink Switchers (MLS) and PoleVault Switchers (PVS) control software, available at www...
Extron USA - West Headquarters +800.633.9876 Inside USA / Canada Only +1.714.491.1500 +1.714.491.1517 FA X Extron USA - East +800.633.9876 Inside USA / Canada Only +1.919.863.1794 +1.919.863.1797 FA X Extron Europe +800.3987.6673 Inside Europe Only +31.33.453.4040 +31.33.453.4050 FA X Extron Asia +8...
