Extron MTP 1500RL 15HD A SEQ - Manual
Extron MTP 1500RL 15HD A SEQ – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
MTP 1500RL 15HD A SEQ • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate the Extron MTP 1500RL
15HD A SEQ twisted pair receiver.
For full details, see the
MTP 1500RL 15HD A SEQ User Guide
, available online at
MTP 1500RL Series
POWER
12V
1.0A MAX
MTP 1500RL 15HD A SEQ
OUTPUT
MONO
L
R
AUDIO
RGB
PEAKING
LEVEL
DELAY
RED
GREEN
BLUE
SELECT
ADJUST
MIN/MAX
INPUT
BUFFERED OUTPUT
ON
H
+
V
+
CSYNC
SO
G
VIDEO
END
SP
ARE
MTP
MTP
Installation and Setup
Step 1 — Mounting
Turn off or disconnect all equipment power sources. Mount the MTP 1500RL 15HD A SEQ receiver as required.
Step 2 — Connect Input
Connect the RJ-45 cable from an MTP transmitter to the Input port on the MTP 1500RL 15HD A SEQ receiver.
Terminate the cable as shown below right, using the same standard (A or B) at both ends.
NOTE:
The transmitter and receiver are designed for and perform best with Extron Enhanced Skew-Free AV cable terminated in accordance
with the TIA/EIA T568A standard. CAT 5 cables are acceptable but less preferable. Using preterminated and tested cables is also
recommend, Cables terminated on site should be tested before use to ensure that they comply with Category 5 specifications.
Step 3 — Connect Outputs
Attach the applicable output cables (video, audio, and buffered output).
A.
High resolution video output
— Connect a display device to the 15-pin HD connector (RGB).
B.
Audio connector
—
Connect an audio device to the 5-pole captive screw connector for mono audio output
1
MONO AUDIO
2
1
MONO AUDIO
2
Unbalanced Output
Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT
connect the sleeves to the negative (-) contacts.
C.
Buffered output
— Connect up to 5 daisy-chained MTP receivers to this RJ-45 connector.
Insert Twisted
Pair Wires
Pins:
RJ-45 Connector
1 2 3 4 5 6 7 8
Pin
T568A Wire
Color
T568B Wire
Color
1
White-green
White-orange
2
Green
Orange
3
White-orange
White-green
4
Blue
Blue
5
White-blue
White-blue
6
Orange
Green
7
White-brown
White-brown
8
Brown
Brown
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
