Extron MTP 15 HD A - Manual

Page 2 - Korean; Safety Instructions; ii

Safety Instructions • English WARNING : This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. ATTENTION: This symbol, , when used on the product, is intended to...

iii FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. The Class A limits provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This...

Page 4 - Conventions Used in this Guide; Notifications; potential; Specifications Availability

Conventions Used in this Guide Notifications The following notifications are used in this guide: WARNING: A warning indicates a situation that has the potential to result in death or severe injury. ATTENTION: Attention indicates a situation that may damage or destroy the product or associated equipm...

Page 5 - Contents; MTP 15HD A Series • Contents

Contents Introduction ............................................ 1 About this Guide .............................................. 1About the MTP Transmitters and Receivers ..... 2 Twisted Pair Cable Advantages .................... 2 Transmission Distance ..................................... 3 In...

Page 6 - Introduction; About this Guide; MTP products; MTP 15HD A Series • Introduction

Introduction This section gives an overview of the user guide. This section also describes the MTP 15HD A Series of transmitters and receivers. Covered topics are: • About this Guide • About the MTP Transmitters and Receivers • Transmission Distance About this Guide This guide contains installation,...

Page 7 - About the MTP Transmitters and Receivers; table; UTP cable and non-C7 transmitters and receivers are used.; Twisted Pair Cable Advantages

About the MTP Transmitters and Receivers The Extron MTP T 15HD A transmitter and MTP RL 15HD A and MTP RL 15HD A SEQ receivers are a system for long-distance distribution of VGA or other high resolution video and audio.The MTPs are a part of the Extron compact line of basic distribution amplifiers, ...

Page 8 - Transmission Distance; on page 4 specifies the recommended maximum; on page 4 apply for a single transmitter

Transmission Distance The maximum distance is determined by the frequency and resolution of the signal that is input to the transmitter. The table on page 4 specifies the recommended maximum transmission distances and transmitter Pre-Peak switch positions (see figure 3 , e on page 9) using Extron En...

Page 10 - Installation Overview; Potential damage to property.; MTP 15HD A Series • Installation and Operation

Installation and Operation This section provides information on: • Installation Overview • Front Panel Features • Transmitter Rear Panel Features • Receiver Rear Panel Features • Power Supply Wiring and Grounding • Twisted Pair Cable Termination • Skew Delay Compensation • EDID Configuration Install...

Page 11 - Front Panel Features; MTP 15HD Front Panels; — The LED indicator lights when the unit is receiving power.; Record LED; The first DIP switch selects the vertical frequency

Front Panel Features See figure 2 to identify the front panel features on the transmitter and receiver. MTP RL 15HD A Receiver M T P S E R I E S MTP RL 15HD A SEQ Receiver RGB PEAKING LEVEL RGB DELAY PEAKING LEVEL MTP SERIES REDGREEN ADJUST BLUE SELECT ON 1 2 3 4 5 H SYNC + V SYNC + S-VIDE O END UNI...

Page 13 - End Unit switch

k DIP switches (RL receivers only) — A 5-pole DIP switch is used to configure the features of the MTP receivers. • • Horizontal sync (H Sync +) switch — Set this switch On (up) for positive horizontal sync or Off (down) for negative sync. • • Vertical sync (V Sync +) switch — Set this switch On (up)...

Page 14 - Transmitter Rear Panel Features; Transmitter Rear Panel; — Plug the included external 12 VDC power supply into this; Power Supply Wiring; on page 12 to wire the; Input video connector; Connect a computer video source to this 15-pin HD; 5-pin HD Connector; — Connect a video monitor to this 15-pin HD connector for

Transmitter Rear Panel Features Figure 3 shows an MTP T 15HD A transmitter, which has all of the connectors and other features that are on either transmitter in the MTP 15HD A series. MTP T 15HD A Transmitter OUTPUT INPUT AUDIO POWER 12V .5A MAX MONITOR PRE-PEAK ON OFF M T P T 1 5 H D A NOTE: A “C7”...

Page 15 - Audio input connector; mm Stereo Audio Plug

d Audio input connector — Plug a 3.5 mm stereo audio plug into this connector for unbalanced audio input. Wire the plug as shown in figure 5. The stereo audio input is summed and output on the twisted pair cable as mono audio. Sleeve ( ) Ring Right (-) Tip Left (+) Figure 5. 3.5 mm Stereo Audio Plug...

Page 16 - Receiver Rear Panel Features; Plug the included external 12 VDC power supply into this; Twisted Pair Cable; Connect a projector or other high resolution video device

Receiver Rear Panel Features Figure 6 shows an MTP RL 15HD A receiver, which has all of the connectors and other features that are on either receiver in the MTP 15HD A series. MTP RL 15HD A Receiver NOTE: A “C7” label is affixed to transmitters designed for STP201 or CAT 7 cable. INPUT BUFFERED OUTP...

Page 17 - Power Supply Wiring and Grounding; Figure 8 shows how to wire and ground the connector.; SECTION A–A; Power Connector Wiring and Grounding

Power Supply Wiring and Grounding Figure 8 shows how to wire and ground the connector. ATTENTION: • Potential damage to property. Power supply voltage polarity is critical. Incorrect voltage polarity can damage the power supply and the transmitter or receiver. Identify the power cord negative lead b...

Page 19 - Twisted Pair Cable Termination; use the same; Connector; When using Enhanced Skew-FreeTM; Twisted Pair Cable Termination Diagram; For proper grounding of; shielded twisted pair cable; , ensure the shield around; should not; be used to

Twisted Pair Cable Termination Figure 9 details the recommended termination of twisted pair cables with RJ-45 connectors in accordance with the TIA/EIA T568A or TIA/EIA T568B wiring standards. You can use either standard with CAT 5, 5e, 6, 7, and STP201 cable, but ensure that you use the same standa...

Page 20 - Skew Delay Compensation; SEQ Receiver Skew Compensation; Zero the skew delay; Non-SEQ Receiver Skew Compensation

Skew Delay Compensation CAT 5, 5e, 6, 7, and STP201 cable can lead to registration errors between the Red, Green, and Blue video signals. Pair skew can be measured with test equipment or identified by viewing a crosshatch test pattern with a critical eye to determine if either the Red, Green, or Blu...

Page 21 - EDID Configuration; Recording a Display EDID; Rotary Switch

EDID Configuration The MTP 15HD A transmitter can either record EDID from a display device, or a pre-programmed EDID can be selected using the rotary and DIP switches. Recording a Display EDID 1. Turn the rotary switch to position 0. NOTE: The vertical frequency DIP switch has no effect in this mode...

Page 22 - Part Numbers; or; Optional Accessories; MTP 15HD A Series • Reference Information

Reference Information This section provides information about: • Part Numbers, Optional Accessories, Cables, and Connectors Part Numbers, Optional Accessories, Cables, and Connectors Part Numbers MTP Transmitter and Receivers Part Number MTP T 15HD A transmitter 60-1282-01 or MTP RL 15HD A receiver ...

Page 23 - Cables; Description; Connectors; Part Number

Cables NOTE: Extron Enhanced Skew-Free AV UTP cables are not recommended for Ethernet or LAN applications. Description Part Number VGA connector cable 26-238-xx SYM BNC Female Mini High Resolution cable 21-251-xx Extron Enhanced Skew-Free AV UTP cable (cut, various lengths) 26-569-xx Extron Enhanced...

Page 24 - Mounting; Tabletop Placement; UL Guidelines for Rack Mounting; Elevated operating ambient temperature; MTP 15HD A Series • Mounting

Mounting This section outlines the various mounting options available for the MTP 15HD A Series transmitters and receivers: • Tabletop Placement • Under-Desk Mounting • Rack Mounting • Projector Mounting Tabletop Placement Attach the four provided rubber feet to the bottom of the unit and place it i...

Page 25 - ). The kit allows the product to be vertically; Projector Mounting

Rack Mounting Procedure These units can be mounted on any of these optional rack systems, including: • RSF 123: 3.5 inch deep, 1U rack shelf kit (part number 60-190-20) • RSB 123: 3.5 inch deep, 1U basic rack shelf (part number 60-604-21) • RSU 126: 6 inch deep, 1U rack shelf kit (part number 60-190...

Page 26 - Contact Information; USA; xtron

Extron Headquarters +1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +1.919.850.1001 FAX Extron Europe +800.3987.6673 (Inside Europe Only)+31.33.453.4040 +31.33.453.4050 FAX Extron Asia +800.7339.8766 (Inside Asia Only)+6...

Extron MTP 15 HD A - Manual

Table of Contents:

Summary

Other Extron Models