Page 2 - Example of Precautions Section in Manuals; 安全须知; 注意; Precautions
This symbol is intended to alert the user of important operating and mainte-nance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk ...
Page 3 - FCC Class A Notice; This device may not cause harmful interference.; NOTE; unit to ensure compliance with FCC emissions limits.; Copyright; © 2010 Extron Electronics. All rights reserved.; Trademarks; Example of FCC Class A Notice in Manuals; Indicates a potential hazard to equipment or data may exist.
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interferen...
Page 5 - Contents
v MPS 409 Switcher • Contents Introduction ........................................... 1 About this Manual .......................................... 1About the MPS 409 ......................................... 1Features ........................................................... 1 Installation .......
Page 7 - Introduction; About this User Guide; and provides HDCP compliance.; Features; with other HDCP compliant devices.
Introduction • About this User Guide • About the MPS 409 • Features About this User Guide this guide contains information to install, configure, and operate the Extron Electronics MPS 409, Media Presentation Switcher. In this guide, the MPS 409 may be referred to as “MPS”, “MPS 409” or “switcher”. A...
Page 9 - Extron; Digital Media; Extron; MPS 409 Application Diagram; — Powers a condenser microphone.; Internal universal power supply; supply provides worldwide power compatibility.
OUTPU T HDM I 3 1 2 OUTPU T 1 2 3 100-240V ~ 0. 2A 50/60 Hz 2 1 OUTPU T OUTPU T VGA/YU V DVI- D 1 2 OUTPU T 1 2 OUTPU T 2 1 LEV EL MI C +48V LIN E ON OF F MIC/LIN E 1 2 ON + - + - - + R L PROGRA M AUDI O OU T MIC/LINE IN RS-23 2 Rx Tx OUTPU T 1 2 1 2 OUTPU T VIDE O L R R L R L XP A 10 02 1 2 LIM ITE...
Page 10 - Installation; Mounting the Switcher; ) is included with the; Mounting the MPS Switcher; UL Rack Mounting Guidelines
Installation this section describes the installation and the operation of the MPS 409, including: • Mounting the Switcher • Rear Panel Connections • Cabling the MPS 409 Switcher Mounting the Switcher the MPS 409 is housed in 1U, full rack width metal enclosure rack- or desk-mountable. the MBD 149 1U...
Page 12 - Rear Panel Connections; j k
Rear Panel Connections 50/60 Hz L R Tx MIC/LINE IN ON OF F MIC LINE LEVEL +48V ON 1 2 HDMI VIDEO VGA/YUV DVI-D OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT 1 2 L 1 2 1 2 1 2 1 2 1 2 1 2 3 3 1 2 L L R R R MIC/LINE PROGRAM AUDIO OUT Rx RS-232 OUTPUT 100-240V 0.4A MAX j k s t u a b c d f g h i e l ...
Page 13 - Connecting the 3-pole captive screw microphone connector; or; Connecting the 3-pole captive screw RS-232 connector; SIS; RS-232 Captive Screw Connector wiring
j Mic/Line input — One 3-pole captive screw connector switchable between mic and line level inputs. A two position DIP switch (u) selects mic or line input level. Connecting the 3-pole captive screw microphone connector 1. Use a pre-made 3-pole captive screw microphone cable, or cut bulk microphone ...
Page 14 - Connecting the 5-pole captive screw stereo output connector; Unbalanced Audio Output; Phantom Power and Mic/Line Input selection
q HDMI audio output — 3.5 mm stereo connector with audio output from the selected HDMI input. See figure 4 for wiring. r Composite video output — One BNC connector with selected composite video output for a composite video display device. s Composite audio output — One stereo pair of RCA connectors ...
Page 15 - Cabling the MPS 409 Switcher
Cabling the MPS 409 Switcher the MPS switcher can be connected to as many as 9 input devices simultaneously. It can output to as many as four devices (three in combine mode) simultaneously. Outputs can be configured for simultaneous outputs from each of the four input groups, VGA/YUV, DVI-D, HDMI, c...
Page 16 - Operation; Front Panel Features; a b; Video/Audio Group Buttons
Operation this section discusses how to connect, configure, and operate the MPS 409. topics that are covered include: • Front Panel Features • Front Panel Operation • Program Audio • EDID Minder • HDCP Front Panel Features 1 MODE 2 SINGLE 1 SEPARATE 2 COMBINE DVI/HDMI 1 2 1 2 3 MUTE MPS 409 DIGITAL ...
Page 18 - Front Panel Operation; Switcher Operating Modes; The switcher operating modes are:; nor will it scale or convert between other input formats.; View Mode; Front Panel Button/LED Functions During View Mode; Press and hold the mode button for more than 3 seconds,
Front Panel Operation the MPS switcher can be connected to as many as nine input devices and four output displays plus an audio amplifier. It operates in one of four switching modes: single (the default), separate, single-combine, or separate-combine. the functions of the front panel controls are de...
Page 19 - Input Selection — Single Switcher Mode; Front Panel Input Selection-Single Mode; Input Selection — Separate Switcher Mode; Program Audio on page 15; Front Panel Input Selection-Separate Mode; Program Audio Breakaway
Input Selection — Single Switcher Mode In single switcher mode (default) the switcher emulates a single nine input switcher (9x1). In this mode, when an input is selected from any group, the green LED indicator to the right of the button lights, and the selected input (video and audio) is routed to ...
Page 20 - Combine Mode; Input selection — Single-combine mode; Front Panel Security Lockout (Executive mode); Executive mode contains two levels:; To toggle through the executive modes:; Toggle Executive Modes
Combine Mode Combine mode switches a selected HDMI/DVI input to the HDMI output, deactivating the DVI audio and video outputs. this enables the MPS 409 to function as one 5x1 HDMI/DVI and audio switcher, adding VGA/YUV and Video inputs. Combine mode can be used whether the switcher is in separate or...
Page 21 - Program Audio; Program Audio Selection; Single switcher mode; Program Audio Selection (HDMI Program Audio Selection Shown); Program Audio Breakaway on page 23; Program Audio Volume Control; Program audio mute does not mute the microphone input.
Program Audio the selected audio input is routed to the program audio output according to the switcher mode. the input LED selected for program audio output blinks. Program Audio Selection Single switcher mode In single switcher mode, audio from the selected input is routed to the program audio outp...
Page 22 - Audio Gain and Attenuation Adjustments; normalize; To adjust the input audio level from; Press and hold the Program Audio Mute; AND
Audio Gain and Attenuation Adjustments Individual audio inputs can be adjusted over a range of -18 dB to +24 dB using the program audio mute button and program audio volume control knob. these adjustments can be used to normalize the input audio levels so that output volume is consistent for all inp...
Page 23 - Microphone Controls; Mic Volume and Mute; Mic volume; for more information.
Microphone Controls Mic on/off Mic volume and mute are controlled from the front panel. the Mic mute button toggles the Mic input on or off. the corresponding red LED illuminates when Mic volume has been shut off (muted). When the Mic input is enabled it is mixed with the program audio output. Mic v...
Page 24 - EDID Minder; Automatic Mode —; If an output display has not been connected, a default EDID file is; Input Group; VGA; Default EDID Resolutions
EDID Minder the DVI and VGA/YUV groups feature EDID Minder, ensuring that each input source reads the EDID of the output display even when not selected. the result is the video source powers up properly and reliably outputs content when selected. the EDID remains in the selected mode (automatic or u...
Page 25 - User assigned EDID Mode —; Using SIS commands, an EDID file can be selected from a; EDID Resolution Table; Basic Audio; HDCP
User assigned EDID Mode — Using SIS commands, an EDID file can be selected from a table of 19 EDID files. One additional EDID file location is reserved for user-loaded EDID files for the VGA and DVI groups. Once a user assigned EDID is chosen, the switcher stores it at the inputs and no longer polls...
Page 26 - Connection Options; Connecting the 3-pole; , for more information on wiring
SIS Programming and Control this section discusses SIS programming and control of the MPS 409 including: • Connection Options • Host-to-MPS Communications • Command/Response Table • Updating Firmware Connection Options the MPS 409 can be remotely connected via a host computer or other device (such a...
Page 27 - USB Configuration Port; the MPS switcher accepts Simple Instruction Set (SIS; MPS Switcher-initiated Messages; is the; Status change messages; MPS Switcher Error Responses; — Invalid input channel number (too large)
USB Configuration Port Drivers for the MPS 409 USB configuration port are loaded automatically when Dataviewer or Firmware Loader, included on the software disc or available at www.extron.com , are loaded. Host-to-MPS Communications the MPS switcher accepts Simple Instruction Set (SIS ™ ) commands t...
Page 28 - Command/Response Table; Using the Command/Response Table; Symbol definitions
Command/Response Table Using the Command/Response Table the command/response table is shown on the following pages. Lower case characters are acceptable in the command field only where indicated. Symbols are used throughout the table to represent variables in the command/response fields. Symbol defi...
Page 29 - Command/response table for SIS commands; Command
Command/response table for SIS commands Command ASCII Command (host to switcher) Response (switcher to host) Description Switcher-initiated messages Input selection (in separate switcher mode only) Select video and audio input X! * X@ ! Chn X! * X@ ] Group X! and input X@ are selected. X! = Group 1 ...
Page 33 - EDID Format Cross-reference Table
EDID Format Cross-reference Table X1^ Native Resolution Refresh Pixel Clock 0 Automatic Mode 1 800 x 600 60 Hz 40 MHz 2 1024 x 768 60 Hz 65 MHz 3 1280 x 768 60 Hz 79.5 MHz 4 1280 x 800 60 Hz 83.5 MHz 5 1280 x 1024 60 Hz 108 MHz 6 1360 x 768 60 Hz 85.5 MHz 7 1440 x 900 60 Hz 106.5 MHz 8 1400 x 1050 6...
Page 34 - Begin; Updating Firmware; Download the latest firmware file:; Switchers > Media Presentation; To access the firmware uploader:; Firmware Loader
3. From the toolbar, select File > Open . 4. Locate the downloaded firmware file and click to select it. 5. Click Begin on the main screen. the total progress bar tracks the loading progress. 6. When the Transfer Complete! message appears, the upload is finished. Exit the program by selecting Fil...
Page 35 - Specifications; Video — VGA
Reference Information this section discusses the specifications, part numbers, and accessories for the MPS 409. topics that are covered, include: • Specifications • Part Numbers and Accessories • Cables and Connectors Specifications Video — VGA Gain ............................................... Un...
Page 37 - Audio — program audio
Input impedance ............................ 510 ohmsOutput impedance ......................... 75 ohmsMax. input voltage ......................... 5.0 Vp-pMax. propagation delay .................. 30 nsMax. rise/fall time ........................... 4.2 nsPolarity .....................................
Page 38 - General
Audio output — program audio Number/signal type ........................ 1 stereo, balanced/unbalancedConnector ...................................... (1) 3.5 mm captive screw connector, 5-poleImpedance ..................................... 50 ohms unbalanced, 100 ohms balancedGain error ..............
Page 40 - Part Numbers and Accessories; Included Parts; these items are included in each order:; Included parts; MBU 149 1U Full Rack Under-Desk Mount Kit; Optional Accessories; these items can be ordered separately:; Part description; xx
Part Numbers and Accessories Included Parts these items are included in each order: Included parts Replacement part number MPS 409 60-1012-01 MBU 149 1U Full Rack Under-Desk Mount Kit 70-077-03 tweeker (small screwdriver)3.5 mm, 3-pole captive screw connector (2)3.5 mm, 5-pole captive screw connecto...
Page 41 - Cables and Connectors; Bulk Cable; twisted Pairs Plenum Cable
Cables and Connectors When using signals with a scanning frequency of 15–125 kHz and running distances of 100 feet or more, use high resolution BNC cables to achieve maximum performance. Pre-cut Cables VGA-A M-M MD with audio cable Part number Lengths from 3' to 50' 26-490- xx VGA M to BNC M MHR cab...
Page 42 - Assorted Connectors; Gold Plated Male Center Pins for MHR BNC Connectors; Part number
Assorted Connectors Crimp connectors (qty. = 50) Part number Mini HR, BNC Male 100-250-01 Gold Plated Male Center Pins for MHR BNC Connectors 100-256-01 Solder connectors (qty. = 10) Part number RCA-3502, RCA Male 100-333-01 RCA-HQ, RCA Male 100-334-01 1/4" Stereo Phone-HQ 100-332-01 3.5 mm Mini...
Page 43 - and Central America:; USA; xtron; Sample of Extron Warranty Page
Extron ® Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electronics will,...
