Extron MLS 608 D - Manual
Extron MLS 608 D – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MLS 608 D Series • Setup Guide (Continued); Twisted Pair (TP) Cable Transmission Distance; do not connect a LAN cable to any MTP or digital video output port.; same spec at 75 Hz; card, and display used in the system.; Maximum Transmission Distance for Digital Signals at 60 Hz
- Page 3 – CAUTION; DO NOT; Installation and Cabling; Step 1 — Mount the Switcher; Unbalanced Input; Step 3 — Connect MLS 608 D Outputs; • Do not short the “ +” and “
- Page 4 – Step 4 — Connect Outputs from MTP/HDMI U R; • 38400 baud •1 stop bit • no parity • 8 data bits • no flow control; Step 6 — Connect Power; Optional — Connect the 2-pole power connector (see; Host; NOTE: If you use cable that has
- Page 5 – Optimizing Video; Setting the Peaking and Level on the MTP/HDMI U R; Adjusting output skew between the; Selecting the MLS 608 D Output Prepeaking; Adjusting level and peaking between the MLS 608 D and the receiver; See page 7
- Page 6 – Front Panel Features; Front Panel Operation; VOLUME; LED equivalent
- Page 7 – = Incremental or decremental value in; Using the DSP Configurator; Download; Extron S3 Sales and Technical Support Hotline.; Basic Simple Instruction Set (SIS) Commands
- Page 8 – Typical Application for MLS 608 D Series, Showing the MLS 608 D SA; Receiver; Extron; MediaLink Switcher; GlobalViewer; Connector and Cable Information; Twisted Pair RJ-45 Cabling; HD15 Pin Locations
1
MLS 608 D Series • Setup Guide
Rear Panel Features — MLS 608 D and MTP HDMI U R
NOTE:
The MLS 608 D SA, as shown below, is representative of the MLS 608 D Series. It has the maximum number and type of
connectors and features of the three models. The MLS 608 D model lacks the power amplifier output.
The Extron MLS 608 D Series are eight input, multi-format AV switchers with ProDSP
™
audio
and are able to integrate analog and digital sources. There are three models:
• MLS 608 D (with variable preamp output - no amplifier)
• MLS 608 D MA (with 40 watt 70 volt mono power amplifier)
• MLS 608 D SA (with 2 x 20 watt stereo power amplifier)
This guide allows you to easily and quickly setup and configure your MLS 608 D using step by step instructions. It covers performing
basic operations using the front panel controls and selected Simple Instruction Set (SIS
™
) commands.
It also gives connection information for the MTP HDMI U R twisted pair receiver, which is supplied with the MLS 608 D Series unit.
See rear cover for a diagram of a typical MLS 608 D application, showing the MLS 608 D SA model.
NOTE:
For full installation, configuration, and operation details for all MLS 608 D models, see the MLS 608 D Series User Guide,
and for complete details on the MTP HDMI U R, see the MTP HDMI U R User Guide, both available at
.
1
BUFFERED OUTPUT
MTP
+
AUDIO
+12 V OUT
PWR OUT=
12W
2
3
6
L
R
1
L
R
2
L
R
3
L
R
5
L
R
7
L
R
8
1
2
1
2
MIC/LINE
+ 48V
1
2
L
R
L
R
Tx
+12V
Rx
8
4 (MTP)
CONFIGURABLE ANALOG INPUTS
AUDIO INPUTS
AUDIO OUTPUTS
RS-232
HOST
PWR OUT = 7.2 W
DIGITAL OUTPUT
VIDEO + RS-232
ANALOG OUTPUT
DIGITAL INPUTS
5
7
L
R
6
Tx
N/
A
N/
A
Rx
RS-232 INSERT
MLS 608 D SA
100-240V 50/60 Hz
1.2A MAX
1
2
4/8 OHM - 20W x 2
1
4
7
8
5
13
12
11
9
14
MLS 608 D SA
2
3
10
6
Power input
MTP input
RS-232 port (analog side), not used in MLS 608 D system
Digital signal inputs (1 and 2)
RGBHV, RGBS output*
Composite video output*
Digital (HDMI) output
S-video output*
Component video (R-Y, Y, B-Y) output*
RS-232 pass-through connector
Mono audio output
* = Analog outputs
DIGITAL OUTPUT
DIGITAL INPUT
POWER
12V
0.8A MAX
1
2
HDMI
RS-232
PASS THRU
Tx Rx
RGB
VID
Y/C
B-Y
Y
R-Y
ANALOG OUTPUTS
RS-232
Tx Rx
SPARE
MTP INPUT
1
MONO AUDIO
2
MTP/HDMI U R
A
B
C
F
D
A
G
H
E
K
I
J
Pin T568A Wire Color
T568B Wire Color
1
White-green
White-orange
2
Green
Orange
3
White-orange
White-green
4
Blue
Blue
5
White-blue
White-blue
6
Orange
Green
7
White-brown
White-brown
8
Brown
Brown
Power, Analog, and Digital Connections
Audio and RS-232 Connections
a
AC power connector
i
Audio inputs: 5-pole captive screw connectors (inputs 1-3, 5-8)
b
RGB, component/S-video/composite inputs: 15-pin HD
connectors (inputs 1-3, see rear page for pinout details)
j
Mic/line level audio inputs (1-2): 3-pole captive screw connectors
and phantom power LEDs
c
Buffered output: 15-pin HD connector (tied only to input 1)
k
Line level audio output: 5-pole captive screw connectors
(audio outputs 1-2)
d
Universal MTP RJ-45 connector (input 4, see rear page for
pinout details)
l
Power amplifier output connector (MA and SA units only)
e
12 V output MTP/HDMI U R power source: 2-pole captive
screw connector
m
RS-232 control/configuration port and +12 V power output
(for optional MLC power source): 5-pole captive screw connector
f
Analog video and audio MTP output: RJ-45 connector
n
RS-232 insertion pass-through port: 5-pole captive screw connector
g
Digital inputs: HDMI connectors (inputs 5-8)
h
Digital video and RS-232 outputs: RJ-45 connectors
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 MLS 608 D Series • Setup Guide (Continued) Twisted Pair (TP) Cable Transmission Distance CAUTION: Do not connect the MTP cable to any LAN port, telecommunications network, or digital video output port. Likewise, do not connect a LAN cable to any MTP or digital video output port. There are differen...
3 Unbalanced Output Balanced Output Tip NO Ground Here Sleeve(s) Tip NO Ground Here LR A UDIO Tip Ring Sleeve(s) Tip Ring LR A UDIO CAUTION For unbalanced audio, connectthe sleeve(s) to the ground contact. DO NOT connect the sleeve(s) to the negative (-) contacts. Installation and Cabling Step 1 — M...
4 MLS 608 D Series • Setup Guide (Continued) RGB VID Y/C B-Y Y R-Y ANALOG OUTPUTS RS-232 Tx Rx SPARE 1 MONO AUDIO 2 Component Video –Connect to these 3 BNCs. Composite Video – Connect to this BNC. RGBHV and RGBS –Connect to this VGAconnector. S-video – Connect to this mini DIN connector. Mono Audio ...
