Extron MLC 64 RS VC D - Manual
Extron MLC 64 RS VC D – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MLC 60 Decora Series • Setup Guide (Continued); Change the faceplate, buttons, and volume control knob as; If desired, replace the buttons in the faceplate as follows:; Connect the cables to the rear panel ports.; Connect a display device or switcher to; MLC RS D Rear Panel; Peg; MUTE; Turn Knob to
- Page 3 – Product Category; Connect a display device, switcher, or up to two IR emitters to; IR Emitter; — The Digital Input port enables you to connect a switch or sensor to; logic low; Wire the volume control module (MLC 64 RS VC D only); Choose an Extron amplifier that is capable of; Rear Panel; A B C
- Page 4 – 011 Extron Electronics All rights reserved.; Connect and apply power.; all devices in the system.; SECTION A–A; Power Supply; Configure the MLC buttons and ports; MLC 60 Series Configuration; Test the system; to ensure that the MLC is functioning properly.; Mount the MLC to an electrical box or a Decora mounting bracket.; Mount the MLC to a Decora mounting bracket (see the
Product Category
IMPOR
TANT
:
Go to www
.extron.com for the
complete user guide and installation
instructions befor
e connecting the
product to the power sour
ce.
MLC 60 Series • Setup Guide
for the MLC 62 RS D, MLC 62 IR D, and MLC 64 RS VC D
The MLC 60 D Series are keypad controllers for use
in classrooms and meeting facilities. They mount
to Decora
®
-style wallplates and therefore may be
referred to as “D” models. The controllers have
backlit soft touch buttons and can control common
AV functions, including power, input switching,
and volume. The MLC RS series provides RS-232
serial and IR ports for universal display control. In
addition, a digital input and two relays are included
for monitoring and controlling other systems in the
room. The MLC 64 RS VC D has a volume control
module that lets you raise and lower the volume on
an Extron amplifier with a remote volume control
port, such as the MPA 122 or MPA 401. The MLC 62 IR D provides IR control only. These products mount in one-gang or
two-gang junction boxes and include black and white color options.
NOTES:
•
Installation and service must be performed by authorized personnel only.
•
Check that the installation meets the local and state regulatory requirements, including building, electrical,
and safety codes, as well as UL and ADA accessibility requirements.
•
For full installation, configuration, and operation details, see the
MLC 60 Series User Guide
, available at
www.extron.com
.
Installation Steps
Rx
Tx
GROUND
Tx/IR
COMMON
1
1
2
HOST/
CONFIG
PORT
A
RS-232
PORT
B
IR/
S
DIGITA
L
INPU
T
Tx
PW
R
12
V
0.4 A MA
X
RELAYS
N/
O
GROUND
GROUND
GROUND
GROUND
+12 VDC
Rx
GROUND
IR OUT
HOST/
CONFIG
PORT
A
IR
Tx
PW
R
12V
0.4 A MA
X
GROUND
GROUND
+12 VDC
MLC 62 RS D
MLC 62 IR D
MLC 64 RS VC D
GND
VOL
10V
Rear Panels
Rx
Tx
GROUND
Tx/IR
COMMON
1
1
2
HOST/
CONFIG
PORT
A
RS-232
PORT
B
IR/
S
DIGITAL
INPU
T
Tx
PW
R
12
V
0.4 A MA
X
RELAYS
N/
O
GROUND
GROUND
GROUND
GROUND
+12 VDC
1.
Prepare the installation site.
The MLC 60 D models can be installed in a standard US one-gang or two-gang electrical
wall box or mounting bracket (“mud ring”).
a.
Install the electrical box, following the instructions provided with it, or the provided mounting bracket.
CAUTION:
Ensure that the electrical box is properly grounded.
b.
Prepare and pull the cables through the electrical box or mounting bracket.
1
VOLUME
Extron
DISPLAY
ON
OFF
VIDEO
PC
VOLUME
Extron
DISPLAY
ON
OFF
PC
VIDEO
LAPTOP
MUTE
MLC 62 RS D
MLC 62 IR D
AUX
LAPTOP
PC
MUTE
Extron
DISPLAY
VOLUME
ON
OFF
MUTE
VOLUME
FF
VIDEO
MLC 64 RS VC D
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
MLC 60 Decora Series • Setup Guide (Continued) 2. Change the faceplate, buttons, and volume control knob as needed. a. (MLC 64 RS VC D only) If changing the faceplate on the MLC 64 volume control module, first remove the volume knob: 1. Rotate the knob until the dot on the knob is aligned with the b...
Product Category z Port B IR/S (RS models) or Port A IR (IR models): Connect a display device, switcher, or up to two IR emitters to this port. On RS models, you can configure Port B IR/S for either serial or IR communication, using the MLC 60 Series configuration program. On IR-only models, Port A ...
68-2166-50 Rev. A 11 11 Extron USA - West Headquarters + 800.633.9876 Inside USA/Canada Only +1.714.491.1500+1.714.491.1517 FAX Extron USA - East +800.633.9876 Inside USA/Canada Only +1.919.863.1794+1.919.863.1797 FAX Extron Europe +800.3987.6673 Inside Europe Only +31.33.453.4040+31.33.453.4050 FAX...
