Extron CS 1226T - Manual

Table of Contents:

• Page 2 – Safety Instructions • English; Instructions de sécurité • Français; Sicherheitsanweisungen • Deutsch; Instrucciones de seguridad • Español; Chinese Simplified; 注 意; Chinese Traditional; 注意; Japanese; Korean; Safety Instructions
• Page 3 – FCC Class A Notice; accessibility, and related topics, see the “; Extron Safety and Regulatory Compliance; ” on the Extron website.; Copyright; © 2013 Extron Electronics. All rights reserved.; Registered Trademarks; Trademarks
• Page 4 – Conventions Used in this Guide; Notifications; potential; Specifications Availability
• Page 5 – Contents; Introduction; Installing the CS 120P in a Suspended; CS 26T and CS 120P User Guide • Contents
• Page 7 – About this Guide; US and metric ceiling grids; CS 26T and CS 120P User Guide • Introduction
• Page 8 – Selectable taps; — The rotary tap selector switch, located behind the grille, sets the; Magnetic grille; — Magnets spaced around the grille edge enable it to be easily; Application Example; L I S; Application Diagram of a CS 1226T Installation
• Page 9 – Installation; Installation Considerations; Risk of severe bodily injury from falling or sharp equipment.; Installation Configurations; For hard ceiling installations,; CS 26T and CS 120P User Guide • Installation
• Page 10 – Installing the CS 1226T System — Single Installer; before; Grid Face Example; only
• Page 12 – Route wires through the conduit.; Using speaker wires without a conduit:; Secure the cable clamp adapter (included) to the cover plate.; Routing the Cables Without a Conduit
• Page 13 – strips; Attach Four Tape Strips to the Baffle and Port Ring Adapter
• Page 14 – Fig: Mounting the PRE; not
• Page 15 – Signal Test Points
• Page 16 – Wiring Multiple Speakers Using Loop-through:; Wiring Multiple Speakers Using Loop-through; troubleshooting in three ways:; Signal Test Points — Loop-through Configuration
• Page 17 – Impedance Test Points; Impedance Test Points — Loop-through Configuration; into the four-pole receptacle on the speaker; Connecting the Wire from the CS 120P to the Speaker
• Page 18 – using the provided zip; through the bottom of the hole in the ceiling tile that was cut in; Do not overtighten the screws.
• Page 19 – Attach secondary support lines; — If required, attach all of the secondary support; Do not; allow any slack in the support cables.; Open Back; Attaching Secondary Support Lines; — Reinstall the adjacent tile that was removed in step 4.
• Page 20 – Set the rotary tap selector switch; — Use a small screwdriver to set the tap selector; do; Adjusting the Rotary Tap Selector; Position the outer perimeter of the grille into the groove of the; Installing the Speaker Grille
• Page 21 – Installing the CS 120P in a Suspended Ceiling — Division of Labor
• Page 22 – emove the adjacent ceiling tile; Removing the Cover Plate
• Page 23 – Tighten the clamp screws.
• Page 26 – Installing the CS 26T in a Suspended Ceiling — Division of Labor; Disconnect power; Route the speaker wires
• Page 27 – Connect the wires to the captive screw
• Page 31 – — Position the outer perimeter of the grille into the groove of the
• Page 32 – Installing the CS 120P in a Hard Ceiling; Do not leave a gap between the CS 120P and the ceiling material.
• Page 33 – Contact Information; Extron Warranty; USA; xtron