Extron 15HD - Manual

IMPO

RTAN

T:

Go to www

.extron.com f

or the complete

user guide

, installation instructions,

and

specifications bef

ore connecting the

product to the po

wer sour

ce.

MTP 15HD A Series • Setup Guide

This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and audio transmission
systems.

Installation

Step 1 — Mounting

Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.

Step 2 — Transmitter Inputs

INPUT

AUDIO

MONITOR

•

Connect a computer (VGA) video source to the Input connector.

•

Connect a VGA monitor to the Monitor connector.

•

Plug a 3.5 mm stereo audio plug into the audio jack.

Step 3 — TP Cables Between Units

Pin

1

2
3
4
5
6
7
8

Wire color

White-green

Green

White-orange

Blue

White-blue
Orange
White-brown

Brown

Wire color

T568A

T568B

White-orange

Orange

White-green

Blue

White-blue
Green
White-brown

Brown

1 2 3 4 5 6 7 8

Insert Twisted

Pair Wires

Pins:

NOTE

: If you are using Enhanced Skew-Free™ AV

cable, use the TIA/EIA T568A standard only.

•

Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and
the receiver’s Input port.

NOTE:

If the unit is labeled “C7,” only CAT 7 cable should be used.

•

For daisy-chaining

, connect up to eight TP cables between a receiver’s Buffered Output port

and a daisy-chained receiver’s Input port.

Step 4 — Receiver Outputs

•

Connect a VGA monitor to the Output connector.

•

Connect a mono audio device to the Mono Audio connector. Wire the connectors as shown
below.

ATTENTION:

Connect the sleeves to ground (Gnd).

Connecting the sleeve to a negative (-) terminal will damage the audio
output circuits.

1

MONO AUDIO

2

1

MONO AUDIO

2

Unbalanced Output

Balanced Output

Do not tin the wires!

Mono output 1-

Sleeve(s)

Mono output 1+

Mono output 2+

Mono output 2-

Sleeve(s)

Mono output 1

Mono output 2

NO GROUND.

NO GROUND.

Step 5 — Receiver DIP Switches

•

H Sync and V. Sync switches —

Set these switches up for positive sync or down for negative sync.

ON

1 2 3 4 5 6

H SYNC +

V SYNC +

C SYNC

SOG

VIDEO

END UNIT

•

Composite Sync, (SOG), and Video switches —

Set these switches as shown in the table below to

output the indicated format.

Output Format

C Sync

SOG

Video

RGBHV







RGBS







RGsB







Component*







S-Video*







Composite*







NOTE:

*

Input video format must match.

•

End Unit switch

— Set this switches up if either of the following is true:

•

The receiver being configured is the only receiver connected to the transmitter.

•

The receiver being configured is the last receiver in a daisy-chained system.

OUTPUT

1

MONO AUDIO

2