Extron 150 - Manual
Extron 150 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
UTS 100 (70-1028-01)
(8) #4-40 x 3/16 inch product mounting screw
(4) #8 x 1/2 inch shelf mounting screw
UTS 150 (70-1028-02)
(8) #4-40 x 3/16 inch product mounting screw
(2) #8-32 Thumbnut
Step 1 — Mount Devices on the Shelf
ATTENTION:
Some products have hexagonal holes
in their base, which anchor stand-offs for internal circuit
boards (see the figure to the right). Using these holes will
damage the product and will not provide secure mounting.
Before securing a device to the shelf, decide where the device
will be placed. Ensure that adequate space remains for running
cables.
1.
Place the device on the shelf so that the rack mounting
holes are aligned with two diagonally opposite product
mounting holes in the shelf (see figure at right).
Remove any rubber feet attached to the device.
2.
Secure the device to the shelf, using two
of the provided #4-40 x 3/16 inch
screws.
3.
Use the rectangular (wire tie)
openings for tie wraps if
necessary.
UTS 100 Series • Setup Guide
The Extron UTS 100 and UTS 150 under-table shelf system accommodates half-rack,
quarter-rack, and eighth-rack products in a half-rack width installation. The shelves can
accommodate a single device or combinations of smaller devices.
Included Parts
Step 2 — Install the UTS 100 (Primary Shelf) Under the Table
The UTS 100 may be mounted under furniture in
one of two ways: using the keyhole slots for
a removable installation or the clearance
holes for a fixed installation.
1.
Hold the UTS 100 under
the desk or table and mark
the locations of four corner
mounting holes.
Clearance
hole
Keyhole
slot
#4-40 Thread for
Rack Mounting
Hexagonal
Stand-off (for
mounting circuit
board)
Use 2 mounting holes on diagonally
opposite corners of device.
(2) #4-40 x 3/16"
screws
UTS 100
Wire tie
openings
Product
mounting
holes
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
