EVGA 128-P2-KN01 - Manual

EVGA 128-P2-KN01

EVGA 128-P2-KN01 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
Page: / 10

Table of Contents:

  • Page 2 – Installation Guide; Turn off your computer and disconnect the power cord.; Table of contents
  • Page 3 – Using Hardware Accelerated Voice Chat
  • Page 4 – Optimized Default Settings; Setting the Lag and Latency Reduction (LLR) mode; Game Mode; Configuring the Killer Xeno
  • Page 5 – Setting Duplex Mode; Mode; Setting Link Speed
  • Page 6 – Configuring Killer Bandwidth Control; , open the Mode drop-down menu and select; Configuring Advanced Settings
  • Page 8 – Configuring Killer Firewall; a. Locate the game or application and set
  • Page 10 – Compliance Information; , or when you call for support, a staff member will register you.; Warranty Information:; For warranty information on this product, please visit:; EVGA Online Community:; To visit the EVGA community message boards, please visit:
Loading the manual

KILLER XENO

TM

PRO

Installation Guide

G a m i n g

I m a g i n g

3 D

V i d e o

E n t e r t a i n m e n t

P h o t o s

G r a p h i c s

EVGA Corp.

2900 Saturn Street, Suite B

Brea, CA 92821

www.evga.com

128-P2-KN01

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Installation Guide; Turn off your computer and disconnect the power cord.; Table of contents

2 Installation Guide 1. Remove the current network driver installed on your computer. In Windows Vista, go to Start > Control Panel > Programs > Uninstall a Program. NOTE: if using an onboard network controller, it is recommended to first disable the onboard network controller from within y...

Page 3 - Using Hardware Accelerated Voice Chat

4 2. Connect the other end of the audio cable to the input labeled “AUX” or “CD” on your motherboard (if using onboard audio) or your soundcard (if using a dedicated sound card). 3. If you do not have a four-pin audio connector available on your motherboard or sound card, follow the directions below...

Page 4 - Optimized Default Settings; Setting the Lag and Latency Reduction (LLR) mode; Game Mode; Configuring the Killer Xeno

6 Optimized Default Settings Feature Optimized Default Setting LLR Mode Game (bypasses Windows Network Stack) Link Speed Auto Link Duplex (Duplex mode) None Nagle Algorithm Control Enabled TCP No Delay Ack Frequency Enabled TCP Ack Frequency Maximum Transmission Unit 1500 bytes Killer Bandwidth Cont...

Other EVGA Models

All EVGA Other