Eureka Hex Screen House - Manual

This Installation Manual covers the assembly of portable steel pole shelters from Johnson Outdoors Gear LLC, focusing on structural setup, fabric attachment, and safety considerations for temporary outdoor structures. The document outlines key topics like proper framing techniques, securing components to prevent instability, and maintenance practices–such as UV protection and cleaning–to extend durability. It also addresses warranty coverage and ethical guidelines for responsible use in natural environments.

Loading the manual

Assembly Instructions for the Hex Screen House:

fig.6

fig.4

fig.2

fig.3

fig.1

fig.5

fig.7

www.eurekatent.com

1.800.572.8822

REV E 10.09

You can usually assemble this screen house alone. However,

with first time set-up or with windy conditions, you will

need help.

Component List:

1 Screen/Body w/ Hub 1 Tent Bag 1 Pole Bag

6 Rafters 6 Poles 1 Stake Bag and Stakes

Layout the Parts

• Unpack the tent bag, pole bag and separate all of the

components. Choose a suitable place and unroll and

unfold the fabric with the Eureka! label up.

• Assemble all of the chain-corded poles and rafters. Check

and make sure that each section is fully seated into the

next. See fig.2.

Important:

Locate the hub fitting attached to the center of

the tent roof. Align the hub arms to match the layout of the

corner pins without twisting the fabric. See fig.1.

Fit the Rafters

• Slide a rafter section labeled

"TOP" onto a hub arm.The

spring clip must engage the

slot in the hub arm. Repeat

with the remaining until all

rafters are secured in place.

See fig.3.

• Make sure the hub and

fabric are still aligned.

Raise the Frame

• Insert the corner ring & pin into the bottom section of a pole.

See fig.4. Then fit the top of the pole into the elbow of its

coresponding rafter.

• With a second pole, fit it into the diagonal opposite rafter and

pin to form and arch. Lift the arch, and working your way

around the frame, attach the remaining poles to erect a

free standing unit.

See fig. 5.

Attach the Fabric to the Frame

• Attach all of the top pole clips first. It may be necessary

to open the doors and step inside the shelter to reach

the clips. Then, attach all side clips. See fig.6.

• Stake down all corner rings and your Screen House is

ready. See fig.7.

Take down

• Zip the door closed.
• Unstake the screen house.
• Unclip the fabric from the frame.
• Remove the corner pins from the ends of the

poles and remove from the rafters.

• Remove the rafters from the hub. Collapse

the sections and store in the pole bag.

• Fold the fabric into thirds. Place the pole

bag on the fabric and together, roll them up.

• Pack all components into the storage bag.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.