Enterasys Networks DFE-256MB-UGK - Manual
Enterasys Networks DFE-256MB-UGK – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Preparation
- Page 3 – DIMM Replacement Procedure; Removing the Existing DIMM; Figure 1 Removing the Existing DIMM; Installing the DIMM
- Page 4 – Figure 2 Installing the DIMM; Completing the Installation
- Page 5 – Getting Help
PN 9033946
Page 1 of 5
DFE Series Module
Memory Upgrade Kit (DFE-256MB-UGK)
Installation Instructions
Before You Begin
These installation instructions describe how to upgrade the Dual-Inline Memory Module (DIMM)
on a DFE series module from 128 MB to 256 MB using the 256 MB SDRAM DIMM included in this
DFE-256MB-UGK
kit.
To help eliminate any potential problems during or after installation, read and understand all of
the instructions in this document and in the release notes supplied with the DFE-256MB-UGK
upgrade kit.
If there are missing or damaged parts, or you need help installing the DIMM, contact Enterasys
Networks for assistance. (Refer to “
” at the end of this document.)
Kit Parts
Required Tools
Caution:
Only authorized personnel should install the DFE Series Module Memory Upgrade Kit
(DFE-256MB-UGK).
Note:
Access to advanced routing features, such as Protocol Independent Multicasting
(PIM) and Load Share Network Address Translation (LSNAT) currently require memory
greater than 128 MB. Please consult the Release Notes to see which additional features
require this memory upgrade.
Qty
Item
1
256 MB SDRAM DIMM assembly
1
URL Location Card
1
This document (PN 9033946)
Qty
Item
1
Antistatic wrist strap (not supplied)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Preparation Page 2 of 5 PN 9033946 Preparation The DIMM is located on the main pc board assembly of the DFE Series Module. In some cases, depending on the module to be upgraded, it may be necessary to remove a daughter board to gain access to the existing DIMM. For information about the location and...
DIMM Replacement Procedure PN 9033946 Page 3 of 5 DIMM Replacement Procedure Although the following replacement procedure describes how to replace a DIMM in an angled connector, the procedure also applies to DIMM replacement in a vertical connector. Removing the Existing DIMM Refer to Figure 1 and p...
Completing the Installation Page 4 of 5 PN 9033946 3. Push the DIMM ➁ further into the connector until the two DIMM alignment notches ➄ and the tabs on the two connector arms ➀ lock the DIMM into place. Figure 2 Installing the DIMM Completing the Installation To complete the installation, proceed as...
