Page 2 - ENFORCER Mini PTZ Camera; Introduction
2 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. a Table of Contents Introduction The EV-7105-NPE is a full-featured PTZ (pan/tilt/zoom) CCTV camera which can pan a full 360 degrees in as little as a second or tilt up to 95 degrees under normal operation or as much as 180 degrees using auto-flip. ...
Page 3 - EV-7105-NPE PTZ Camera Features and Functions; ENFORCER Mini PTZ Camera Features and Functions
3 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. EV-7105-NPE PTZ Camera Features and Functions Powerful yet flexible camera: 1 / 4 -inch CCD camera with Day and Night function, up to 100X zoom (max. 10X optical zoom and 10X digital zoom), multiple focus modes, and full programmability. Powerful Pa...
Page 5 - Camera
5 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. Dimensions: Camera Wall-Mount Bracket 7” (180mm) 6” (152mm) 3 1 / 8 ” (80mm) 4 11 / 16 ” (119mm) 6 1 / 2 ” (166mm) Side Bottom Side Bottom 4 13 / 16 ” (122mm)
Page 6 - Safeguards and Precautions
6 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. Safeguards and Precautions Before Starting: 1. Please read this manual carefully and keep it for future reference. 2. Use the camera within given temperature and electrical limits. 3. Do not point the camera at the sun. Heat could damage the camera,...
Page 7 - Overview
7 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. a Wall mount bracket Camera DIP switches Lens Dome Turn counter-clockwise to remove Overview
Page 8 - Communication Protocol and Camera ID DIP Switch Setup:
8 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. Communication Protocol and Camera ID DIP Switch Setup: Before the Mini PTZ Camera is installed, first set up the DIP switches to configure the camera ID and the communications protocol. a Communication Protocol Camera ID On Value On Value 1 2 3 4 5 ...
Page 9 - Installation; Connecting Multiple PTZ Cameras; Basic Installation
9 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. a Installation 1. Connect the camera to either the included wall mount or other optional bracket. 2. Run a 24VAC power supply wire, a video cable with a male BNC connector, and a data wire through the wall to where the camera is to be mounted. 3. Co...
Page 10 - Pre-operation Checklist
10 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. a Pre-operation Checklist Before operating this PTZ camera, please note the following: Double-check that the cables are properly run between the controller and camera, and that all connections are correct. Double-check that the camera ID on the...
Page 11 - Understanding and Operating Preset and Pattern Functions
11 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. Understanding and Operating Preset and Pattern Functions Standard Pelco-compatible controllers allow the camera operator to do several functions without going through the full OSD menu, depending on the capabilities of the DVR to which the camera i...
Page 13 - Reserved Presets
13 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. <Go Preset> [95] :Enters into OSD menu <Go Preset> [131~134] :Runs Pattern Function 1~4 <Go Preset> [141~148] :Runs Swing Function 1~8 <Go Preset> [151~158] :Runs Group Function 1~8 <Go Preset> [170] :Sets Camera BLC m...
Page 14 - OSD Main Screen; OSD Display of Main Screen
14 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. OSD Main Screen The OSD main screen shows information about the current situation of the camera while it is operating. This screen is NOT seen as part of the programming process. Preset Label The label of the specific preset. Action Title Will be o...
Page 15 - Operating the OSD Menus
15 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. For operating the OSD menus, please note the following: • To access the OSD menu from your DVR, go to Preset 95. For more information on DVR presets and their functions for the ENFORCER Mini PTZ Camera, please see page 13, Reserved Presets. • Most ...
Page 17 - SPEED DOME CAMERA Menu; SYSTEM INFORMATION Menu
18 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. SPEED DOME CAMERA Menu • <SYSTEM INFORMATION>: Displays system information and configuration (see menu on page 18). • <DISPLAY SETUP>: Configures the display information shown on the OSD Main Screen as shown on page 16 (see menu on page...
Page 18 - DISPLAY SETUP Menu; SET NORTH DIRECTION Menu
19 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. DISPLAY SETUP Menu From SPEED DOME CAMERA This menu enables or disables the information shown on the OSD Main Screen (see page 14). Note that setting an item to "AUTO" means that item will be displayed only when its value changes. This menu...
Page 19 - PRIVACY ZONE Menu; EDIT MASK Menu
20 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. PRIVACY ZONE Menu From DISPLAY SETUP This menu configures an area of the camera’s field of vision so that it is covered by a gray mask, hiding it. For instance, this would be used to cover a neighbor’s window, or a sensitive window of the office. O...
Page 20 - DOME CAMERA SETUP Menu
21 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. DOME CAMERA SETUP Menu From SPEED DOME CAMERA <CAMERA SETUP> Goes to the ZOOM CAMERA SETUP menu for configuring many of the general functions of the zoom camera module. See page 22. <MOTION SETUP> Configures the general functions of the...
Page 21 - ZOOM CAMERA SETUP Menu
22 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. FOCUS MODE [AUTO / MANUAL / SEMI-AUTO] Sets the camera focus mode. "SEMI-AUTO" mode -- In this mode, the camera switches between the "manual focus mode" and "auto focus mode" depending on the current operation of the camera....
Page 23 - MOTION SETUP Menu
24 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. MOTION SETUP Menu From DOME CAMERA SETUP MOTION LOCK [ON / OFF] If ON, the user is prevented from configuring or deleting PRESET, SWING, PATTERN, or GROUP settings. However, those settings can still be used during operations. If OFF, the user is al...
Page 24 - PARKING ACTION SETUP Menu
25 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. PARKING ACTION SETUP Menu From MOTION SETUP PARK ENABLE [ON / OFF] If set to ON, the camera runs an assigned function automatically if there is no PTZ command during the configured "WAIT TIME.” WAIT TIME [1 minute to 4 hours] The time the PTZ c...
Page 25 - PRESET MENU
26 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. PRESET MENU From DOME CAMERA SETUP PRESET NO. [1~94, 96~128] If the PRESET number has already been defined, the camera immediately moves to the pre-set PRESET position and characteristics. If not, "UNDEFINED" is shown on the screen Note: If...
Page 26 - EDIT SCENE Menu; EDIT LABEL Menu
27 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. EDIT SCENE Menu From PRESET MENU This menu redefines the current PRESET scene position. 1. Use the joystick or arrow keys to move the camera to the desired position. 2. Press the "NEAR" key to save the new camera position, or press the "...
Page 28 - PATTERN SETUP Menu; EDIT PATTERN Menu
29 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. PATTERN SETUP Menu From DOME CAMERA SETUP PATTERN NO. 1 UNDEFINED CLR PATTERN CANCEL <EDIT PATTERN> PATTERN SETUP EXIT BACK Configures up to four pan/tilt patterns, with each pattern consisting of a starting position, an ending position, and ...
Page 29 - GROUP SETUP Menu
30 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. GROUP SETUP Menu From DOME CAMERA SETUP GROUP NO. 1 UNDEFINED CLEAR GROUP CANCEL <EDIT GROUP> GROUP SETUP EXIT BACK Configures up to eight groups of motions, with each group consisting of any combination of up to 20 actions, including PRESETS...
Page 30 - SYSTEM INITIALIZE Menu
31 ENFORCER Mini PTZ Camera SECO-LARM, U.S.A., INC. NO ACTION ### DW ELL OPT 1 PRESET 1 00 : 03 : 360 2 NONE 3 NONE 4 NONE 5 NONE EDIT GROUP 1 CANCEL [FAR : EDIT :END] SAVE [NEAR:EDIT ACT] 4. Configure each ACTION, ###, DWELL, and OPT. In the sample screen on the left, ACTION #1 is the command for t...
