Emerson SW375- User Manual
Emerson SW375– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure 1
- Page 3 – Figure 2; Remove the SW375 Receiver.; Figure 4
- Page 4 – to the switch housing.; Air Comfort Products; DIVISION OF EMERSON ELECTRIC CO.; WIRE CONNECTOR; Figure 6
Part No. F40BP74240000
Form No. BP7424
READ AND SAVE THESE INSTRUCTIONS
Replacement of
SW375 Receiver
With SW105 or
RCK55 Receiver
Owner's Manual
Safety Instructions
WARNING:
To avoid fire, shock, and serious personal injury, follow all instructions
carefully.
1.
Read your Owner's Manual carefully before installing the Receiver. Retain Owner's
Manual for future reference.
2.
Before servicing or cleaning the ceiling fan, switch power off at service panel and lock
service panel to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a warning device such as a
tag, to the service panel.
ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION
1.
To avoid possible electrical shock, be sure electricity is turned off at the main fuse or
circuit breaker box before wiring.
2.
Make certain no bare wires are exposed outside the wire connectors.
3.
All wiring must conform to National and Local Electrical Codes.
4.
Follow the recommended instructions for the proper method of wiring your new
Receiver. If you feel you do not have enough electrical wiring knowledge or
experience, have your Receiver installed by a licensed electrician. Any electrical work
not described in this manual should be performed by a licensed electrician.
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC
Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference
to radio and TV reception. The user is cautioned that changes and modifications made to the equipment
without the approval of manufacturer could void the user’s authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
!
WARNING
BP7424 SW375 7/7/10 3:45 PM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 General Your Owner’s Manual contains instructionsfor the replacement of your old SW375Receiver, located under the ceiling cover,with a new SW105 or RCK55 Receiver.Removal of switch(es) and the capacitor inthe switch housing, installation of areversing module in the switch housing, andwiring altera...
3 CAP THE RED WIRE FROM THE MOTOR USING A WIRE CONNECTOR D JOIN THE BLACK WIRE TO THE RED WIRE FROM THE DOWNROD USING A WIRE CONNECTOR F C CAP EACH OF THE BROWN WIRES USING WIRE CONNECTORS Figure 2 Off On Up Down Lights Fan Sleep FAN BLADES REMOVEDFOR CLARITY REMOVE WIRE CONNECTOR FROM BROWN WIRES R...
LISTED GENERAL USE ON/OFF WALL SWITCH OR OPTIONAL EMERSON SR110 WALL CONTROL CAP BROWN WIRES CAP RED WIRE FANHOUSING DOWNROD CONNECT BLACK AND RED WIRES WHITE SUPPLY WIRE RED FAN WIRE INSTALL SW105 OR RCK55 RECEIVER TO110V SUPPLY YELLOW RECEIVER WIRE ** WHITE FAN WIRE BLUE RECEIVER WIRE * BLUE FAN W...
