Emerson SST2000 - Manual - manualsarea.com

Page 2 - ELECTROCUTION HAZARD

2 DID YOU GET THE RIGHT SIZE DID YOU GET THE RIGHT SIZE DID YOU GET THE RIGHT SIZE DID YOU GET THE RIGHT SIZE DID YOU GET THE RIGHT SIZE AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER Model SST1000 Model SST1000 Model SST1000 Model SST1000 Model SST1000 is designed for heating or coolin...

Page 3 - Handle

3 A B C Dirty Air In Clean Air Out Cabinet Pre-Filters Handle ContactButton ContactButton Collecting Cells Power Pack H O H O H O H O H OW W W W W THE THE THE THE THE AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER AIR CLEANER W W W W WORKS ORKS ORKS ORKS ORKS Dirt particles flowing through the duct...

Page 4 - Figure 3; Figure 4; Figure 5

4 Air Flow FurnaceOpening Not to Exceed 20 Air Flow ElectronicAir CleanerOpening ElectronicAir Cleaner Furnace Transition Section (if Needed) Figure 3 Cabinet (Interchangeable) Collecting Cell (Interchangeable) Collecting Cell Outlet Box Power Pack Handle Contact Button Contact Button Pre-Filters (I...

Page 5 - TYPICAL MOUNTING POSITIONS; Rear View; Rear View; Air Flow; Figure 9

5 At Least9 Inches Less than7 Inches Offset Figure 10 Air Flow Figure 11 TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE(LOWBOY)...

Page 6 - Transition Fittings

6 Figure 12 Figure 13 Duct Frame Power Supply Box Mounting Holes Air Flow Turning Vanes Figure 14 Optional method (Bend tabs outward at 90˚ angle) Figure 15 REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND D...

Page 7 - WARNING; Figure 19 Installing Power Pack

7 7. With the cabinet installed, the air cleaner can now bewired to electrical input source. WARNING ! I n s t a l l a t i o n o f t h i s u n i t m u s t c o m p l y w i t h l o c a l I n s t a l l a t i o n o f t h i s u n i t m u s t c o m p l y w i t h l o c a l I n s t a l l a t i o n o f t h i...

Page 8 - CAUTION; CLEANING THE CELLS

8 OperatingLight On-Off Switch Figure 20 1. With the 120 VAC power turned on at the circuitbreaker for the furnace, push the air cleaner ON-OFFswitch to the “ON” position (Figure 20). 2. With the furnace blower running, the air cleaner will beoperating. An arcing or “snapping” sound may beheard. Thi...

Page 9 - Hook the new wire onto the support at one end.

9 REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE If an ionizing wire should break, it can be replaced asfollows: 1. Remove all pieces of broken wire. Make sure sup-ports at each end are in good condition and not ...

Page 13 - a) Place washer on rivet

13 OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION All electronic air cleaners typically produce a smallamount of ozone that is within established limits.Some customers may notice an odor especially athigh altitudes or low air flow rates. This power supply has a “hair...

Page 15 - PARTS LIST FOR ELECTRONIC AIR CLEANERS

15 1 Cabinet N/A N/A N/A N/A 2 Pre-Filter • F825-0431 • F825-0432 • F825-0337 • F825-0338 3 Collecting Cell • F811-0398 • F811-0397 • F811-0321 • F811-0319 4 Junction Box Cover F838-0072 F838-0072 F838-0072 F838-0072 5 * Screw #6 x 3/8 ------ ------ ------ ------ 6 Connector, Female F818-0053 F818-0...

Page 16 - NOTICE TO CONSUMERS; Electronic Air Cleaner; WASH REMINDER SCHEDULE

NOTICE TO CONSUMERS White-Rodgers Electronic Air Cleaner Dear Consumer; White-Rodgers would like to thank you for purchasing a White-Rodgers Electronic Air Cleaneror product containing a White-Rodgers Electronic Air Cleaner. Although White-Rodgers doesnot extend a warranty directly to consumers, Whi...

Emerson SST2000 - Manual

Table of Contents:

Summary

Other Emerson Models