Emerson KF180- User Manual

Page 2 - WARNING

WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference.2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prev...

Page 3 - Installed Wire Length; This Manual Is Designed to Make it as Easy as Possible for You to; Unpacking Instructions

3 Tools Needed for Assembly One Phillips head screwdriverOne wire stripperSix wire connectors (supplied)Three 60-watt (max.) candelabra base bulbs Materials Wiring, outlet box and box connectorsmust be of type required by the local code.The minimum wire would be a 3-conductor(2-wire with ground) of ...

Page 4 - Setting Operating; Figure 1

Preset Memory Feature Your remote control receiver is equippedwith a preset memory feature. The receiv-er will remember the light intensity and fanspeed when the light and fan are turned offfrom the wall switch. When the wall switchis turned back on, the lights and fan willresume operation as they w...

Page 5 - CEILING FAN; Remove the hanger ball by loosening; Figure 2

2. Slide the four switch levers on the code switch to your choice of ON (up) ordown positions. Use a ball-point pen orsmall screwdriver and slide the leversfirmly up or down. 3. In the receiver (Figure 1), slide the four switch levers to the same positions asset in the transmitter. Make sure theleve...

Page 6 - Figure 3; rod as shown in Figure 4.; Figure 4; Mount the fan blades to the blade; Figure 5

6 It is critical that the clevis pin in themotor coupling is properly installedand the setscrews securely tight-ened. Failure to verify that the pinand setscrews are properly installed(as shown in Figure 3) could result inthe fan falling. ! WARNING HAIRPINCLIP DOWNROD CLEVISPIN MOTOR COUPLING SETSCR...

Page 7 - Align one of the threaded holes in the; Figure 6; Figure 7

7 8. Turn the fan motor and housing assem- bly upside down in preparation formounting the fan blade assemblies.Remove and discard the three shippingretainers securing the motor hub in themotor housing. NOTE: Take care not to scratch the fanhousing when installing the bladeassemblies. 9. Insert a 1/4...

Page 8 - Carefully lift the fan and seat the hang-; How to Hang Your Ceiling Fan; Figure 9

2. Carefully lift the fan and seat the hang- er ball/downrod assembly on the hang-er bracket that was just attached to theoutlet box (Figure 11). Be sure thegroove in the ball is lined up with thetab on the hanger bracket (Figure 10). How to Hang Your Ceiling Fan The fan must be hung with at least 7...

Page 9 - Position the supply wires to the left side; How to Wire

9 1. Position the supply wires to the left side of the outlet box (Figure 12); positionthe fan wires to the right side. Partiallyinsert the remote control receiver (flatside up) until one end rests on thehanger ball as shown in Figure 12. NOTE: Make all wiring connectionsusing wire connectors (suppl...

Page 10 - Unscrew the six ring screws from the; Push the wires and connectors up into

7. Screw three 60-watt (maximum) cande- labra base flame bulbs into the lightfitter sockets (Figure 15). 8. Unscrew the six ring screws from the lower ring assembly (Figure 15).Position the lower glass in the lowerring assembly so that the six channelsin the glass align with the six arms ofthe lower...

Page 11 - Operating Your; IMPORTANT; Installation of

button is held down. When the light isat the desired brightness, release thebutton. 5. To turn the light on and off, press and release the button. The light will turnon at the light level previously set (seestep 4). 6. If airflow is desired in the opposite direction, turn the fan off and wait forthe...

Page 12 - IMPORTANT CARE INSTRUCTIONS; Accessories; INSTRUCTION TO THE USER

12 Do not use water when cleaning yourceiling fan. It could damage themotor or the blades and create thepossibility of an electrical shock. ! WARNING The use of any other control notspecifically approved for this fancould result in fire, shock and per-sonal injury. ! WARNING This product is designed...

Page 13 - Trouble Shooting; TROUBLE; Make sure; FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX

13 Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. 2. Loose power line 2. Check line power connections connections to the fan, or to fan and wire. loose wire connections inth...

Page 14 - Repair Parts

14 Repair Parts 10 16 12 3 2 1 5 4 7 6 14 21 19 23 H I OFF LOW MED 24 11 15 13 9 17 20 25 8 22 18 BP7284, Sturbrige, KF180 7/31/06 10:52 AM Page 14

Page 15 - Repair Parts Listing; HOW TO ORDER REPAIR PARTS; • PART NUMBER

Part Numbers Key Model No. Model No. Model No. No. Description KF180AP01 KF180DBK01 KF180OZ01 * Hanger Pack, Consisting of: 761655-34 761655-36 761655-35 1 Hanger Bracket — — — 2 Hanger Ball — — — 3 Downrod — — — * Parts Bag, Containing: 762659 762659 762659 4 Wire Connector (7) — — — 5 Threaded Stu...

Page 16 - LIMITED WARRANTY; A i r C o m f o r t P r o d u c t s; DIVISION OF EMERSON ELECTRIC CO.

LIMITED WARRANTY What The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against alldefects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is:As it...

Table of Contents:

Other Manuals for Emerson KF180

Summary

Other Emerson Models