Emerson KF140TZ00- User Manual
Emerson KF140TZ00– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – To avoid fire, shock, and serious personal injury, follow these; Safety Instructions; Do not put anything into the fan blades while they are turning.; Additional Safety Instructions for Installation; before wiring, and do not operate fan without blades.; This fan is suitable for use with solid-state speed controls.; WARNING; Installed Wire Length; This Manual Is Designed to Make it as Easy as Possible for You to; Unpacking Instructions; screws with lockwashers
- Page 3 – Setting Operating; Remove the hanger ball by loosening
- Page 4 – ly while pulling up on the downrod.; Make sure the grommet is properly
- Page 5 – How to Hang
- Page 6 – IMPORTANT; Installation of
- Page 7 – INSTRUCTION TO THE USER; Trouble Shooting; Make sure
- Page 8 – Repair Parts; Part Numbers; Repair Parts Listing; HOW TO ORDER REPAIR PARTS; • PART NUMBER
- Page 9 – LIMITED WARRANTY; A i r C o m f o r t P r o d u c t s; DIVISION OF EMERSON ELECTRIC CO.
Net Weight:
26.4
Lbs.
Part No. F40BP72820000
Form No. BP7282
READ AND SAVE THESE INSTRUCTIONS
CONTOURS
Ceiling Fan Owner's Manual
E m e r s o n Fa n s
D e s i g n e d b y
Model Numbers
KF140AP00
Antique Pewter with Natural
Cherr y/Mahogany Blades
KF140TZ00
Tanner y Bronze
¨
with
Teak/Mahogany Blades
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Emerson KF140TZ00
Summary
WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to pre...
2. Slide the four switch levers on the code switch to your choice of ON (up) ordown positions. Use a ball-point pen orsmall screwdriver and slide the leversfirmly up or down. 3. In the receiver (Figure 1), slide the four switch levers to the same positions asset in the transmitter. Make sure theleve...
11. Partially install two 8-32 x 12mm pan head screws (supplied) in two thread-ed holes in the adapter holder(Figure 8). 12. Connect the white wire from the light fitter to the white wire from the motor(Figure 8). Connect the black wirefrom the light fitter to the black wirefrom the motor. Make sure...
