Emerson EM-252- Manual

1. Keep your

Bluetooth Headset

and mobile phone within 3 feet of each

other during pairing.
2. Make sure the

Bluetooth Headset

is turned off.

3. Press and hold the

[POWER]

button until the RED and BLUE lights

flash alternately.

4. Set the phone to search for bluetooth devices.
5. When the phone finds the headset, confirm by selecting EM252 from the
list.

EM252

1234

EM252

EM252 added

Pairing the Headset with a Bluetooth enabled phone

2

Pairing the headset with a Bluetooth enabled phone

2

1. Connect the USB cable to the charging socket on the handset.
2. Connect the USB cable to:

●

AC Charger, and plug into a wall (A/C) outlet.

●

Computer’s USB port.

●

Car Charger.

3. The RED LED indicator light turns on.
4. The RED LED indicator light shuts off when the headset is fully charged.
(approximately 2 hours)

NOTE:

Make sure you charge your headset for two hours before using it for

the first time.

Charging the Bluetooth headset

1

Bluetooth

Headset

Owner’s

Manual

USB Cable

Car Charger

Travel Charger

IN THE BOX:

Microphone

Speaker

Ear hook

Power button

Power ON/OFF

Answer/Reject incoming calls

Dial last number

Pair

Volume down

Volume down/

microphone mute

Volume up

Volume up/

conversation switch/

microphone mute

Mini USB port

LED indicator light

Location of controls

● Check local laws regarding use of a mobile handset and wireless headset

while driving. If you use the

Bluetooth Headset

while driving, ensure your

attention and focus remains on your driving.

● Observe all signs in the designated areas where some

electronic devices

or RF radio products are required to be switched off. These could
include airplanes, hospitals, blasting areas, and potentially explosive
atmospheres.

Safety information

Driving while talking on your mobile phone is dangerous, and illegal in
many states.

Although this device enables drivers to conduct handsfree conversations,
it is still dangerous to drive and use a mobile phone at the same time.

We recommend pulling over before making or answering calls, especially
during adverse driving conditions. Please use your mobile phone, and
our product responsibly while driving!

Drive safe

FCC Part 15

This equipment has been tested and found to comply with the requirements
for a Class B digital device under Part 15 of the Federal Communications
Commission (FCC) rules. These requirements are intended to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

● Re-orient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.
consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.

FCC and telephone company information

Model EM-252

Wireless Headset

®