Page 2 - WARNING
WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to pre...
Page 3 - Tools Needed for Assembly; Installed Wire Length; Unpacking Instructions
3 This Manual is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Do not install or use fan if any part isdamaged or missing. Call Toll-Free: 1-800-654-3545 ! WARNING This product is designed to use onlythose parts supplied with this product...
Page 5 - a. Set the operating frequency of the; Mount the fan blades to the blade; Figure 1
5 Your new ceiling fan will require agrounded electrical supply line of 120 voltsAC, 60 Hz, 15 amp circuit. The outlet box must be securely anchoredand capable of withstanding a load of atleast 50 pounds. IMPORTANT: Before assembling yourceiling fan, refer to sections “SettingOperating Frequency of ...
Page 6 - Figure 2; Figure 5; Remove the wire connectors from the; Figure 6
FAN MOTOR ASSEMBLY 6 - 8 INCHES STYROFOAMPACKAGING FLAT EDGE OF LIGHT KIT PLATE ASSEMBLY STYROFOAM M4 x 10mm SERRATED HEAD SCREW (3) KEY HOLE SLOT (2) MOUNTING HOLE (1) LIGHT KIT ASSEMBLY FAN MOTOR ASSEMBLY Figure 2 To reduce the risk of personal injury, donot bend the blade flange when installingth...
Page 7 - Figure 7; Figure 9; Figure 8
10. Unscrew and remove one lockwasher and screw from each end of the upperlight plate cover on the fan motorhousing. Do not remove the screwclosest to the light holes (Figure 9). NOTE: The screw closest to the lightholes, holds the light socket to the lightplate cover. Do not remove this screw. 11. ...
Page 8 - Slide the coupler cover on the
8 CEILING COVER PIN DOWNROD HANGER BALL SETSCREW Figure 14 It is critical that the pin in the hanger ballis properly installed and the setscrewsecurely tightened. Failure to verify thatthe pin and setscrew are properlyinstalled could result in the fan falling. ! WARNING 16. Reinstall the hanger ball...
Page 9 - Securely attach the hanger bracket to; How to Hang; Carefully lift the fan and seat the; TAB
1. Securely attach the hanger bracket to the outlet box using the two screwssupplied with the outlet box (Figure 16). How to Hang Your Ceiling Fan The fan must be hung with at least 7' ofclearance from floor to blades (Figure 15). ! WARNING The outlet box and joist must be securelymounted and capabl...
Page 10 - How to Wire
OUTLET BOX BLACK SUPPLY WIRE BLACK/WHITE RECEIVER WIRE BLACK FAN WIRE BLUE FAN WIRE BLUE RECEIVER WIRE YELLOW FAN WIRE YELLOW RECEIVER WIRE CEILING COVER WHITE RECEIVER WIRE WHITE FAN WIRE WIRE CONNECTOR RECEIVER WHITE SUPPLYWIRE SUPPLY GROUNDWIRE (GREEN OR BARE) HANGER BALLGROUND WIRE(GREEN) HANGER...
Page 11 - Carefully turn the wires upward and
11 Check to see that all connections aretight, including ground, and that no barewire is visible at the wire connectors,except for the ground wire. Do notoperate fan until blades are in place.Noise and fan damage could result. ! WARNING BLUE RECEIVER WIRE YELLOW RECEIVER WIRE BLUE FAN WIRE DOWNROD B...
Page 12 - Position the glass shade over the; Final Assembly; Lift the ceiling cover up to the threaded; wired and ready for use.
5. Unscrew the finial nut, hex jamnut, and rubber lockwasher from the light kitthreaded nipple (Figure 22). Retain thelockwasher, hex jamnut and finial nutfor future installation. 6. Position the glass shade over the threaded nipple in the light kit plateassembly (Figure 23). Seat the glassshade eve...
Page 13 - Slide the four switch levers in the wall
ON 1 2 3 4 RECEIVER SWITCHLEVERS CODESWITCH SW105 RECEIVER CODESWITCH WALL CONTROL WALL CONTROLLEVERS ON 1 2 3 4 LIGHT HI HI MED MED LOW LOW FAN OFF Turning off wall switch is not sufficient.To avoid possible electrical shock, besure electricity is turned off at the mainfuse or circuit breaker box. ...
Page 14 - Operating Your
4. To turn the lights on and off, press and release the upper part of the LIGHT(U/L) button or the lower part of theLIGHT (D/L) button. The lights will turnon at the light level previously set (seeStep 3). Red light turns on when any button ispressed. If the light does not come on,replace your batte...
Page 15 - IMPORTANT CARE INSTRUCTIONS; Accessories; INSTRUCTION TO THE USER; Reorient or relocate the receiving antenna.
15 1. Downrod Extension Kits (see store or catalog). 2. Ceiling Fan Controls (see store or catalog). 3. Blades (see store or catalog). Do not use water when cleaning yourceiling fan. It could damage the motor orthe blades and create the possibility of anelectrical shock. ! WARNING The use of any oth...
Page 16 - Repair Parts
16 Repair Parts 4 24 HI MED LOW FAN OFF EMERSON D/L U/L LIGHT 29 1 7 89 6 3 2 15 16 17 28 5 21 22 25 13 14 23 18 30 10 27 26 11 12 20 19 BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 16
Page 17 - HOW TO ORDER REPAIR PARTS; Part Numbers; Lockwasher, External Tooth; Repair Parts Listing
Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REPAIR PARTS WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: The model number of your Fan will be found on a label attached to the top housing.For repair parts, phone 1-800-654-3545. • PART ...
Page 18 - Trouble Shooting; TROUBLE; Make sure; FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX
18 Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. WARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan. to...
Page 19 - LIMITED WARRANTY; authorized service center.
LIMITED WARRANTY What The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson Electric Co. ceilingfan against all defects in workmanship and materials. You must be the original purchaser or user of the productto be covered.What The Period Of Covera...
Page 20 - A i r C o m f o r t P r o d u c t s; DIVISION OF EMERSON ELECTRIC CO.
Part No. F40BP73330000 Printed in China 12/06 Form No. BP7333 A i r C o m f o r t P r o d u c t s DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant ¥ St. Louis, MO 63136 BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 20