Emerson CF240ATB00 - Manual

5 Your new ceiling fan will require agrounded electrical supply line of 120 voltsAC, 60 Hz, 15 amp circuit. The outlet box must be securely anchoredand capable of withstanding a load of atleast 50 pounds. General Your Emerson ceiling fan comes suppliedwith a Fan/Light Wall Control whichconsists of a...

4. Remove and retain one of the three pan head screw/lockwashers from themotor flange (Figure 2); loosen theother two pan head screws three orfour turns. 5. Position the light fitter adapter on the motor flange so that the two screwsmate with the two keyhole slots in thelight fitter adapter (Figure ...

8. Remove and retain the three outer screw/lockwashers from the light fitteradapter (Figure 4). 9. Position the light fitter assembly on the light fitter adapter. Line up the threeholes on the light fitter with thethreaded holes in the adapter andreinstall three screw/lockwashers(previously removed)...

8 12. Unscrew the two upper setscrews (Figure 8) until they clear the inside ofthe motor coupling. Then separate,untwist and unkink the three 80”motor leads. Route the motor leadwires through the downrod. Align theclevis pin holes in the downrod withthe holes in the motor coupling. Installthe clevis...

9 16. Place the ceiling cover over the downrod. Then reinstall the hangerball (Figure 10) on the downrod asfollows. Route the three 80” motorleads through the hanger ball andslide the hanger ball over thedownrod. Position the pin through thetwo holes in the downrod and alignthe hanger ball so the pi...

10 2. Carefully lift the fan and seat the hanger ball/downrod assembly on the hangerbracket that was just attached to theoutlet box (Figure 13). Be sure thegroove in the ball is lined up with the tabon the hanger bracket (Figure 12). Hanger bracket must seat firmlyagainst outlet box. If the outlet b...

1. Position the supply wires to the left side of the outlet box (Figure 14); positionthe fan wires to the right side. Partiallyinsert the remote control receiver (flatside up) until one end rests on thehanger ball as shown in Figure 14. NOTE: Make all wiring connectionsusing wire connectors (supplie...

12 7. Screw in three 40-watt (maximum) candelabra bulbs in the light fittersockets (Figure 17). Carefully place thelower glass over the light fitter threadednipple. Be sure the glass is firmlyseated on the fitter, then secure inplace using a rubber washer, metalwasher, and 1/8-27 nut (washers andnut...

Installation of Wall Control SINGLE-POLE INSTALLATION (Figure 19) 1. Disconnect power at circuit breaker or remove fuse. 2. Remove faceplate and screws from existing wall control. Pull control outfrom the wall box. Determine the “hot”wire and the “load” wire and disconnectthese wires from control. D...

3. Before installing wall control, place wall control in “OFF” mode by pushing“ON/OFF” switch to the “OFF” position. 4. Install a wall control in the wall box containing the “hot” wire first. Connectthe black wire of the wall control to the“hot” wire. Securely connect wires withwire connectors suppl...

9. Place the second wall control into thewall box. Screw in place and installdecorator style faceplate (included).Leave switch in “OFF” mode until faninstallation is completed. 10. Refer to page 5 and complete the ceiling fan installation . STANDARD WIRING FOR EXISTING3-WAY CONTROL 15 HOT BLK FAN/LI...

16 Do not use water when cleaning yourceiling fan. It could damage themotor or the blades and create thepossibility of an electrical shock. ! WARNING The use of any other control notspecifically approved for this fancould result in fire, shock andpersonal injury. ! WARNING This product is designed t...

17 Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. WARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan. to...

Repair Parts 1 17 18 22 29 30 20 9 8 21 12 11 10 15 14 13 26 27 19 23 28 24 25 31 HI MED LOW FAN OFF LIGHT ON OFF EMERSON 1 2 3 4 ON 2 3 5 4 16 6 7 Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REPAIR PARTS WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLL...

Part Numbers Key Model No. No. Description CF240ATB00 * Hanger Pack, Consisting of: 761655-53 1 Hanger Bracket — 2 Hanger Ball — 3 Downrod (16”) — * Parts Bag, Containing: 763046 4 Wire Connector (7) — 5 Threaded Stud, 8-32 x 1-1/4” (2) — 6 Knurled Knob (2) — 7 Lockwasher (2) — 8 Hairpin Clip — 9 Cl...

LIMITED WARRANTY What The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson Electric Co. ceilingfan against all defects in workmanship and materials. You must be the original purchaser or user of the productto be covered.What The Period Of Covera...