Emerson CF200n100 - Manual - manualsarea.com

Page 2 - Safety Instructions; Always turn off the power to the ceiling fan before servicing.; Additional Safety Instructions for Installation; wiring, and do not operate fan without blades.; WARNING

WARNING: To avoid fire, shock, and serious personal injury, follow these instruc- tions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference.2. Before servicing or cleaning unit, switch power off at service panel and lock serv- ice panel disconnecting means to ...

Page 3 - Installed Wire Length; This Manual Is Designed to Make it as Easy as Possible for You to; Unpacking Instructions

3 Tools Needed for Assembly One Phillips head screwdriverOne wire stripperOne stepladderSix wire connectors (supplied) Materials Wiring, outlet box and box connectorsmust be of type required by the local code.The minimum wire would be a 3-conductor(2-wire with ground) of the following sizes: Install...

Page 4 - BATTERY; RECEIVER; Setting Operating; Figure 1

Preset Memory Feature Your remote control receiver is equippedwith a preset memory feature. The receiv-er will remember the light intensity and fanspeed when the light and fan are turned offfrom the wall switch. When the wall switchis turned back on, the lights and fan willresume operation as they w...

Page 5 - CEILING FAN; Mount the fan blades to the blade; FAN BLADE; Figure 2

2. Slide the four switch levers on the code switch to your choice of ON (up) ordown positions. Use a ball-point pen orsmall screwdriver and slide the leversfirmly up or down. 3. In the receiver (Figure 1), slide the four switch levers to the same positions asset in the transmitter. Make sure theleve...

Page 7 - PIN; Figure 7; DOWNROD; Figure 8

12. Tighten the setscrews (Figure 8) securely while pulling up on thedownrod. NOTE: The setscrews must be properlyinstalled as described above, or fanwobble could result. 13. Make sure the grommet Is properly installed in the coupling cover, thenslide the coupling cover over thedownrod until it rest...

Page 9 - Carefully lift the fan and seat the hang-; How to Hang; FLOOR; Securely attach the hanger bracket to; TAB; You have now completed the initial

2. Carefully lift the fan and seat the hang- er ball/downrod assembly on the hang-er bracket that was just attached to theoutlet box (Figure 15). Be sure thegroove in the ball is lined up with thetab on the hanger bracket (Figure 14). How to Hang Your Ceiling Fan The fan must be hung with at least 7...

Page 10 - Position the supply wires to the left side; How to Wire

1. Position the supply wires to the left side of the outlet box (Figure 16); positionthe fan wires to the right side. Partiallyinsert the remote control receiver (flatside up) until one end rests on thehanger ball as shown in Figure 16. NOTE: Make all wiring connectionsusing wire connectors (supplie...

Page 11 - Push the wires and connectors up into

7. Screw the 75-watt (maximum) halogen bulb (supplied) into the light fitter sock-et (Figure 19). Do not touch the glassbulb; use the porcelain base to screw inthe bulb, or wear soft gloves. CAUTION: To avoid risks of burns orother injury, assure power is off beforeattempting to install or replace t...

Page 12 - IMPORTANT; Installation of; Place the lower glass into the light fitter,

Operating Your Ceiling Fan IMPORTANT Fan installation must be completed,including the installation of the fanblades, before testing of the remotecontrol. Your remote control (Figure 20) has fullcontrol of your fan and light. However, air-flow direction is controlled by a slideswitch on the switch ho...

Page 13 - IMPORTANT CARE INSTRUCTIONS; Accessories; INSTRUCTION TO THE USER; Reorient or relocate the receiving antenna.

Do not use water when cleaning yourceiling fan. It could damage themotor or the blades and create thepossibility of an electrical shock. ! WARNING The use of any other control notspecifically approved for this fancould result in fire, shock and per-sonal injury. ! WARNING This product is designed to...

Page 14 - Trouble Shooting; TROUBLE; Make sure; FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX

14 Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. 2. Loose power line 2. Check line power connections connections to the fan, or to fan and wire. loose wire connections inth...

Page 15 - Repair Parts Listing; Part Numbers; Before discarding packaging material, be certain all

Repair Parts Listing Part Numbers Key Model No. Model No. No. Description CF200NI00 CF200GES00 * Hanger Pack, Consisting of: 761655-38 761655-39 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod — — * Parts Bag, Containing: 762660-1 762660 4 Wire Connector (7) — — 5 Threaded Stud, 8-32 x 1-1/4” (2) —...

Page 16 - LIMITED WARRANTY; A i r C o m f o r t P r o d u c t s; DIVISION OF EMERSON ELECTRIC CO.

LIMITED WARRANTY What The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against alldefects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is:As it...

Emerson CF200n100 - Manual

Table of Contents:

Summary

Other Emerson Models