Emerson CF100GES00 - Manual

Page 3 - Installed Wire Length; This Manual Is Designed to Make it as Easy as Possible for You to; WARNING; four mounting screws)

Tools Needed for Assembly One Phillips head screwdriverOne wire stripperOne stepladderThree 60-watt (max.) candelabra base bulbsSix wire connectors (supplied) Materials Wiring, outlet box and box connectorsmust be of type required by the local code.The minimum wire would be a 3-conductor(2-wire with...

Page 4 - Setting Operating; Figure 1

Preset Memory Feature Your remote control receiver is equippedwith a preset memory feature. The receiv-er will remember the light intensity and fanspeed when the light and fan are turned offfrom the wall switch. When the wall switchis turned back on, the lights and fan willresume operation as they w...

Page 5 - CEILING FAN; Remove the hanger ball by loosening; Figure 2

2. Slide the four switch levers on the code switch to your choice of ON (up) ordown positions. Use a ball-point pen orsmall screwdriver and slide the leversfirmly up or down. 3. In the receiver (Figure 1), slide the four switch levers to the same positions asset in the transmitter. Make sure theleve...

Page 6 - Figure 3

5. Reinstall the hanger ball (Figure 5) on the downrod as follows. Route thethree 80” motor leads through thehanger ball and slide the hanger ballover the downrod. Position the pinthrough the two holes in the downrodand align the hanger ball so the pin iscaptured in the groove in the top of thehange...

Page 7 - Figure 6; Figure 7

11. Engage the connector of the switch housing/light fitter assembly with themotor connector (Figure 8). The twoconnectors are color-coded and mustbe mated correctly (color-to-color)before they can be engaged. Makesure the connectors close properly. 12. Partially install two 8-32 x 7mm pan head scre...

Page 8 - Carefully lift the fan and seat the hang-; How to Hang; Securely attach the hanger bracket to

2. Carefully lift the fan and seat the hang- er ball/downrod assembly on the hang-er bracket that was just attached to theoutlet box (Figure 12). Be sure thegroove in the ball is lined up with thetab on the hanger bracket (Figure 11). 8 How to Hang Your Ceiling Fan The fan must be hung with at least...

Page 9 - Position the supply wires to the left side; How to Wire

9 1. Position the supply wires to the left side of the outlet box (Figure 13); positionthe fan wires to the right side. Partiallyinsert the remote control receiver (flatside up) until one end rests on thehanger ball as shown in Figure 13. NOTE: Make all wiring connectionsusing wire connectors (suppl...

Page 10 - Place the lower glass in the lower ring; Push the wires and connectors up into

7. Screw three 60-watt (maximum) cande- labra base bulbs into the light fittersockets (Figure 16). 8. Place the lower glass in the lower ring assembly (Figure 16). Unscrew fourbracket mounting screws from the fourlower ring posts. SOCKET LOWER RING ASSEMBLY POST LOWER RING BRACKET BRACKET MOUNTING S...

Page 11 - Operating Your; IMPORTANT; Installation of

NOTE: Slightly loosen the four screwssecuring the lower ring brackets to theswitch housing assembly. 9. Securely grasp one of the lower ring posts and raise the lower ring up to oneof the lower ring brackets. Secure thelower ring post to the lower ring brack-et using a bracket mounting screw(Figure ...

Page 12 - IMPORTANT CARE INSTRUCTIONS; Accessories; INSTRUCTION TO THE USER

12 Do not use water when cleaning yourceiling fan. It could damage themotor or the blades and create thepossibility of an electrical shock. ! WARNING The use of any other control notspecifically approved for this fancould result in fire, shock and per-sonal injury. ! WARNING This product is designed...

Page 13 - Trouble Shooting; TROUBLE; Make sure; FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX

13 Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. 2. Loose power line 2. Check line power connections connections to the fan, or to fan and wire. loose wire connections inth...

Page 14 - Repair Parts

14 Repair Parts 16 17 3 2 1 5 4 7 6 14 18 19 15 23 25 24 22 21 9 8 11 10 12 13 26 FAN/OFF FOR/REV LIGHT DIMMER HI MED LOW ® 20 U.L. Model No.: CF100 BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 14

Page 15 - Repair Parts Listing; HOW TO ORDER REPAIR PARTS

Part Numbers Key Model No. Model No. Model No. No. Description CF100AP00 CF100DBK00 CF100GES00 * Hanger Pack, Consisting of: 761655-34 761655-36 761655-35 1 Bracket, Hanger Assembly (1) — — — 2 Ball, Hanger (1) — — — 3 Downrod (1) — — — * Parts Bag, Containing: 762655 762655 762655 4 Wire Connector ...

Page 16 - LIMITED WARRANTY; A i r C o m f o r t P r o d u c t s; DIVISION OF EMERSON ELECTRIC CO.

LIMITED WARRANTY What The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against alldefects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is:As it...

Emerson CF100GES00 - Manual

Table of Contents:

Summary

Other Emerson Models