Emerson Avocent Universal Management Gateway- Installation Manual

AVOCENT

®

FIBER MEDIA CONVERTER

Quick Installation Guide

1

To Contact Avocent Technical Support: Visit www.avocent.com

590-658-501A

Emerson, Emerson Network Power and the Emerson Network Power logo are trademarks or registered trademarks of Emerson Electric Co. Avocent and the Avocent logo are trademarks or registered trademarks of Avocent
Corporation or its affiliates in the U.S. and other countries. All other marks are the property of their respective owners. This document may contain confidential and/or proprietary information of Avocent Corporation, and its receipt
or possession does not convey any right to reproduce, disclose its contents, or to manufacture or sell anything that it may describe. Reproduction, disclosure, or use without specific authorization from Avocent Corporation is
strictly prohibited. ©2012 Avocent Corporation. All rights reserved.

For document downloads, visit:

www.avocent.com/manuals

The following instructions will help you
install your Avocent

®

Fiber Media Converter.

Should you require further assistance,
please contact Avocent Technical Support.

The Avocent

®

Fiber Media Converter

converts 1000BaseSX (multi-mode) or LX
(single-mode) fiber to 1000BaseT copper.
The Plug and Play Fiber Media Converter
automatically selects between a crossover
workstation and a straight-through
connection, depending on the connected
device for the twisted pair port.

The Fiber Media Converter can be
installed in an IE-PowerTray or can be
used as a standalone media converter
with a universal external switching
power cube.

1

Installing the IE-PowerTray

Mount the PowerTray into your rack
using the brackets on either side of the
PowerTray.

2

Installing a Fiber Media

Converter into the PowerTray

Make sure the Fiber Media Converter’s
data connectors are facing the front
of the PowerTray, then use the guides
to slide it into the PowerTray until it is
seated firmly in the backplane.

3

Connecting devices

Plug one end of a CAT 5 network cable
into the twisted pair port of the Fiber
Media Converter, then plug the other
end into a device. Plug the PowerTray
into a power source and turn the power
on. A green LED on the back of the
PowerTray will illuminate when the power
is turned on.

NOTE

:

In a standalone configuration, the

unit can be powered by either its power
supply or with a USB cable connected to
a computer or HMX user station. Both the
power cord and USB cable are included
with the unit.

4

LED operation

The Fiber Media Converter has two
LEDs. The FX LNK LED illuminates
green when a link is established on

the fiber port and blinks green when
data is passing. The TX LNK/ACT
LED illuminates amber when a link is
established on the copper port. It blinks
amber when activity is detected on the
copper port.

For additional information

Visit www.avocent.com for more
information on your Fiber Media
Converter.

2

3

1

End view of fiber

media converter

Fiber Media Converter

3

4