Emerson 8610E - Manual
Emerson 8610E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Gearmotors and Reducers; Installation Instructions; Do not hammer on shaft!; The preventative maintenance list below should be performed
- Page 4 – One-Piece Splined Coupling
- Page 5 – Mounting Positions; Single Reduction
- Page 7 – Standard Synthetic Gear Oil; Gear; Acceptable Mineral Oil Lubricants; Never mix synthetic oil and mineral oil.
- Page 8 – Positions of Plugs and Breathers - Reducer; Position
- Page 9 – Position of Plugs and Breathers - Gearmotors
- Page 11 – Spare Unit or Parts Orders
- Page 12 – Qty
- Page 15 – Part
- Page 16 – Pinion; Size; Maintenance Parts; Input Shaft - Solid Pinion
- Page 18 – CbN
- Page 19 – Seal
- Page 20 – TD Ball Bearing
F O R M
Installation and Maintenance Manual
For CbN Series 2000
Gearmotors and Reducers
8610E
Revised
July 2006
Emerson Industrial Automation
7120 New Buffington Road
Florence, KY 41042
Application Engineering: 800 626 2093
www.emerson-ept.com
• Periodic inspections should be performed. Failure to perform proper maintenance
can result in premature product failure and personal injury.
• Read and follow all instructions carefully.
• Disconnect and lock-out power before installation and maintenance.
Working on or near energized equipment can result in severe injury or death.
• Do not operate equipment without guards in place. Exposed equipment can
result in severe injury or death.
Browning, Emerson and Emerson Industrial Automation are trademarks of
Emerson Electric Co. or one of its affiliated companies.
©2006 Emerson Power Transmission Corps., All Rights Reserved.
MCIM11023E • Form# 8610E • Printed in USA
* US Motors is believed to be a trademark and/or trade name of Nidec Motor Corporation, and is not
owned or controlled by Emerson Power Transmission
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 CbN Series 2000 Gearmotors and Reducers Installation Instructions Start-Up Before operating the reducer or gearmotor, the following must be done: • Install the drive on a rigid and vibration-free surface. • Remove the protective coating on the shaft and flange. Use solvent if necessary. • Carefull...
4 CbN Series 2000 Gearmotors and Reducers A "O" RING 56C, 140TCMOTOR 180TC - 280TCMOTOR A C-Face Assembly One-Piece Splined Coupling Notes: 1. Install motor shaft key onto motor shaft. 2. Lubricate spline teeth of coupling and input shaft with Mobil ® Grease XTC or equivalent coupling grease...
5 CbN Series 2000 Gearmotors and Reducers Mounting Positions Foot Mount (S) Single Reduction Multiple Reduction B3 B8 B6 B7 V5 V6 B6 B7 V5 V6 B3 B8
