Ematic EVH528BL - Manual

5 Introduction to Appearance and Keypad TFT LCD S c r e e n S c r e e n - - o f f o f f l i g h t l i g h t s w i t c h s w i t c h S c r e e n S c r e e n - - o f f l i g h t o f f l i g h t Infrared light C a m e r a C a m e r a lens B u s y l i g h t B u s y l i g h t / c h a r g i n g / c h a r ...

7 U s a g e U s a g e __ _____ 1. Charge the built-in lithium battery To charge the camera, connect it to the computer. Then, the charge indicator light (red) will be on. After the camera is fully charged, the charge indicator light will be off. In general, it can be fully charged after 2-4 hours. U...

8 2. Use of Memory Card 1. Push the Micro SD card into the card slot according to the concave lettering beside the slot of memory card till it is completely inserted. 2. To take out the Micro SD card, gently press the end of the memory card inward and it will pop up. Note: No built-in memory is avai...

10 4. Conversion Between Function Modes The camera has three modes: video recording mode, photo mode and playback mode. These modes can be switched over by tapping the icon in the upper left corner of the LCD display after startup. Video recording mode Photo mode Vehicle mode Playback mode 5. Indica...

11 6. Video recording mode After turning on the DV camera, it will directly get to the video recording mode. You can start recording videos by pressing the shutter button in the preview state. To stop video recording, just press this shutter button again. When the memory card is full or the battery ...

17 Connecting the camera to a high-definition TV: Connect the camera to a high-definition TV with a HD cable (as shown below). Then video signals from the camera will be automatically output to the high-definition TV, and you can enjoy HD videos and photos that you have recorded on the high-definiti...

19 2 Use of remote control: Using the remote control will help you start video recording, shoot photos and turn off the camera without operating the camera itself. While using the remote control, place its signal transmitter port toward the infrared signal receiver light of the camera. Then you can ...

20  Remember to put the Mode Switch in your desired recording position before inserting the camera in the waterproof case. There is no external button for the Mode Switch.  After every use in salt water you will need to rinse the outside of the housing with non-salt water and dry. Not doing this c...

21 Video AVI File formats Photo JPEG Storage medium MicroSD card (Supporting up to 32GB),( without build-in flash memory) USB interface High-speed USB 2.0 interface Power Supply Built-in 3.7V rechargeable lithium Dimension (length × width × height) 74*52*33mm Weight Approx. 72g Standard packaging Ca...