Ei Electronics Ei220EN - Manual
Ei Electronics Ei220EN – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CONTENTS; Page
- Page 4 – When the CO Alarm detects abnormal levels of CO (above 50ppm CO) the; red; WHAT TO DO WHEN THE ALARM SOUNDS; Open the doors and windows to ventilate the area.
- Page 5 – number in a prominent place.; Figure 1
- Page 6 – High levels of CO in a house can be caused by:; Incorrectly or poorly installed fuel-burning appliances.; Symptoms of Carbon Monoxide Poisoning
- Page 9 – Table B: CO Alarm Response; If your CO Alarm sounds follow the instructions on page 4.; When the alarm detects over 50ppm CO the red light flashes every 2; Off
- Page 11 – WHERE TO PLACE CO ALARMS; Ideally a Carbon Monoxide Alarm should be installed in:; Unsuitable Locations; Do not place the CO Alarm in any of the following areas.
- Page 12 – If locating the CO alarm in a room with a fuel burning appliance
- Page 13 – of the partition as the potential source.; Location in room with a fuel burning appliance
- Page 15 – INSTALLING YOUR CARBON MONOXIDE ALARMS; The Ei225EN Alarm must; not; be connected when the house wiring insulation is being; WARNING; : The Alarm must be continuously powered 24 hours a day so it is
- Page 16 – INSTALLATION PROCEDURE
- Page 17 – Turn on the mains power to the CO Alarm circuit.; Recessed Wiring
- Page 18 – Insert the plug into a suitable socket.; Figure 7
- Page 19 – TESTING YOUR CO ALARM; Testing with Carbon Monoxide
- Page 20 – How to distinguish between CO Alarm and Smoke Alarm Warnings; MAINTAINING YOUR CO ALARM
- Page 22 – circuit is going to be turned on again after the CO Alarm is removed.; LIMITATIONS OF CO ALARMS
- Page 23 – : THIS CO ALARM IS DESIGNED TO PROTECT INDIVIDUALS FROM
- Page 24 – HOW TO PROTECT YOUR FAMILY
- Page 26 – TECHNICAL SPECIFICATION
- Page 28 – GETTING THE CO ALARM SERVICED
- Page 30 – The unit has been operating for up to 6 years and must be replaced.; “What to do when the alarm; If there are still problems:
- Page 32 – PRODUCT DISPOSAL; Ei Electronics
BS EN 50291: 2001
MAINS
MA
INS
POWERED
PO
WE
RE
D
Model Ei 225EN
Model Ei 220EN
- HARD WIRED TO MAINS
- WITH POWER CORD
MAINS POWERED
CARBON MONOXIDE ALARM
Read and retain carefully for as long as the product is being used. It contains vital information
on the operation and installation. The leaflet should be regarded as part of the product.
If you are just installing the unit, the leaflet must be given to the householder. The leaflet is to
be given to any subsequent user.
INSTRUCTIONS
B15584-R0-225EN&220EN-U&C 6/9/07 8:13 AM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 4 5 11 15 19 20 22 24 26 28 28 30 1 2 3 4 5 6 7 8 9 10 11 12 13 READ THIS FIRST WHAT TO DO WHEN THE CO ALARM SOUNDS CARBON MONOXIDE - THE SILENT KILLER! WHERE TO PLACE CARBON MONOXIDE ALARMS INSTALLING YOUR CARBON MONOXIDE ALARMS TESTING YOUR CARBON MONOXIDE ALARMS MAINTAINING CARBON MONOXIDE ALAR...
When the CO Alarm detects abnormal levels of CO (above 50ppm CO) the red light starts to flash and the horn will sound within 90 minutes. At higher levels of CO the alarm will turn on sooner (see table B - page 9). The CO Alarm will automatically reset once the CO has cleared. Pressing thetest/hush ...
(5) Ring your gas or other fuel supplier on their emergency number. Keep the number in a prominent place. (6) Do not re-enter the property until the alarm has stopped. (If the alarm has been silenced by pressing the test/hush button, wait at least 5 minutes so the alarm cancheck that the CO has clea...
