Page 3 - ENGLISH; SAFETY GUIDELINES; Keep the safety guideline; the mains; WARNING; • If something smells strange or smoke comes from the monitor:
ENGLISH I SAFETY GUIDELINES This monitor is designed to be safe to use. However, due to high voltage of about 400 V,fire or serious injury may occur unless you use this monitor in the proper way.Please follow the instructions shown below in order to avoid injury. Keep the safety guideline Do not use...
Page 4 - II; use a UL LISTED/CSA LABELLED or CERTIFIED power cord set; In Europe or 200V area; , a proper European standard approved power cord is to be used
ENGLISH II SAFETY GUIDELINES(continued) • Do not apply shock to the monitor.• Do not use monitor if glass is broken or damaged. If there is no picture appearance, broken glass , smoking or something smells after applyingshock to the monitor, turn off the monitor and disconnect the power plug from th...
Page 5 - III; You may receive an electric shock.; CAUTION; This is for your safety.
ENGLISH III • Do not touch the power plug with wet hands. You may receive an electric shock. • Do not obstruct a ventilation hole. If you obstruct a ventilation hole during the operation of the monitor or just after switchingoff the power, it may cause a fire or electric shock due to heating up the ...
Page 6 - IV; • Do not coil or wind the power cord.; This may cause excessive heat resulting in a fire.; INFORMATIVE EXAMPLES OF PROTECTIVE DEVICES IN SINGLE - PHASE; • Remove the power cord for complete isolation!
ENGLISH IV SAFETY GUIDELINES(continued) • Do not coil or wind the power cord. This may cause excessive heat resulting in a fire. • Caution for 200 - 240V operation only This equipment relies on the protective devices in the building installation for short - circuitand over - current protection. Refe...
Page 7 - PRECAUTIONS; • Installation environment; monochrome characters and graphic patterns, for long.; • How to clean the monitor.
ENGLISH V PRECAUTIONS • Installation environment Do not obstruct a ventilation hole.Do not put the monitor on carpet or blanket, or near a curtain which has a possibility ofobstructing a ventilation hole of the monitor. Do not put the monitor in the following places.• Hot places such as near heater,...
Page 8 - • Prevention of an obstacle to Radio receivers; VII; • Precautions for the monitor; Also confirm the screws on the connector are tightened.; • Precaution during transportation
ENGLISH VI SAFETY GUIDELINES(continued) • Prevention of an obstacle to Radio receivers This monitor has been designed pursuant to the FCC class B Rules (see page VII ). This is to prevent a problem to Radio receivers.- Keep the monitor away from Radio.- Adjust Radio antennas in order for the monitor...
Page 9 - • FCC (Federal Communications Commission) STATEMENT WARNING; - Consult the dealer or an experienced radio / TV technician for help.
ENGLISH VII • FCC (Federal Communications Commission) STATEMENT WARNING WARNING : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interfere...
Page 11 - CONTENTS; Notes about This Manual; of their respective owners.
ENGLISH 1 CONTENTS Notes about This Manual • The information in this manual is subject to change without notice.• While meticulous care has been taken in the preparation of this manual, you are requested to notify your dealer or us should you have any comments, views or questions about ourproduct. •...
Page 12 - FEATURES; If any of these accessories is missing, please contact your dealer.; STANDARD ACCESSORIES; Multimedia input support
ENGLISH 2 FEATURES ■ This product is complete with the display monitor, plus the accessories shownbelow. • If any of these accessories is missing, please contact your dealer. User manual(this book) Power cable USER MANUAL BEDIENUNGSANLEITUNG READ THE INSTR UCTIONS INSIDE CAREFULLY.KEEP THIS USER MAN...
Page 13 - Installation; Securing to a wall or pillar; CAUTIONS; INSTALLATION INSTRUCTIONS
ENGLISH 3 INSTALLATION INSTRUCTIONS ■ No stand is provided with this product. When installing the monitor, use the optional Desk-top Stand ( 651-61 or 651-62 ), Wall Mount Unit (horizontal-mount ) The Desk-top Stand has been used for the illustrations in this manual. Installation • Use one of the sp...
Page 14 - Front; Component Names
ENGLISH 4 INSTALLATION INSTRUCTIONS (continued) Front Cabinet (front frame) Main power switch Panel Indicating lamp Remote-control receiver 8 Control panel VOLUME button MENU button INPUT SELECT button SELECT button ■ Adjustment buttonsare located on thebottom. ■ The inner side of thecover is provid...
Page 15 - External device connection terminals; Rear; Video input terminals; Remote controller
ENGLISH 5 External device connection terminals Rear AUDIO IN R L/MONO AUDIO IN COMPONENT COMPOSITE S VIDEO 2 VIDEO 1 R P R /C R P B /C B Y IN IN OUT L/MONO Video input terminals RGB input terminals AUDIO IN V H B G R RGB 1 RGB 2 D-SUB IN RS232C External speaker terminals 7 7 6 Remote controller SIZE...
Page 16 - Connecting to a PC; Read SAFETY GUIDELINES ( to ) carefully to ensure maximum safety; section “Signal Input”.; Installation and Cabling
ENGLISH 6 INSTALLATION INSTRUCTIONS (continued) Connecting to a PC ■ Read SAFETY GUIDELINES ( to ) carefully to ensure maximum safety before proceeding to these steps: 1) Make sure that the display signals produced by your PC meet the specifications of this product. • For the specifications of this ...
Page 17 - Connecting to Video Equipment
ENGLISH 7 Connecting to Video Equipment (such as a Laser Disc player, a DVD player, a DSS,or a Video Camera) ■ Read SAFETY GUIDELINES ( to ) carefully to ensure maximum safety before proceeding to these steps: 1) Choose an appropriate site and install the product on a level table where the stand is ...
Page 18 - Loading Batteries; • Slide the battery cover towards the arrow mark while; • Use the remote controller within about 5 m from front of the; Handling the Remote Controller; TIPS; Do not drop or impact the remote controller.
ENGLISH 8 INSTALLATION INSTRUCTIONS (continued) Loading Batteries 1) Open the battery cover. • Slide the battery cover towards the arrow mark while pressing it. 2) Load batteries. • Load two Size AA batteries included observing the correct polarities. 3) Close the battery cover. • Slide back the bat...
Page 19 - OPERATING INSTRUCTIONS; Turning Power On and Off; Indicating lamp; To turn the monitor power ON, press the main power switch (
ENGLISH 9 OPERATING INSTRUCTIONS • When the indicating lamp blinks in green or the message“POWER SAVE” or “OUT OF FREQUENCY” appears onthe screen, there is something unusual about the status ofreception. See “Symptoms That Seemingly Appear to beFailures.” Main powerswitch Main unit Remotecontroller ...
Page 20 - Input Selection; Volume Adjustment
■ The input is switched by pressing the RGB1, RGB2, VIDEO1 or VIDEO2 buttonon the remote control. Pressing the INPUT SELECT button on the monitor mainunit switches the input in the order ofRGB1 → RGB2 → VIDEO1 → VIDEO2 → RGB1. • When the same signal is input to RGB1 and RGB2, the phase may in some c...
Page 21 - Contrast Adjustment; Size Selection
■ Each press on the SIZE button on the remote control switches the display size ofthe screen (or the display area) in the following order. The selected mode isdisplayed in the lower part of the screen. •RGB signal input •VIDEO signal input • Depending on the signal type, sometimes it may not be poss...
Page 22 - On-Screen Display System; HINTS
■ Press the MENU button to open an MAIN MENU allowing you to completevarious adjustments and settings using the SELECT buttons (The , , , and keys of the remote controller or the SELECT or VOLUME button of the main unit.). • Press the SELECT button of the main unit ( or key of the remote controller)...
Page 23 - PICTURE MENU; VIDEO; Selected characters
ENGLISH 13 PICTURE MENU MAIN MENU PICTURESOUNDDISPLAYFUNCTION PICTURE MENU CONTRAST : 127 BRIGHTNESS : 0 COLOR : 0 TINT : 0 SHARPNESS : 0 PICTURE MODE : SUPER OPTIONSRETURN PICTURE MENU CONTRAST : 127 BRIGHTNESS : 0 PICTURE MODE : SUPER OPTIONSRETURN VIDEO RGB Selected characters Setup hint CONTRAST...
Page 24 - SOUND MENU; OPTIONS MENU
ENGLISH 14 OPERATING INSTRUCTIONS (continued) SOUND MENU MAIN MENU PICTURESOUNDDISPLAYFUNCTION SOUND MENU VOLUME : 20 BALANCE : 0 TREBLE : 0 BASS : 0 MUTE LEVEL : 0 RETURN Selected characters Setup hint VOLUME Turns down the volume. Turns up the volume. Adjust for the desired sound volume. BALANCE S...
Page 25 - INTERPOLATION; Displays According to Selected DISPLAY AREA (RGB input); automatic adjustment. Apply MANUAL ADJUST to optimize them.
ENGLISH 15 Resolution Overall display Partial display Display FULL NORMAL ZOOM 640 X 480 (VGA) X Y 800 X 600 (SVGA) 1024 X 768 (XGA) SXGA X : Y = 5 : 4 Others X : Y = 4 : 3 1280 X 1024 (SXGA) 1600 X 1200 (UXGA) DISPLAY MENU (RGB) Selected characters Setup hint DISPLAY AREA NORMAL ZOOM FULL Set to FU...
Page 26 - RGB
ENGLISH 16 OPERATING INSTRUCTIONS (continued) MANUAL ADJUST MENU (RGB) Selected characters Setup hint H.POSITION Moves the horizontalposition to left. Moves the horizontalposition to right. Adjust the left-side displayposition. V.POSITION Moves down the verticalposition. Moves up the verticalpositio...
Page 27 - Using a wide-screen monitor; FULL, and the S2 image would be set to MOVIE1.; Displays by Selecting the DISPLAY SIZE (VIDEO input)
ENGLISH 17 TIPS Using a wide-screen monitor • This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software, such as a TV program, the image would appear differentfrom the original. Take this into consideration when making screen mode choices. ...
Page 28 - FUNCTION MENU
ENGLISH 18 OPERATING INSTRUCTIONS (continued) FUNCTION MENU MAIN MENU PICTURESOUNDDISPLAYFUNCTION FUNCTION MENU LANGUAGE : ENG. AUTO FREQ : ON LINE INTP. : OFF 3D COMB : ON COMPONENTVIDEO SYSTEM : AREA1 SCREEN SAVERRETURN ENGLISH FUNCTION MENU LANGUAGE : ENG. AUTO FREQ : ON MODE : PC SCREEN SAVERRET...
Page 29 - SCREEN SAVER MENU
ENGLISH 19 COMPONENT MENU(VIDEO) Selected characters Setup hint COMPONENT SD1 (480i) Set to Cb/Cr to suitthe Y/Cb/Cr signals. Set to Pb/Pr to suit theY/Pb/Pr signals. The default is Y/Cb/Cr. COMPONENT SD2 (European SDTV) COMPONENT HD1 (480p) COMPONENT HD2 (720p) The default is Y/Pb/Pr. COMPONENT HD3...
Page 30 - OTHER FEATURES; Automatic Store
ENGLISH 20 OTHER FEATURES • The previously recorded items will be lost.• The signal mode can be identified by the horizontal/vertical sync frequency and the sync signal polarity. Different signals with which all the elements are the same or similar will behandled as the same signal. • RGB1 and RGB2 ...
Page 31 - • Pressing the; Signal Check
ENGLISH 21 ■ The on-screen display system shown to the right will be displayed when theSELECT button is used to select DISPLAYand moreover DISPLAY INIT is selected fromthe On-screen Display System . If the key (select YES) of the SELECT button ispressed at this time, the user adjustment valuesin the...
Page 32 - Power Save Mode; When the RGB input is selected; Sound Mode; Press the MENU button to cancel sound mode.
ENGLISH 22 OTHERFEATURES (continued) Power Save Mode ■ When the RGB input is selected • When this unit is connected to a VESA DPMS computer, the Power Save (Off) mode can be set to be activated automatically when the computer is not being used to reduce powerconsumption by this unit. RGB sync signal...
Page 33 - TROUBLESHOOTING; Symptoms That Seemingly Appear to be Failures; • Customer servicing can be hazardous.; Symptom
ENGLISH 23 TROUBLESHOOTING ■ Make the checks suggested below depending on the symptoms observed. If thesymptoms remain uncorrected, contact your dealer. Symptoms That Seemingly Appear to be Failures • Customer servicing can be hazardous. WARNING Symptom Point to check See page • No picture with the ...
Page 35 - Actions to Correct Abnormal Displays; ABC
ENGLISH 25 ■ Depending on the kind of system equipment used, images may not be displayednormally. In this case, make the adjustments suggested below. Actions to Correct Abnormal Displays • The display image may be momentarily disturbed during clock adjustment but this is not a failure. Symptom 1 Tex...
Page 37 - PRODUCT SPECIFICATIONS
ENGLISH 27 PRODUCT SPECIFICATIONS ■ Product specifications and designs are subject to change without notice. Type P 42 Panel Displaydimensions Approx. 42 inches (922 mm (H), vertical 522 mm (V), diagonal 1059 mm) Resolution 1024 (H) x 1024 (V) pixels Inputsignals Inputterminals RGB input VIDEO input...
Page 38 - Signal Input; • When different kinds of input signals are; S-input connector pin specifications
ENGLISH 28 PRODUCT SPECIFICATIONS (continued) Signal Input Pin Input signal 1 R. video 2 G. video or sync on green 3 B. video 4 No connection 5 No connection 6 R.GND 7 G.GND 8 B.GND 9 No connection 10 GND 11 No connection 12 [SDA] 13 H. sync or H/V composite sync 14 V.sync. [V.CLK] 15 [SCL] ■ RGB te...
Page 39 - The following are recommended for use with this moniter; RGB signal input (RGB1 or RGB2 signal input); Recommended Signal List
ENGLISH 29 ■ The following are recommended for use with this moniter RGB signal input (RGB1 or RGB2 signal input) Recommended Signal List No. Signal mode Horizontal frequency (kHz) Dot clock frequency (MHz) Remarks Signal Name Resolution Vertical frequency (Hz) 1 VGA 640 X 400 70.08 31.47 25.18 2 64...
Page 41 - LEGAL INFORMATION; TWO-YEAR LIMITED WARRANTY
LEGAL INFORMATION TWO-YEAR LIMITED WARRANTY This Dukane LCD projector is warranted to the original purchaser for a period of five (2) years from the original purchase date - in normal use and service - against defects in material and workmanship. DUKANE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARR...
