Dukane 8926H-RJ - Manual

4 Contents of package Your projector should come with the items shown below. Check that all the items are included. Require of your dealer immediately if any items are missing. (1) Remote control with two AA batteries (2) Power cord (3) Computer cable(4) Adapter cover(5) Lens cover(6) User’s manuals...

5 ENGLISH Preparing for the remote control Please insert the batteries into the remote control before using it. If the remote control starts to malfunction, try to replace the batteries. If you will not use the remote control for long period, remove the batteries from the remote control and store th...

6 WARNING ►Install the projector where you can access the power outlet easily.►Install the projector in a stable horizontal position.• Do not use any mounting accessories except the accessories specified by the manufacturer. Read and keep the manuals of the accessories used. • For special installatio...

7 ENGLISH Connecting with your devices Before connecting the projector to a device, consult the manual of the device to confirm that the device is suitable for connecting with this projector and prepare the required accessories, such as a cable in accord with the signal of the device. Consult your de...

8 Connecting power supply 1. Put the connector of the power cord into the AC IN (AC inlet) of the projector. 2. Firmly plug the power cord’s plug into the outlet. In a couple of seconds after the power supply connection, the POWER indicator will light up in steady orange. Please remember that when t...

9 ENGLISH Tur ning on the power 1. Make sure that the power cord is firmly and correctly connected to the projector and the outlet. 2. Make sure that the POWER indicator is steady orange. Then remove the lens cover. 3. Press the STANDBY/ON button on the projector or the remote control. The projection...

10 Adjusting the projector’s elevator When the place to put the projector is slightly uneven to the left or right, use the elevator feet to place the projector horizontally. Using the feet can also tilt the projector in order to project at a suitable angle to the screen, elevating the front side of ...

11 ENGLISH Displaying the picture 1. Activate your signal source. Turn the signal source on, and make it send the signal to the projector. 2. Use the VOLUME + / VOLUME - buttons to adjust the volume. To have the projector silent, press the MUTE button on the remote control. 3. Press the INPUT button...

12 Tur ning off the power 1. Press the STANDBY/ON button on the projector or the remote control. The message “Power off?” will appear on the screen for about 5 seconds. 2. Press the STANDBY/ON button again while the message appears. The projector lamp will go off, and the POWER indicator will begin ...

13 ENGLISH Replacing the lamp A lamp has finite product life. Using the lamp for long periods of time could cause the pictures darker or the color tone poor. Note that each lamp has a different lifetime, and some may burst or burn out soon after you start using them. Preparation of a new lamp and ear...

14 HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE WARNING ►The projector uses a high-pressure mercury glass lamp. The lamp can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note that each lamp has a different lifetime, and some may burst or burn out ...

15 ENGLISH Please check and clean the air filter periodically. When the indicators or a message prompts you to clean the air filter, comply with it as soon as possible. The air filter has two kinds of filters inside. Replace the filters when they are damaged or too soiled. To prepare the new filters, make...

16 Using the CD manual The other manuals for this product are written into the included CD-ROM titled “User’s Manual (detailed)”. Before using the CD-ROM, please read the following to ensure the proper use. System requirements The system for using the CD-ROM requires the following. Windows ® : OS:Mi...

17 ENGLISH Item Specification Product name Liquid crystal projector Liquid Crystal Panel +5- , +5- , +5- : 786,432 pixels (1024 horizontal x 768 vertical) +:5- : 1,024,000 pixels (1280 horizontal x 800 vertical) Lamp 210 W UHP Speaker 16 W mono (8 W x 2) Power supply/Rated current AC 100-120 V: 3.4 A...

18 Troubleshooting - Warranty and after-ser vice If an abnormal operation (such as smoke, strange odor or excessive sound) should occur, stop using the projector immediately. Otherwise if a problem occurs with the projector, first refer to “Troubleshooting” of User’s Manual - Operating Guide and Netw...