Page 4 - Table of Contents; Important Operating Considerations
3 Table of Contents Introduction 4Positioning the projector 5 Connecting a computer source 6 Required computer connections 6 Optional computer connections 6 Displaying a computer source image 7 Adjusting the image 8 Using the projector with Windows 98 for the first time 9 Connecting a video device 1...
Page 5 - Introduction
4 Introduction Your new digital projector is easy to connect, use, and maintain. It is an exceptional projector for both business presentations and home entertain-ment. Dukane 28A7100HC is compatible with a wide variety of computers and video devices, including: • Most standard VCRs, DVD players (pr...
Page 6 - Positioning the projector
5 Positioning the projector To determine where to position the projector, consider the size and shape of your screen, the location of your power outlets, and the distance between the projector and the rest of your equipment. Here are some general guide-lines: • Position the projector on a flat surfa...
Page 7 - Connecting a computer source; Required computer connections; Computer In; Optional computer connections; Audio In
6 Connecting a computer source Required computer connections Connect one end of the computer cable (see page 11 for connecting video devices) to the dark blue Computer In connector on the projector. Connect the other end to the video port on your computer. If you are using a desktop computer, you wi...
Page 8 - Displaying a computer source image; Power
7 Displaying a computer source image Remove the lens cap. Toggle the Power switch on the side of the projector to the On position. The LED flashes green and the fans start to run. When the lamp comes on, the start up screen displays and the LED is steady green. It can take a minute for the image to ...
Page 9 - Adjusting the image; Keystone
8 Adjusting the image Adjust the height of the projector, if necessary, by pressing the release but-ton to extend the foot. Rotate the leveling foot located at the rear of the projector, if necessary. Avoid placing your hands in near the hot exhaust vent in front of the projec-tor. Position the proj...
Page 11 - Skip this page if you did not connect a USB mouse cable; The Wizard launches three times
10 Skip this page if you did not connect a USB mouse cable For Windows 98: • If you connected the USB cable, the Add New Hardware Wizard appears again. Drivers must be installed to use the USB functionality. • The Wizard launches three times . The first time it detects a USB Composite Device. The se...
Page 12 - Connecting a video device
11 Connecting a video device You can connect VCRs, DVD players, camcorders, digital cameras, video games, HDTV receivers, and TV tuners to the projector. There is also an audio input. You can connect the audio directly to the projector to get sound from the onboard speaker, or you can connect it to ...
Page 13 - Video connections; Input Signal
12 Video connections The next step is to figure out what type of connectors/output the equip-ment you want to connect has. If there is more than one output, select the one with the highest quality. Component video has the best quality, fol-lowed by S-video, then composite video. If you are connectin...
Page 14 - Video device connections; Composite video connection; Video In
13 Video device connections Composite video connection Plug the included video cable’s yellow connector into the video-out connec-tor on your video device. Plug the other yellow connector into the yellow Video In connector on the projector. Plug the included audio adapter ’s white connector into the...
Page 15 - Component video connection; Computer in; VGA connection
14 Component video connection If your video device has component connectors, use a Component to S-video adapter or the Component to VESA adapter (available from a third-party vendor) for HD and progressive sources. Plug the component cable into the video device. Plug the other end of the component c...
Page 16 - Displaying video
15 Displaying video Remove the lens cap. Toggle the Power switch on the side of the projector to the On position. The LED flashes green and the fans start to run. When the lamp comes on, the start-up screen is displayed and the LED is steady green. It can take a minute for the image to achieve full ...
Page 18 - Shutting down the projector; Screen Save; NOTE; Troubleshooting your setup; Table 1: LED behavior and meaning; Meaning
17 Shutting down the projector The projector automatically displays a black screen after no active source is detected for 30 minutes. This black screen helps preserve the life of the pro-jector. The image returns when an active source is detected or a remote or keypad button is pressed. Screen Save ...
Page 23 - COLOR
22 Problem Solution Result image upside down turn off ceiling in Settings>System menu correct image image reversed left to right turn off rear in Settings>System menu correct image projected colors don ’ t match source adjust color, tint, color temperature, brightness, contrast in the menus co...
Page 25 - Still need assistance?
24 Still need assistance? If you need assistance, call Dukane Customer Service directly at 1-800- 676-2485 . Or, send us an e-mail at [email protected]
Page 26 - Using the remote control
25 Using the remote control The remote uses two (2) provided AAA batteries. They are easily installed by sliding the cover off the remote’s back, aligning the + and - ends of the batteries, sliding them into place, and then replacing the cover. Caution : When replacing the batteries, be aware that u...
Page 30 - Using the menus
29 Using the menus To open the menus, press the Menu button on the keypad or remote. (The menus automatically close after 60 seconds if no buttons are pressed.) The Main menu appears. Use the arrow buttons to move up and down to high-light the desired submenu, then press the Select button. To change...
Page 34 - Settings menu
33 Settings menu Audio: allows adjustments to Volume of the internal speaker. Adjustments can also be made from the projector ’s keypad and the remote. Sources: Power-up Source determines which source the projector checks first for active video during power-up. When the Autosource feature is On, the...
Page 37 - Maintenance; Cleaning the Lens; Volume
36 Maintenance Cleaning the Lens 1 Apply a non-abrasive camera lens cleaner to a soft, dry cloth. • Avoid using an excessive amount of cleaner, and don’t apply the cleaner directly to the lens. Abrasive cleaners, solvents or other harsh chemicals might scratch the lens. 2 Lightly wipe the cleaning c...
Page 39 - Cleaning the Lamp Housing Screens; Using the security lock
38 Cleaning the Lamp Housing Screens In dirty or dusty environments, the two dust filter screens in the lamp hous-ing can become clogged, causing high temperatures and premature lamp failure. Routine maintenance to remove dust from the screens lowers the lamp operating temperature and prolongs lamp ...
Page 40 - Appendix; Specifications
39 Appendix Specifications Temperature Operating 50 to 104 ° F (10 to 40 ° C) at sea level 50 to 95 ° F (10 to 35 ° C) at 10,000 feet Non-operating -4 to 140 ° F (-20 to 60 ° C) Altitude Operating 0 to 10,000 feet (3,048 meters) Non-operating 0 to 20,000 feet (6,096 meters) Humidity Operating 10% to...
Page 41 - Projected image size; Distance to screen
40 Projected image size Table 2: Range of distance to the screen for a given screen size for the InFocus X1 Diagonal Screen Size (inches/m) Distance to screen Image Width(inches/m) Maximum distance(feet/m) Minimum Distance(feet/m) 40/1 32/0.8 5.8/1.8 4.8/1.5 50/1.3 40/1 7.8/2.4 6,5/2.0 60/1.5 48/1.2...
Page 42 - Red LED Behavior and Projector Errors; Table 3; Red LED Behavior
41 Red LED Behavior and Projector Errors If the projector is not functioning properly and the LED is blinking red, con-sult Table 3 to determine a possible cause. There are two-second pauses between the blinking cycles. Table 3: Red LED Behavior Explanation One (1) blink The lamp won't strike after ...
Page 43 - Numerics
42 Numerics 16x9 vs 4x3 screen aspect 11800x600 resolution 4 A About 34, 35 Advance menu 32altitude limits 39Aspect Ratio 34Aspect ratio 30aspect ratio 11Audio 33Audio In connector 6, 13, 26Autosource 33 B Blank button 27Blank Screen 34blinking green 17blinking red 17Brightness 30 C cable box 11 Cei...
